Blu Bathworks SA0600 User Manual

blu·stone™ integrated basins

®

Installation Guide

SA0600

SA0700

SA0900
SA0910

SA1400
SA1410

SA1401
SA1411

SA1402
SA1412

SA1200
SA1210

SA1800
SA1810

2014-01

1 866 907 0122 blubathworks.com

®

Attention — Before Installation

- We recommend that the installation be done by a minimum of 2 people as a security precaution. Also make sure
to adopt the proper posture when lifting the basin.

- Adhere to all local building and plumbing codes. The diagrams in this guide are not construction plans. They are
visual aids.

- For best results, the floor must be level and the wall must be square with the floor.

Installation Requirements

Please read the instructions carefully so as to avoid any damage to the fixture.

1. To ensure this product is installed properly, you must read and follow these guidelines.

2. The owner/user of the product must keep this information for future reference.

3. Consult local building codes to make sure the installation complies with standards.

4. Remove the unit from its packaging. Before disposing of it, inspect the unit to make sure its in good shape. Should
inspection reveal any damage or defect in the finish, contact your distributor. The warranty does not cover damages
or defects in the finish once it has been installed. Blu Bathworks’ responsibility for shipping damages ceases upon
delivery of the product in good order to the carrier. All complaints regarding damage due to transport must be made
directly to the carrier.

5. Place the unit in the bathroom before you start working. Conserve all nuts and bolts.

6. To protect the unit during installation, we recommend that you lay a piece of cardboard on the bottom.

7. If the unit is covered with polyethylene protective film, do not remove until installation is complete to grant maximum
protection. However, remove film where any two surfaces will be in permanent contact.

8. Verify that all dimensions on the plan are the same as the ones of the unit.

Installation Notes

Important! Install this product according to the installation guide. Product does have an overflow. Spout must provide a
minimum of 5” reach for adequate clearance into basin. Our products must be installed by certified professionals only
and according to our installation guide as well as federal, provincial / state and local building codes and regulations.

Technical Support Assistance

If further assistance is required, please contact:

Product Support at 1.866.907.0122 (09:00 – 17:00hrs PST) or email [e-mail]

North America

Blu Bathworks Inc.

188 Smithe Street,Vancouver, BC, Canada, V6b 6A9

T +1.604.299.0122 F +1.604.299.0125

2014-01

1 866 907 0122 blubathworks.com

1