Boss MR100 User Manual

Page 1
MR100
10" (254mm) MARINE SUBWOOFER
USER'S MANUAL j
MR100
10" (254mm) MARINE SUBWOOFER
AUDIO SYSTEMS
3451 Lunar Court • Oxnard, CA 93030
www.bossaudio.com
tech support: www.bossaudio.com/support
Page 2

Product Specifications

Free Air Resonance Total Q Driver @ FS including all resistance's Q of the Driver @ FS including non electrical resistance only Q of the Driver @ FS including electrical resistance only The Driver's compliance expressed as an equivalent Volumn of all (cubic Ft.) The Driver's linear displacement (inches) The DC resistance of the driver's twin voice colls(ohms) Thermal Power rating of Driver (R.M.S./Peak) The Driver’s voice coil inductance(millihenries) The Driver's sensitivity (dB)
(Fs) 30 (Qts) 0.3091 (Qms) 4,7452 (Qes) 0 3307 (Vas) 1.83
(Xmas) (Re) 4 (Pe) 300W/600W (le) 2.0717 (Sens)

Calculating Enclosures

It is difficult to give exact box dimensions that are universal for all cars and trucks. It is for this reason that you must be able to calculate the space in which you have available in order to achieve the proper air volume required.
It is recommended to build your enclosure from 3/4“ thick MDF (medium density fiberboard). Make sure the enclosure is sealed air tight,

Calculating External Volume

1) To calculate box volume, measure the outside Width x Height x Depth of the enclosure. Example 12" x 14" x9" = 1512”
2) Next you must convert cubic inches into cubic feet. To do this. You must divide the cubic inch total by 1728". Example 1512 h- 1728 = .875 Cubic feet
0.3071
94

Calculating Internal Volume

1) To calculate the internal (net) volumn of the above box you must first multiply the thickness of the wood you are using by Two (2) Example; 3/4" x 2"=1.5"
2) Next Subtract 1,5 from each of the outside measurements of the box. Width 12*1.5=10.5 Height 14-1.5=12,5 Depth 9-1.5 =7.5
3) Muitipfy the new totals (H x W x D) Example : 10.5 x 12.5 x 7.5=984.375
4) Next you must convert cubic inches into cubic feet.To do this,you must divide the cubic inch total by 1728" Example 984.375-r1728 =. 5696 Cubic feet
Page 3
Woofer Installation Instruction
1. Using mounting template for woofer, mark the correct mounting loaction by a pencil or pen.
^ ^ ^
2. Cut out the panel by this marking and drill 6 holes for the mounting bolts to pass through.
3. Rotate the plastic grill counterclockwise to separate it from the woofer.
Thank you for purchasing BOSS speaker systems. Engineered in the
USA, BOSS offers innovative products that are on the cutting edge of de
sign and performance. If you have any question about the installation or operation of your BOSS speaker system which are not answered by this manual, contact your dealer in first instance.

Precautions

• Before making holes, check the mounting space with supplied template
• To prevent noise pick-up, keep the wiring of this unit away from motors, high-voltage leads and other possible noise, source.
• To prevent short-circuit, keep all wiring away from moving parts sharp edges.
• Make sure you have carefully read and understood the installation instruction.
4. Connect the terminal of the speaker to car audio correctly by using cord provided. Caution; Be carefuly not to misconnect
polarity.
5. Insert woofer in the speaker mounting hole and fix woofer with bolt & screws & nuts provided.
6. Put the plastic grill back with the woofer, rotate it clockwise.
10” Marine Subwoofer

(SOOwatts RMS Sealed Enclosure)

HIGH QUALITY POLY MICA CONE BUTYL RUBBER SURROUND
WATER-RESISTANT CONSTRUCTION 2” HIGH TEMPERATURE VOICE COIL 600 WATTS PEAK / 300 WATTS RMS
FERQUENCY RESPONSE: 30 HZ - 2.5 KHZ
SPL: 94dB(1 W/1 M)
IMPEDANCE: 4 OHMS
MOUNTING DEPTH: 4-5/8”
Page 4

Recommended Enclosures

Please Note : Our Suggested box Volumes are given as internal Air requirements.
MR100 Amplitude Response(dB/Hz)
Sealed Enclosure
Sealed Enclosure

Frequency

Frequency

Ported Enclosure

Box Volume : 1.0Cu Ft

Box Voiume : 0.4Cu Ft

Box is given as internal air volume including driver displacement
Box is given as internal air volume including driver displacement
Port Frequency Port Diameter
Port Length
51 Hz 3 Inches
5 Inches
Loading...