Product Description
SUPERTOOTH LIGHT is a Bluetooth handsfree kit that supports headset or handsfree profi le phones. Its special features include Full DSP Noise Cancellation/Echo
Cancellation, thus, it provides advanced audio quality . It is designed for easy handsfree operation and superior performance.
Don’t forget: Drive safely and within the law.
Check if the national or local legislation in your country does limit the use of mobile
phones while driving. It is up to the user of this product to respect the said legislation
in the area where they lives.
Product Overview
1 Accept Button
2 End/Reject Button
3 Bluetooth Indicator
4 Charge Indicator
5 Microphone Shaft
*Press-and-release to Switch On
*Push-in to Switch Off
6 Speaker
7 Volume Down
8 Volume Up
9 Charger Port
10 Magnets
Charging
When the Charge Indicator (4) turns Red, the kits’ battery is low. Charge the unit.
1. Connect the supplied charger to an external power source.
Connect the charger’s plug to the Charger Port (9)
of the SUPERTOOTH LIGHT.
Charge Indicator (4) Status:
Steady Red: Low Battery
Steady Orange: Charging
Steady Green: Full Charge
2. When fully charged, disconnect the charger.
Power On/Off
Power On: Push in the Microphone Shaft (5) until you hear a click, and release.
The shaft will spring out from the body of the unit and fi x in place.
Power Off: Push the Microphone Shaft (5) inside the unit until it clicks.
Pairing to your Bluetooth Mobile Phone
Pair the SUPERTOOTH LIGHT to your Bluetooth mobile phone to create a “Pairing”
link, or audio connection between the two. This has to be only done once when fi rst
connecting each new phone.
1. From OFF, Press and Hold the Accept Button (1).
First Time Pairing to your Bluetooth Mobile Phone
When you turn ON your Supertooth Light for the fi rst time, it will automatically go
into Pairing mode ready to be found by devices in Bluetooth searches. This will be
the case until you have successfully paired a phone. If you have already paired a
phone, please go to the next section.
1. Power ON your Supertooth Light. The Bluetooth Indicator (3) will turn a blinking
red/blue, The kit is now in pairing mode.
2. Go to Point 3 in the next section, “Pairing to your Bluetooth Mobile phone”
Loading...