Beko DSFN 4530 User manual [EN]
Dishwasher
Instruction Manual
DSFN 4530
Dear customer,
Please read carefully right through this instruction booklet before installing or
operating your dishwasher. The following instructions should prevent the risk of
personal injury and/or damage to the appliance.
Please keep these documents in a safe place for later reference.
This operating manual has been written for several different machines, and some
of the features mentioned here may not apply to your particular model.
Explanation of symbols
Throughout this User Manual the following symbols are used:
Important information or useful hints about usage
Warning for hazardous situations with regard to life and property
Warning for electric shock
This product was manufactured using the latest technology in environmentally friendly conditions.
Dishwasher
Instruction Manual
DSFN 4530
Dear customer,
Please read carefully right through this instruction booklet before installing or
operating your dishwasher. The following instructions should prevent the risk of
personal injury and/or damage to the appliance.
Please keep these documents in a safe place for later reference.
This operating manual has been written for several different machines, and some
of the features mentioned here may not apply to your particular model.
Explanation of symbols
Throughout this User Manual the following symbols are used:
Important information or useful hints about usage
Warning for hazardous situations with regard to life and property
Warning for electric shock
This product was manufactured using the latest technology in environmentally friendly conditions.
CONTENTS
1. Getting To Know Your Machine 3
View of the Machine 3
Technical Specifications 4
2. Important safety instructions 5
General safety 5
Intended use 5
Children’s safety 6
3. Installation 7
Appropriate installation location 7
Connecting water supply 7
Connection to the drain 8
Adjusting the feet 9
Aquasafe+ 9
Electrical connection 9
Initial use 9
Disposing of packaging material 10
Transportation of the product 10
Compliance with the WEEE Directive and
Disposing of the Waste Product: 10
Compliance with RoHS Directive: 10
4. Prewashing 11
Tips for energy saving 11
Water softening system 11
Adjusting the water softening system 11
Adding salt 12
Detergent 13
Adding detergent 13
Tablet detergents 14
Rinse aid 15
Silverware basket 18
Silverware basket piece 18
Movable silverware basket 18
Collapsable lower basket
wires (2 pieces) 19
Collapsable lower
basket wires (4 pieces) 19
Collapsable lower basket
wires (6 pieces) 20
Collapsable lower basket
wires (4 & 8 pieces) 21
Lower basket multipurpose / height
adjustable service rack 22
Lower basket bottle wire 23
Upper basket height adjustable rack 23
Upper basket drawer 23
Upper basket glass support piece 24
Collapsable upper basket wires 24
Collapsable upper basket wires 25
Adjusting the height of loaded upper
basket 26
Adjusting the height of loaded upper
basket 27
Adjusting the height of empty upper
basket 28
5. Maintenance and cleaning 29
Cleaning the outer surface of
the product 29
Cleaning the interior of the machine 29
Cleaning the filters 29
Cleaning the hose filter 30
Cleaning the impellers 30
6. Troubleshooting 32
1
Getting To Know Your Machine
View of the Machine
1. Upper dish basket with shelf
2. Guide rail for the upper dish basket
3. Salt container
4. Cutlery basket
5. Detergent dispenser
6. Door
7. Control panel
8. Filters
9. Lower sprayer arm
10. Lower basket
11. Upper sprayer arm
12. Housing (depends on the model)
13. Turbo fan heat drying system (depends
on the model)
14. Model and serial tag
3
EN
Technical Specifications
Permitted water pressure: 0,3 –10 bar (= 3 – 100 N/cm² = 0,01-1,0Mpa)
Electrical connection: 220-240 Volts, 10 Amps (see type plate)
Energy efficiency class “A”
Electrical Safety class-1
Output: 1900-2200 W
Heat output: 1800 W
This device corresponds to the following EU directives:
2006/95/EC: Low Voltage Directive
2004/108/EC: EMV Directive
DIN EN 50242: Electrical dishwasher for home use Testing procedures for
practical service conditions
Because we continually strive to improve our products, we may change our
specifications and designs without prior notice.
Note for Testing Institutes
The necessary information for performance testing will be provided upon request.
The request can be done by e-mail through:
dishwasher@standardloading.com
Please do not forget to write the model code and stock code information of the
appliance besides your contact information in the e-mail. The model code and
stock code information can be found on the rating label, which is placed on the
side of the door.
