In Car Video
IVSC-5501
Operating and installation instructions
http://www.blaupunkt.com
General .................................. 12
Accessories............................ 12
Installation and
safety notices ......................... 12
Supplied equipment .............. 13
Installation.............................. 13
Connection diagram .............. 17
Features ................................. 19
Specifications ........................ 19
CONTENTS
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
11
ESPAÑOL
PORTUGUÊS
DANSK
SAFETY INFORMATION
General
Thank you for deciding to use a Blaupunkt product. We hope you enjoy using this new piece of equipment.
Please read these operating instructions before using the equipment for
the first time.
The Blaupunkt editors are constantly
working on making the operating instructions clearer and easier to understand. However, if you still have any
questions on how to operate the equipment, please contact your dealer or the
telephone hotline for your country . You
will find the telephone numbers printed
at the back of this booklet.
We provide a manufacturer guarantee
for our products bought within the European Union. You can view the guarantee conditions at www.blaupunkt.de
or ask for them directly at:
Blaupunkt GmbH
Hotline CM/PSS 6
Robert Bosch Str. 200
D-31 139 Hildesheim
Installation and safety notices
Before connecting your signal converter, please read the following information carefully .
The battery’s negative terminal must
remain disconnected whilst you are
installing and connecting the unit.
Whilst doing so, you must observe the
vehicle manufacturer’s safety notices
(airbags, alarm systems, trip computers,
immobilizers).
Before drilling any holes, you must make
sure that no installed cables or vehicle
components can be damaged.
When installing the signal converter, select a location in the vehicle that allows
you to attach it firmly into place using
screws. The installation location should
be such that the signal converter does
not get in the way of the driver and cannot endanger the occupants in the event
of the vehicle suddenly coming to a halt,
for instance, during an emergency stop.
Accessories
We recommend you use accessories
that have been approved by Blaupunkt.
12
SUPPLIED EQUIPMENT INSTALLATION
Supplied equipment
The signal converter is supplied with all
the parts listed below. Please check that
the range of parts supplied with your device is complete. If one of the listed parts
is missing, please contact your dealer
immediately.
● Signal Converter
● Connecting cable
● RGB adapter
● Installation and operating instruc-
tions
Signal Converter
7 607 003 550
Connecting cable
RGB adapter
Installation
Note:
• Before connecting the monitors to
your signal converter, check that
the +/- and the switched positive
are connected properly . After connecting the +/- and the switched
positive, the red LED on the signal converter must light up!
Positive connection
Connect the fuse holder (5A fuse) to protect the positive cable (3) (see Fig. 1).
The fuse holder must be connected to
the positive terminal at a distance of
max. 30 cm from the vehicle battery (if
necessary, drill a hole in the bulkhead
use the appropriate cable grommets).
Switched positive
Connect the switched positive cable (4)
(see Fig. 1) to the switched positive output (
) of the main system unit (e.g.
car radio or navigation unit). If connecting to the vehicle’s terminal 15, you must
connect a fuse holder (1A fuse) to protect the switched positive cable (4) (see
Fig. 1). The fuse holder must be connected to the positive terminal at a distance of max. 30 cm from the vehicle
battery (if necessary, drill a hole in the
bulkhead and use the appropriate cable grommets).
Negative (earth) connection
Attach the negative cable (1) (see Fig. 1)
directly to the vehicle body using a screw.
Scratch the surface down to the bare
metal at the point at which the earth contact is made and apply graphite grease
(important for a good earth connection).
13
DEUTSCH
ENGLISH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
DANSK