Blaupunkt MPS 1402C MB, MPW 1801 MB Installation Instructions

M-BENZ PLUG & PLAY UPGRADE
MPS 1402C MB MPW 1801 MB
Enjoy it.
Operating and installation instructions
INTRODUCTION
Safety notes
Ensure to follow below safety notes during installation and wiring connection: -
Disconnect the negative terminal of the battery. Refer to the safety notes of vehicle manufacturer.
Ensure positions of the holes are nowhere near the vehicle component to avoid any damage during drilling.
Ensure cross section of the cable is no less than 2.5mm2 if the positive and negative cables are too long.
Incorrect installation may result in malfunc­tion of the device or the car sound system. Installation and Connection Instructions
Select a dry and well-ventilated location to install the device.
The device must not be installed in overly exposed location such on the rear shelf, rear seat etc.
The installation location must be suitable for screw holes and have stable ground support. Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages, to property or life, improper storage, whatsoever arising out of or connected with the use or misuse of our products.
USA & CANADA : Products not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased as-is. No warranty, express or implied is provided in the U.S. and Canada.
Voltage Supply
Use the supplied power extension cable to connect to the positive battery terminal.
Firmly and carefully connect the ground lead to a bare metal point on the vehicle chassis.
The control of the device should be a two-channel control, either via the preampli­er output of the car sound system.
A control solely via the right or left channel is also possible since the low-frequency portion of the music is generally identical on both channels.
Integrated Fuse
The integrated fuse in the device protects the output voltage and the entire electrical system in case of malfunction. Do not replace damaged fuse with higher current.
Switching On/O
This device will automatically turn on if a music signal is detected. The device will also automati­cally turn o if no music signal is received.
Recycling and Disposal
Please dispose responsibly. Subject to change.
1
SPECIFICATION
MPW 1801 MB
Pair of M-Benz plug & play 2-way subwoofer to upgrade OE speaker installed for selected M-Benz models with berglass sandwiched including mounting hardware
Max. output power : 120W
Normal output power (RMS) : 50W
Impedance : 2 ohms
Frequency response : 55Hz - 2,000Hz
Sensitivity : 86dB
Mounting depth : 58mm
Diameter hole : 165mm
259.3mm
223.2mm
254.1mm
286.5mm
MPW 1801 MB INSTALLATION
Connector with intergrated crossover
Input
WF
WF
101.5mm
57.4mm
MPW 1801 MB (L)
104.6mm
57.4mm
MPW 1801 MB (R)
MPS 1402C MB
Pair of M-Benz plug & play 2-way component speaker to upgrade OE speaker installed for selected M-Benz models with berglass including mounting hardware
Max. output power : 30W
Normal output powe (RMS) : 15W
Impedance : 3.6 ohms
Frequency response : 90Hz – 10kHz
Sensitivity : 89dB
Mounting depth : 37mm
Diameter hole : 165mm
MPS 1402 MB (Tweeter)
MPS 1402 MB (MidRange)
2 3
Connect the long wire “WF”
Subwoofer L
Connect the short wire “WF”
Subwoofer R
MPS 1402C MB INSTALLATION COMPATIBILITY LIST
The plug that connects the Midrange and Tweeter output signals
Connector with integrated crossover
Input
Tweeter
Midrange
MPW 1801 MB and MPS 1402C MB can be installed in the following list of car models :
Class
Model
C
GLC
E
S
ront/rear door
W205/ Sedan
S205/ Estate
C205/ Coupe
A205/ Convertible
X253/ SUV
C253/ SUV Coupe
W213/ Sedan
S213/ Estate
C238/ Coupe
A238/ Covertible
W222/ Limousine/ Sedan
Mounting Position
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
Front/rear door
4 5
Designed and engineered by Blaupunkt Competence Center
MPW 1801 MB
1 112 19 005 02 01
MPS 1402C MB
1 111 19 017 02 01
Loading...