4
EN
2
Important safety instructions
This section contains safety
instructions that will help to get
protected from risk of personal injury
or property damage Failure to follow
these instructions shall void all
warranties.
General safety
• Never place the product on a
carpet-covered oor; otherwise,
lack of airow beneath the product
will cause electrical parts to
overheat. This will cause problems
with your product.
• Do not operate the product if the
power cable / plug is damaged!
Call the Authorised Service Agent.
• Connect the product to a grounded
outlet protected by a fuse
complying with the values in the
“Technical specifications” table. Do
not neglect to have the grounding
installation made by a qualified
electrician. Manufacturer shall not
be liable for any damages that will
arise when the product is used
without grounding in accordance
with the local regulations.
• The water supply and draining
hoses must be securely fastened
and remain undamaged.
• Unplug the product when not in
use.
• Never wash the product by
spreading or pouring water onto it!
There is the risk of electric shock!
• Never touch the plug with wet
hands! Never unplug by pulling
on the cable, always pull out by
grabbing the plug.
• The product must be unplugged
during installation, maintenance,
cleaning and repairing procedures.
• Always have the installation and
repairing procedures carried out
by the Authorised Service Agent.
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorised persons.
• Never use chemical solvents in the
product. They bring forth risk of
explosion.
• When you pull the upper and lower
baskets out completely, the door of
the product will bear all the weight
of the baskets. Do not put other
loads on the door; otherwise, the
product may tilt.
• Never leave the door of the
product open apart from loading
and unloading procedures.
• Do not to open the door of the
product when it is running unless
necessary. Be careful for the rush
of hot steam when you need to
open the door.
Intended use
This appliance is intended to be used
in household and similar applications
such as:
• staff kitchen areas in shops,
offices and other working
environments;
• farm houses;
• by clients in hotels, motels
and other residential type
environments;
• bed and breakfast type
environments;
• Only dishwasher safe detergents,
rinse aids and additives must be
used.
5
EN
• The manufacturer waives any
responsibility arisen from incorrect
usage or transportation.
• The service life of your product
is 10 years. During this period,
original spare parts will be
available to operate the appliance
properly.
• This product should not be
used by persons with physical,
sensory or mental disorders or
unlearned or inexperienced people
(including children) unless they are
attended by a person who will be
responsible for their safety or who
will instruct them accordingly for
use of the product.
Children’s safety
• Electrical products are dangerous
for the children. Keep children
away from the product when it is
in use. Do not let them to tamper
with the product.
• Do not forget to close the door of
the product when leaving the room
where it is located.
• Store all detergents and additives
in a safe place away from the
reach of the children.
6
EN
3
Installation
Refer to the nearest Authorised
Service Agent for installation of your
product. To make the product ready
for use, make sure that the electricity,
tap water supply and water drainage
systems are appropriate before calling
the Authorised Service Agent. If they
are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C Preparation of the location and
electrical, tap water and waste
water installations at the place of
installation is under customer's
responsibility.
B Installation and electrical
connections must be carried out
by the Authorised Service Agent.
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorised persons.
B Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
A Make sure that the water inlet and
discharge hoses are not folded,
pinched or crushed while pushing
the product into its place after
installation or cleaning procedures.
When placing the product, pay
attention not to damage the floor,
walls, piping, etc. Do not hold the
product from its door or panel to
move it.
Appropriate installation location
• Place the product on a solid and
at oor that has sufficient load
carrying capacity! The product
must be installed on a at surface
in order for the door to be closed
comfortably and securely.
• Do not install the product at places
where temperature may fall below
0ºC.
• Place the product at least 1 cm
away from the edges of other
furniture.
• Place the product on a rigid oor.
Do not place it on a long pile rug
or similar surfaces.
A Do not place the product on the
power cable.
• Make sure that you select a
location that will allow you to load
and unload the dishes in a fast
and comfortable manner.
• Install the product in a place close
to the tap and the drain hole.
Select the installation location
by considering that it will not be
changed after the connections are
made.
Connecting water supply
C We recommend attaching a filter
on the house/apartment supply
water inlet to protect the machine
from damages that may arise
from impurities (sand, dirt, rust,
etc.) coming from the urban water
supply system or from your own
water system as well as to prevent
complaints such as yellowing or
sludge accumulation at the end of
washing.
7
EN
Permitted water temperature: up to
25°C
The dishwasher may not be connected
to open warm water devices or ow-
through water heaters.
