ENDURE
USER GUIDE
Read Me to Get the Most Out of
Your Device...
Endure Quick Start Guide: English
1
Command
Indicator
Light
Microphones
Vol - Vol +
Button
Model: T2
Charge Your Headset
2
Your headset has been given an initial partial charge to get started,
but for best results charge it using the supplied USB cable and
adaptor until the indicator light turns white.
> Charge the Endure whenever it announces the battery is Very Low.
> Your headset features Rapid Charge technology. It will charge to
50% capacity in just 30 minutes. A full charge takes about 2 hours.
> During charging, the indicator light fl ashes red.
> When the light goes white, the charge is complete.
> The Endure features an iPhone headset battery meter so you can
check your battery status at a glance.
USB Connector
(lift cover to access)
Power
Switch
Wearing the Endure
3
You can wear your
headset on either ear.
For best results:
> Position the hook
and ear gel as
shown here.
> Make sure the
headset is angled
towards your mouth.
Pair Your Headset
4
1. Slide the power switch across to turn the Endure on.
2. Put the Endure in your ear.
3. The fi rst time you use the Endure it will go straight to pair mode
and talk you through the pairing process.
For subsequent pairings, make sure the Endure is not connected to
any phones, then hold down the Command button. The Endure will
announce it is going into pairing mode.
Tip: The pairing code is 0000 (four zeros).
LEFT
EAR
RIGHT
EAR
Pairing mode will time out after 2 minutes. To go back into pairing
mode, press and hold the Command button. To cancel pairing mode,
turn the Endure off and back on again.
Transfer Your Phonebook
5
Once the pairing is complete, your headset will attempt to transfer
your phonebook contacts so that it can announce the names of
incoming callers. Please accept any connection requests on your
phone from the Endure and wait for the transfer to fi nish.
Some phones do not support automatic phonebook transfers. If
the Endure announces that this is the case, you need to go to your
phone’s address book and send contacts via Bluetooth to the Endure.
See “Phonebook Troubleshooting” or www.blueantwireless.com
for help.
Note: Whenever you add contacts to your phone in future you must
update your phonebook on the Endure: with the headset connected
to your phone but not on a call, hold down the Command button for 3
seconds to initiate a phonebook update.
6
Making Calls
Voice Dialing
To use this feature your phone must support voice dialing over
Loading...