Transferring your Phonebook Contacts to the Q2 14
Listening to Audio 16
ENGLISH
3
Reconnecting to the Q2 16
Using 2 Phones with the Q2 (Multipoint) 17
Which Phone is Used for Calls? 17
Multiple Calls (Call Waiting)* 18
Resetting the Q2 19
Troubleshooting 20
Alternatives to Voice Control 24
Specifi cations 26
Help and Support 26
Terms and Conditions 27
4
Introduction
Welcome to the BlueAnt Q2: the voice controlled smart
Bluetooth headset for smartphone users.
With the Q2 you can make outgoing calls
and answer incoming calls using just your voice,
and you will always know who is calling without
looking at your phone because the Q2 will
read out the caller’s name or number.
Microphones
Indicator Light
Multi-Function
Button (MFB)
Vol +
ENGLISH
Vol -
5
Charge Your Q2
Your Q2 has been given an initial partial charge to get you started, but for best results we
recommend you fully charge it using the supplied USB cable and adaptor.
> You should charge the Q2 whenever it announces that the battery is Very Low. The Q2 will
switch itself off automatically when the Q2 battery runs out.
> A full charge takes about 3-4 hours.
> During charging, the indicator light fl ashes red.
> When the light goes white, the charge is complete.
Switching the Q2 On and Off
There is a hardware power switch next to the
charging port on the back of the Q2.
Slide the switch across to turn the Q2 on or off.
6
Hardware
power switch
(off position)
Charging
port
Pair the Q2 with your Phone
To use the Q2 you need to pair it with your phone.
1. Slide the hardware power switch across to turn the Q2 on and then put the Q2 in your ear.
2. If this is the fi rst time you have used the Q2 it will go straight to pairing mode. The voice
prompts will start to talk you through the pairing process.
For subsequent pairings, click the MFB and wait for the Q2 to ask you to Say A Command.
Then say Pair Me.
3. Follow the voice prompts to pair the Q2 with your phone. The pairing code is 0000 (four
zeros).
Transfer your Phonebook
Once the pairing is complete your Q2 will attempt to transfer the contacts from your
phonebook so that it can announce the names of incoming callers.
Note: If your phone prompts you to allow a connection to the Q2, you must select “YES” or
“OK”.
ENGLISH
7
BlackBerry
If you are using a BlackBerry smartphone you may see a message
like this one.
Select “Don’t ask this again” so that a tick appears in the box, and
then choose “YES”.
Android
On Android devices a message about the phonebook transfer may
appear in the notifi cations area at the top of the screen.
In order to transfer your contacts you must swipe your fi nger over this
message and accept the phonebook transfer request from the Q2.
®
™
Accept connection request
from BlueAnt Q2?
Don’t ask this again
Phonebook Access Request
Automatic Transfer Not Supported
Some phones do not support automatic phonebook transfers. If this is
the case on your phone the Q2 will announce that it cannot transfer the
contacts automatically.
See “Manually Transferring your Phonebook Contacts to the Q2” on page 14 for help.
8
YES
NO
Notifi cation
shown on
Android
devices
Wearing Your Q2
You can wear your Q2 in either ear. For best
results:
> Rotate the ear gel as shown here.
> Make sure that the headset is angled towards
your mouth.
LEFT
EAR
RIGHT
EAR
Changing the Ear Bud
Your Q2 is supplied with a choice of ear buds in different sizes so that you can choose the one
that fi ts best. If you want to change the ear bud, remove the attached one by gently lifting it
away from the Q2.
Gently press the replacement ear bud onto the Q2 and push it fi rmly to secure it in place.
Stabilizing Ear Buds
The optional stabilizing ear buds allow you to wear the Q2 with or without
an ear hook. Your Q2 is supplied with a choice of sizes.
ENGLISH
9
Loading...
+ 19 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.