Black+Decker BDCINF18 Original Instructions Manual
www.blackanddecker.com.au
www.blackanddecker.co.nz
36
5
7
10
11
13
2
9
8
16
15
1
12
4
17
18
14
BDCINF18
16 17 18 19
21 20
7
A B
22
15
C
1
12
D
2
E
2
F
ENGLISH
(Original instructions)
23117
u Retain this manual for future
reference.
u This appliance is only to be used with
the battery packs listed in the manual
as cordless power.
u If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualied
persons in order to avoid a hazard.
G
Intended use
Your BLACK+DECKER BDCINF18 Ination station has been
designed to be used cordless or in most vehicles from the
standard 12 Volt socket to inate car and bike tires, balls,
rafts, air mattresses, swimming pool oats, etc. This appliances is intended for This tool is intended for consumer use only.
Read all of this manual carefully
before operating the appliance.
Safety instructions
Warning! Read all safety
@
warnings and all instructions
Failure to follow the warnings
and instructions listed below may
result in electric shock, re and/or
serious injury.
u The intended use is described in this
manual. The use of any accessory
or attachment or the performance
of any operation with this appliance
other than those recommended in this
instruction manual may present a risk
of personal injury.
.
Using your appliance
u Do not use the appliance to pick up
liquids or any materials that could
catch re.
u Do not immerse the appliance in water.
u Never pull the charger lead to
disconnect the charger from the
socket. Keep the charger lead away
from heat, oil and sharp edges.
Safety of others
u This tool is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience
and knowledge, unless they have
been given supervision or instruction
concerning use of the tool by a person
responsible for their safety.
u Children should be supervised to
ensure that they do not play with the
appliance.
Inspection and repairs
Before use, check the appliance for damaged or defective parts.
3
ENGLISH
(Original instructions)
Check for breakage of parts, damage to
switches and any other conditions that
may affect its operation.
u Do not use the appliance if any part is
damaged or defective.
u Have any damaged or defective parts
repaired or replaced by an authorized
repair agent.
u Regularly check the charger lead for
damage. Replace the charger if the
lead is damaged or defective.
u Never attempt to remove or replace
any parts other than those specied in
this manual.
Additional safety instructions
u Inate bike tires, balls, rafts, swimming
pool oats, air mattresses, and more in
and around the home. Recommended
maximum continuous duty at 65 psi is
2 minutes on with 5 minutes off.
u The compressed air from your inator
is not safe for breathing. Never
inhale air from your inator or from
a breathing device connected to the
inator.
u Too much air pressure causes a
hazardous risk of bursting.
Check the manufacturer’s maximum
pressure rating for objects being
inated.
u Do not leave inator running
unattended. It could burst tires or other
items.
u Use a tire gauge to check the tyres
pressure before each use and while
inating tyres; see the tyre sidewall for
the correct tyre pressure.
4
u Do not modify or attempt to repair.
Never drill into, weld, or make any
modications to the inator or its
attachments.
u Operate only with the accessories in-
cluded or air handling parts acceptable
for not less than 160 psi.
u The use of any
accessory not recom-
mended for use with this tool could
be hazardous.
u Never “horseplay.” High pressure air
is dangerous. Don’t direct air-ow at
yourself or others.
Warning! Always leave the valve adaptor
lever open when not in use.
u Inator can become hot during use.
Allow inator to cool 30 minutes before
storing away.
After use
u Unplug the charger before cleaning.
u When not in use, the appliance should
be stored in a dry place.
u Children should not have access to
stored appliances.
Residual risks
Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc.
Even with the application of the relevant
safety regulations and the implementation of safety devices, certain residual
risks can not be avoided. These include:
u Injuries caused by touching any
rotating/moving parts.
Loading...