Black & Decker BDCMTS-XE Original Instructions Manual

Australia

New Zealand

www.blackanddecker.com.au

QUICK CONNECT SYSTEM

BDCMTS-XE

SANDER

ATTAChMENT

2

PARTS AND FEATURES

Additional accessories are available at extra cost
from your local Black & Decker dealer.

1. Sander attachment

2. Sanding base

3. Sanding base tip

4. Sanding sheet

2

1

3

4

3

ENGLISH

(Original instructions)

WARNING: Read all safety warnings and all instructions. Failure to follow the

warnings and instructions may result in electric shock, re and/or serious injury.

Intended use

Safety instructions

General power tool safety warnings

@

Read all safety warnings

and all instructions provide with your

power unit (BDCDMT108-XE,

before using this accessory.

BDCDMT180-XE)

:

To reduce the risk of injury, the user

must read the instruction manual.

General power tool safety warnings

@

WARNING! Read all safety warnings and all

Failure to follow the warnings and

instructions listed below may result in electric

instructions.

WARNING!

WARNING!

Your Black & Decker multi-purpose tool has been

designed for a wide range of DIY applications.

This tool is intended for consumer use only.

Using the sander head, this tool is intended for

sanding wood, metal, plastics and painted surfaces.

SPECIFIC SAFETY RULES

WARNING:

ALWAYS use safety glasses. Everyday eye glasses are NOT safety

glasses. Also use Face or dust mas sanding operation is dust . ALWAYS WEAR

CERTIFIED SAFETY EQUIPMENT:

•

ANSI Z87.1 eye protection (CAN/CPA Z94.3),

•

ANSI S12.6 (S3.19) hearing protection,

•

NOSH/OSHA respiratory protection.

• Sanding of lead-based paint is not recommended. See Sanding Lead Based Paint for

additional information before sanding paint.

• Clean your tool out periodically.

SYMBOLS

The label on your tool may include the following symbols. The symbols and their definitions are as follows:

V ..................volts A ...................amperes

Hz ................hertz W ..................watts

min ..............minutes

................alternating current

.............direct current

n

o .................no load speed

................Class I Construction ..................earthing terminal

(grounded)

................safety alert symbol

................Class II Construction .../min or rpm...revolutions or

(double insulated) reciprocation per minute

............

Read instruction manual before use

..................Use proper respiratory protection

................Use proper eye protection ..................Use proper hearing protection

y

k

if