BlueAnt RIBBON User Manual

RIBBON
USER GUIDE

Read Me to Get the Most Out of
Your Device...

Welcome to the BlueAnt Ribbon: Stereo Bluetooth Streamer.

With a simple twist you can be wearing the Ribbon and ready
to go.

The Ribbon delivers the highest fi delity of sound from your
wireless bluetooth audio source to our true-to-life sound ear
buds, your own headphones or a speaker or dock with 3.5mm
audio input.

The intuitive controls make controlling your music or making
and taking calls a breeze.

You can also use your Ribbon in your car or your home with the
supplied cable.

2

Volume

Controls

Microphone

Indicator Light

Play/Pause

Charging

Port

Headphone/

Speaker

Socket

3

Charge the Ribbon

The Ribbon has been given an initial partial charge, but for best
results we recommend you fully charge it using the supplied
USB cable and adaptor.

> A full charge takes about 2 hours.
> During charging, the indicator light is solid red.
> When the light goes solid white, the charge is complete.
> The Ribbon features an iPhone battery meter so you can

check your battery status at a glance.

Pair Your Phone or Bluetooth Streaming Device

To get started you need to pair the Ribbon with your phone or
device.

1. Hold down
fl ashing to switch the Ribbon on and go straight to pairing
mode.

2. Go to your phone or device’s Bluetooth menu.

3. Select Pair or Add New Device.

4. Select the BlueAnt Ribbon.

Note: If requested, the pairing code is 0000 (four zeros).

4

for about 3 seconds until the LED starts

Streaming from Another Phone

In order to stream from another phone you will need to pair the
phone with the Ribbon.

To put the Ribbon back into pairing mode:

1. Switch the Ribbon off (hold down

2. Hold down
fl ashing.

The Ribbon will switch on and go straight to pairing mode,
Follow the instructions above to pair your phone or Bluetooth
streaming device.

Note: When powered on, the Ribbon will try to connect to the

last phone it was connected to. To swap the source phone for
streaming, you need to disconnect the currently streaming
phone, go to the Bluetooth menu on the new phone, then select
the Ribbon and connect.

This enables you to easily switch the Ribbon between phones.

for about 5 seconds, until the LED starts

for about 3 seconds).

5