• Do not use old or used water inlet
hose on the new product. Use the
new water inlet hose supplied with
the product.
• Connect the water inlet hose
directly to the water tap. Pressure
coming from the tap should be
minimum 0.3 and maximum
10 bars. If the water pressure
exceeds 10 bars, a pressure
relief valve should be installed in
between.
C Use a screw-on hose connector
to connect the water inlet hose to
a water tap with a ¾ inch external
thread. If required, use a filter
insert to filter deposits from the
pipes.
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink’s
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the oor.
1011
1009
• Open the taps completely after
making the connections to check
for water leaks.
A For your safety, close the water
inlet tap completely after the
washing programme is over.
A discharge hose longer than 4 meters
causes dirty washing.
Attach the water discharge hose
to the drainpipe without bending it.
Tightly fix the water discharge hose to
the drainpipe in order to prevent any
dislocation of the water discharge hose
during operation of the product.
C Drainpipe must be connected to
the sewage system and it should
not be connected to any surface
water.
8
EN
Adjusting the feet
If the door of the product cannot be
closed properly or if the product swings
when you push it slightly, then you
need to adjust the feet of the product.
Adjust the feet of the product as
illustrated in the installation manual
supplied with the product.
Aquasafe+
(depends on the model)
Protect the Aquasafe+ system against
water leaks that may occur at hose
inlet. Water contact with the valve
box of the system must be prevented.
Otherwise, electrical assembly will get
damaged. If the Aquasafe system is
damaged, unplug the product and call
the Authorised Service Agent.
A As the hose set contains electrical
connections and assemblies, never
shorten or lengthen the hose with
extension hoses.
1010
Electrical connection
Connect the product to a grounded
outlet protected by a fuse complying
with the values in the "Technical
specifications" table. Manufacturer
shall not be liable for any damages
that will arise when the product is used
without grounding in accordance with
the local regulations.
• Connection must comply with
national regulations.
• Power cable plug must be within
easy reach after installation.
A Unplug the product after the
washing programme is over.
• The voltage and allowed fuse or
breaker protection are specified
in the “Technical specifications”
section. If the current value of
the fuse or breaker in the house
is less than 16 Amps, have a
qualified electrician install a 16
Amp fuse.
• The specified voltage must be
equal to your mains voltage.
• Do not make connections via
extension cables or multi-plugs.
B Damaged power cables must be
replaced by the Authorised Service
Agent.
B If the product has a failure, it
should not be operated unless it is
repaired by the Authorised Service
Agent! There is the risk of electric
shock!
Initial use
Before starting to use the product,
make sure that all preparations
are made in accordance with the
instructions in sections "Important
safety instructions" and "Installation".
• To prepare the product to do the
dishes, perform first operation
in the shortest programme with
9
EN
detergent while the machine is
empty. During the initial use, fill the
salt reservoir with 1 litre of water
prior to filling it with salt.
C Some water might have remained
in the product due to the
quality control processes in the
production. It is not harmful for the
product.
Disposing of packaging material
Packaging materials are dangerous to
children. Keep packaging materials in
a safe place away from reach of the
children.
Package information
Packaging materials of the product
are manufactured from recyclable
materials in accordance with our
National Environment Regulations. Do
not dispose of the packaging materials
together with the domestic or other
wastes. Take them to the packaging
material collection points designated
by the local authorities.
Transportation of the product
A If you need to move the product, do
it in upright position and hold from
the rear side. Slanting the product
onto its front side may cause the
electronic parts in it get wet and
damaged.
1. Unplug the product before
transporting it.
2. Remove water drainage and water
supply connections.
3. Drain the remaining water in the
product completely.
Compliance with the WEEE Directive and Disposing of the Waste Product:
This product complies with EU WEEE
Directive (2012/19/EU). This product
bears a classification symbol for waste
electrical and electronic equipment
(WEEE).
This product has been manufactured
with high quality parts and materials
which can be reused and are suitable
for recycling. Do not dispose of the
waste product with normal domestic
and other wastes at the end of its
service life. Take it to the collection
center for the recycling of electrical and
electronic equipment. Please consult
your local authorities to learn about
these collection centers.
Compliance with RoHS Directive:
The product you have purchased
complies with EU RoHS Directive
(2011/65/EU). It does not contain
harmful and prohibited materials
specied in the Directive.
10
EN
Loading...