Bello PVS-4218 Owners manual

PVS-4218 Flat Panel Television Stand

ASSEMBLY INSTRUCTIONS

PATENT PENDING

ART #

P

Parts List

QTY.

FOR YOUR SAFETY, PLEASE FOLLOW THESE PRECAUTIONS:

! ALWAYS REMOVE THE TV AND OTHER EQUIPMENT FROM THE FURNITURE PRIOR TO MOVING THE ASSEMBLED UNIT.

! BE CAREFUL

AND/OR WHEN THERE IS EQUIPMENT LOCATED ON THE FURNITURE AS THIS MAY CAUSE THE SHELVES TO
BECOME UNSECURED AND FALL.

! WHEN IN USE,

! DO NOT LEAN ON THE TV WHEN IT IS ON THE TV STAND.

! DO NOT

! DO NOT

! DO NOT PLACE ITEMS ON THE SHELVES WHICH EXCEED THE MAXIMUM WEIGHT LIMITS OF 125 LBS. FOR TOP SHELF

AND 50 LBS. FOR EACH LOWER SHELF

WHEN MOVING THE ASSEMBLED FURNITURE AFTER THE GLASS SHELVES HAVE BEEN INSTALLED,

T, SOLID AND LEVEL SURFACE.

FLA

THIS FURNITURE MUST

CLIMB OR STEP ON THE STAND.

BANG OR PLACE YOUR OWN WEIGHT ON THE GLASS SHELF.

BE PLACED ON

A

Assembly Instructions

NOTE: TWO PEOPLE ARE RECOMMENDED TO ASSEMBLE THIS TABLE.

A. PLACE the CMS®(Cable Management System)

(1) on a soft flat surface with the shelf posts
facing upwards as shown in Fig 1. NOTE: The

two holes located on one side of the CMS

®

frame must be positioned at the TOP of the
stand when fully assembled and in use.

B. INSERT the open ends of the top (least deep)

shelf frame (2) onto the shelf posts and
SECURE with two of the shorter (M6x15) bolts
(8) as shown in Fig. 1.

REPEAT this step for
the middle (medium depth) shelf frame (3) and
for the bottom (deepest) shelf frame (4). FULLY
TIGHTEN ALL BOLTS.

C.

APPLY two glass pads (10) to the front of each
lower shelf frame as shown in Fig. 2. Apply

three pads to the top shelf support as shown.

CAREFULLY MOVE the table near the place it

D.

will occupy in the room when fully assembled
and in use.

CAREFULLY POSITION the bottom (deepest)

E.

glass shelf (7) onto the bottom shelf frame so
that the two silver discs are sitting inside the
holes at the rear of the shelf frame and
SECURE the silver discs from below the frame
with two longer (M6x25) bolts (9) as shown in
Fig. 2. DO NOT OVERTIGHTEN.

Fig. 1

Fig. 2

CAREFULLYstand the table upright. CARE

F.

FULLY POSITION

the middle (medium depth)

-

glass shelf (6) onto to the center shelf frame so
that the two silver discs are sitting inside the
holes at the rear of the middle shelf frame (3)
and

SECURE the silver discs from below the

frame with two longer (M6x25) bolts (9). DO

TIGHTEN.

OVER

NOT

G.

CAREFULLY POSITION the top (least deep)
glass shelf (5) onto to the top of the CMS®so
that the two silver discs are sitting inside the
holes at the top of the CMS
silver discs from below the CMS

®

and SECURE the

®

with two
shorter (M6x15) bolts (8). DO NOT OVER­TIGHTEN.

IMPORTANT: REMOVE THE TV AND OTHER
EQUIPMENT FROM

THE FURNITURE PRIOR
TO MOVING THE ASSEMBLED UNIT. ALWAYS
PLACE THE HEAVIEST EQUIPMENT ON THE
BOTTOM SHELF.

Fig. 3

Warranty

One (1) Year Limited Warranty

All Bell’O International products are warranted, with the exception of glass, to the original purchaser at the time of
purchase and for a period of one (1) year thereafter. Glass is warranted to the original purchaser at the time of
purchase and for a period of thirty (30) days thereafter. Warranty is only valid in the United States of America.

In order to provide you with timely assistance, please thoroughly inspect your furniture for missing or defective parts
immediately after opening the carton. To receive replacement or missing part(s) under this warranty, go to our
website at www.bello.com or call our Customer Service Department at 1-888-235-7646. Please have the model
number and part number(s) for reference. You will also need your sales receipt or other proof of purchase.
Replacement part(s) will be shipped to you at no charge with Bell’O International assuming all shipping and handling
expense.

We warrant to you, the original purchaser, that our furniture and all of its parts and components are free of defects in
material or workmanship. "Defects", as used in this warranty, is defined as any imperfections that impair the use of
the furniture or product.

Our warranty is expressly limited to the replacement of furniture parts and components. For one (1) year after the
date of purchase, Bell’O International will replace any part described on the enclosed furniture parts list that is
defective in material or workmanship.

This warranty applies under conditions of normal use. Our furniture products are not intended for outdoor use. The
warranty does not cover: 1) defects caused by improper assembly or disassembly; 2) defects caused by shipping,
claims for damage during transit to you should be placed immediately by you to the transportation company;

3) defects occurring after purchase due to product modification, intentional damage, accident, misuse, abuse,
negligence or exposure to the elements; 4) cosmetic damage and 5) labor or assembly costs.

There are no warranties, express or implied, including without limitation merchantability or fitness for particular use,
except as (i) contained herein or (ii) required by applicable law in the state whose law governs (which shall be New
Jersey absent controlling law imposing the law of another state in lieu thereof as governing law). All warranties of
whatsoever derivation shall be limited to the term set forth above, unless otherwise required by applicable law.

Manufacturer’s employees or representatives’ … ORAL OR OTHER WRITTEN STATEMENTS DO NOT CONSTITUTE
WARRANTIES, shall not be relied upon by Buyer, and are not a part of the contract for sale or this limited warranty.

Except as provided herein, Bell’O International shall have no liability or responsibility to the purchaser or any other
person or entity with respect to any liability, loss or damage caused directly or indirectly by use of the product,
including, but not limited to, any incidental or consequential damages. Some states do not allow limitation on how
long an implied warranty can last or the exclusion of limitation of incidental or consequential damages, so the above
limitation and exclusion may not apply to you.

This warranty gives you specific legal rights. You may also have other rights, which vary from state to state.

BELL'O INTERNATIONAL CORPORATION, 711 Ginesi Drive, Morganville, NJ 07751-1235

Phone: [phone] Fax: [phone] Web: www.bello.com E-mail: [e-mail]