BlueAnt T1 Quick Start Manual

T1 QUICK START GUIDE

T1 Quick Start Guide: English

1

Microphones

Indicator

Light

Vol - Vol +

Multi-

Function

Button

(MFB)

Charging

Port

Charge Your T1

2

Your T1 has been given an initial partial charge to get
started, but for best results charge it using the supplied USB
cable and adaptor until the indicator light turns white.

> Charge the T1 whenever it announces that the battery is

Very Low.

> A full charge takes about 3 hours.

> During charging, the indicator light fl ashes red.

> When the light goes white, the charge is complete.

Pair Your T1

3

1. Turn the T1 on by
sliding the power
switch on the back to
the green on position.

2. Put the T1 in your ear.

3. The fi rst time you use the T1 it will go straight to pair
mode and talk you through the pairing process.

For subsequent pairings, make sure the T1 is not
connected to any phones, then hold down the MFB. The T1
will announce that it is going into pairing mode.

Tip: The pairing code is 0000 (four zeros).

Power switch (on)

Transfer Your Phonebook

4

Once the pairing is complete, your T1 will attempt to transfer
your phonebook contacts so that it can announce the names
of incoming callers. Please accept any connection requests
from the T1 and wait for the transfer to fi nish.

Some phones do not support automatic phonebook
transfers. If the T1 announces that this is the case, you need
to go to your phone’s address book and send contacts via
Bluetooth to the T1. See www.blueantwireless.com for help.

Note: Whenever you add contacts to your phone in future

you must update your phonebook on the T1: with the T1
connected to your phone but not on a call, hold down the
MFB for 3 seconds to initiate a phonebook update.

Wearing the T1

RIGHT
EAR

LEFT
EAR

5

You can wear your T1
on either ear.

For best results:

> Position the hook and

ear gel as shown here.

> Make sure the T1 is angled

towards your mouth.

Protective Skins

Your T1 is supplied with optional rubber
skins to protect against dust and
moisture.

Making Calls

6

Use your voice to make calls:

1. Click the MFB and wait for the T1 to ask you
to Say A Command.

2. Say Phone Commands to activate the voice
dial feature on your phone (if supported by
your phone).

Or:

> Dial the number on your phone and the audio will

automatically transfer to the T1.

> Hold down Vol + for 1 second to redial the last outgoing

call.