Bosch NDN-50022-A3, NDI-50022-A3, NDN-50051-A3, NDI-50051-A3 Quick Installation Manual

1 2 3 4 5

6 7 8 9 10

6 x 30

T10

4.5 x 40

Desiccant

Mounted

IR version

microSD card

Reset

Desiccant

Ø 6 ~ 7 mm

sealant

6 mm

Ø6 mm

4.5 x 40

7 mm

(0.3 in)

12 VDC

SELV

Class 2

24-28 AWG

RJ45

Ethernet (PoE)

Default: DHCP on

(no DHCP: 192.168.0.1)

This equipment is only to be connected to PoE networks

without routing to outside plant

8 mm

(0.3 in)

CVBS

BNC

SMB

connector

AUDIO ALARM

OUT OUT OUTGND GND GNDIN IN

24-28 AWG

NBN-MCSMB

(optional)

not included

Pan

350°

Tilt

130°

Twist 330°

T10

Do not position light sensor below edge of

cover (IR only).

180°

Default

Focus

Zoom OK

Zoom (0-6)

Focus & Zoom OK

- autofocus

>2s

<2s

Analog format

<2s

Output OK

CVBS

1 2 3 4

en en en en

FLEXIDOME IP outdoor 5000

NDN-50022-A3 | NDI-50022-A3 NDN-50051-A3 | NDI-50051-A3

Quick Installation Guide

Bosch Security Systems B.V.

Torenallee 49 5617 BA Eindhoven The Netherlands

www.boschsecurity.com

F.01U.304.149

IPHelper

Lens Wizard

Configuration >> Camera >> Installer Menu

Zoom & Focus

View & Configure

Bosch Video

Client

Video Security

Client

Configuration

Manager

Safety

Safety precautions

Caution!

1.1

Installation should only be performed by qualified service personnel in accordance with the National Electrical Code (NEC 800 CEC Section 60) or applicable local codes.

The Low Voltage power supply unit must comply with EN/UL 60950. The power supply must be a SELV-LPS unit or a SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power Source).

After connections are made ensure that the watertight compartment is tightly closed and cables and conduits are properly sealed to prevent ingress of water.

1.2 Important safety instructions

Read, follow, and retain for future reference all of the following safety instructions. Follow all warnings on the unit and in the operating instructions before operating the unit.

1. Clean only with a dry cloth. Do not use liquid cleaners or aerosol cleaners.

2. Do not install unit near any heat sources such as radiators, heaters, stoves, or other equipment (including amplifiers) that produce heat.

3. Never spill liquid of any kind on the unit.

4. Take precautions to protect the unit from power and lightning surges.

5. Adjust only those controls specified in the operating instructions.

6. Operate the unit only from the type of power source indicated on the label.

7. Unless qualified, do not attempt to service a damaged unit yourself. Refer all servicing to qualified service personnel.

8. Install in accordance with the manufacturer's instructions in accordance with applicable local codes.

9. Use only attachments/accessories specified by the manufacturer.

FCC & ICES Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- reorient or relocate the receiving antenna;

- increase the separation between the equipment and receiver;

- connect the equipment into an outlet on a circuit different from that to which the receiver is connected;

- consult the dealer or an experienced radio/TV technician for help.

Intentional or unintentional modifications, not expressly approved by the party responsible for compliance, shall not be made. Any such modifications could void the user's authority to operate the equipment. If necessary, the user should consult the dealer or an experienced radio/television technician for corrective action.

More information

For more information please contact the nearest Bosch Security Systems location or visit:

http://www.boschsecurity.com/catalog_overview.htm

Disposal - Your Bosch product was developed and manufactured with high-quality material and components that can be recycled and reused. This symbol means that electronic and electrical appliances, which have reached the end of their working life, must be collected and disposed of separately from household waste material. Separate collecting systems are usually in place for disused electronic and electrical products. Please dispose of these units at an environmentally compatible recycling facility, per European Directive 2012/19/EU.