Beko DIS 1520, DIS 1520 N QUICK REFERENCE GUIDE
QUICK REFERENCE GUIDE
.Attention:Please read the operating manual prior to operating the machine for the first time !
How to use your dishwasher:
On/Off button
1
Rinse aid level indicator light
2
Salt level indicator light
3
4
Start/Cancel button
5
Programme selection button
6
Programme indicator lights
EN
• Open the water tap.
• Plug to the mains.
• Open the door and load the dishwasher. Check if both upper
and lower spray arms move freely.
• Pour (Put in) the detergent.
• Push in the on/off button and check that the programme light
comes on.
• Check the salt and rinse aid level indicators before you start
the machine. If necessary add salt and rinse aid.
• Use the programme selection button to choose your washing
programme.
• Start the programme with the Start/Cancel button:
• Close the door then programme starts.
Programme Table
Programme number
Programme name
Cleaning temperature
Degree of Soiling
Suitable for removing the
remnants on the soiled dishes
that will be kept waiting in the
machine for a few days, and
thus, for preventing the bad
1 2 3 Reference* 4 5
Pre-wash 30 Min. Intensive
35°C- 50°C 70°C
Suitable for lightly soiled daily
dishes that are scraped or pre-
cleaned.
odor buildup.
Attention
Avoid opening the door during the washing process. This interrupts
the washing process, and hot steam will escape. When the door is
closed, the programme will continue.
• An audio signal with an interval of 10 seconds warns you to
switch your machine off when the selected washing program
ends. This audio signal warns you for a duration of 1-2 minutes
and then turns off.
• Open the door Press the on/off button after the programme is
completed. The indicator lights will go off.
• Close the water tap. Pull out the plug.
• Allow your dishes to cool for 15 minutes, with the door open.
Unload the dishes. Begin with the lower basket.
Quick & Clean
60°C
Most economical washing
program for the medium soiled
daily dishes that are kept
waiting.
Daily washing program at which
the medium soiled dishes that
are kept waiting are cleaned in
the fastest way.
Suitable for heavily soiled
dishes, pots and pans.
- Few Medium Medium High
A=25 cm³/15 cm³ B=5 cm³
Programme sequence
The consumption values shown in the table were determined under standard conditions. Differences may therefore occur under practical conditions.
* Reference programme for testing institutes
The tests in accordance with EN 50242 must be carried out with a full water softener salt dispenser and a full rinse aid reservoir, and using the test programme.
Detergents
(without options)
Duration (min) 15 30 172 58 115
Water (I) 3,6 10,2 13 10,6 14,4
Energy (kWh)
- A A+B A+B A+B
Pre-wash
▼
End
- 0,77 0,94 1,17 1,32
Wash
▼
Cold rinse
▼
Hot Rinse
▼
End
Pre-wash
▼
Wash
▼
Cold rinse
▼
Hot Rinse
▼
Dry
▼
End
Wash
▼
Cold rinse
▼
Hot Rinse
▼
Dry
▼
End
Pre-wash
▼
Wash
▼
Cold rinse
▼
Hot Rinse
▼
Dry
▼
End
QUICK REFERENCE GUIDE
On/Off button
1
Rinse aid level indicator light
2
Salt level indicator light
3
4
Start/Cancel button
5
Programme selection button
6
Programme indicator lights
EN
On/off button
You turn your dishwasher on / off with this button. When turning on,
the indicator light for the last used programme will light up.
Visual Indicator
Salt level indicator light
When this indicator light comes on, you must
refill special salt (If applicable).
In machines which do not possess an electrical
salt indicator, the salt content can be read on
the container for the salt. When the visual fill
indicator is dark, there is enough salt in the
container.
When the colour is light, open the container and add dishwasher
salt.
Visual Indicator
(If applicable)
Rinse aid level indicator light
If this indicator light comes on, you have to
refill rinse aid (If applicable).
You can also tell whether rinse aid must be
refilled by looking at the rinse aid dispenser.
When the visual fill indicator is dark, there is
enough rinse aid in the dispenser.
When the colour is light, open the dispenser
and refill rinse aid.
Program selection buttons
Use the program selection button to select the desired program.
The corresponding program light lights up.
! Important:
The new program will NOT start right from the beginning. It will start
from the stage last carried out by the previous program selection.
! Warning
Depending on the length of the terminated program detergent and
rinse aid may still be in the dispensers.
Improper Loading Of Dishware
Start/cancel button
You use this button to start the selected program; the light on the
button lights up.
Stop the program with the start / cancel button if you would like to
open the door once the dishwasher’s washing program is running.
How to cancel the washing program
To cancel a programme while the machine is operating:
Open the door.
! Care must be taken when opening the door, as steam will escape.
Press the Start/Cancel button for 3 seconds. Start/Cancel indicator
light will start flashing. Close the door. The machine will drain
the water inside the machine for 45 seconds. The programme is
cancelled when Start/Cancel indicator light goes off. Then you can
choose and start a new programme.
! Important:
Depending on the stage of the programme you have cancelled,
there may be detergent residue or rinse aid inside the machine and
on the load. Make sure the items in the dishwasher are not used
before washing properly.
How to change the washing program
To change the program selection while the machine is operating
open the door.
! Care must be taken when opening the door, as steam will escape.
Press Start/Cancel button. The indicator light will go off.
Select the new program. Press Start/Cancel button. The indicator
light will be on and close the door new program will start.
17 9185 01 00_AG
Loading...