Congratulations on your choice of a Quality Appliance
which has been designed to give you service for many years.
WARNING!
IMPORTANT!
DO NOT connect your appliance to the electricity supply until all packing and
transit protectors have been removed.
• Leave to stand for at least 4 hours before switching on, to allow compressor
oil to settle, if transported horizontally.
• If you are discarding an old appliance with a lock or latch fitted to the door,
ensure that it is left in a safe condition to prevent the entrapment of children.
• This freezer must only be used for its intended purpose i.e. the storing and
freezing of edible foodstuff.
• Do not dispose of the appliance on a fire. Your appliance contains non CFC
substances in the insulation which are potentially flammable if exposed to fire.
We suggest you contact your local authority for disposal information and facilities
available.
• Do not damage the refrigerant circuit.
• Do not use electrical appliance inside the freezer.
• Do not use mechanical devices or other means to accelerate the defrosting
process other than those recommended by the manufacturer.
To obtain the best possible performance and trouble free operation from your
appliance it is very important to carefully read these instructions.
Failure to observe these instructions may invalidate your right to free service
during the guarantee period.
We suggest you keep these instructions in a safe place for easy reference.
CHEST FREEZER
CF 382
PERFORMANCE
Energy efficiency class
Energy consumption - Kwh/year
Net storage - vol fresh food Itrs (cu.ft.)
Net storage - vol frozen food Itrs (cu.ft.)
Total net vol - Itrs (cu.ft.)
Frozen food compartment rating
Conservation time from failure - hours
Freezing capacity fresh food - kg
Climate class
Operating noise level dB (A)
1
C
254
----105 lt. (3.7)
105 lt. (3.7)
4 STAR
28 h
8
SN
41
CONTENTS PAGE
SAFETY FIRST / ELECTRICAL REQUIREMENTS
TRANSPORTATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
STARTING
TEMPERATURE CONTROL AND ADJUSTMENT/INDICATOR LIGHTS
STORING FROZEN FOOD
FREEZING FRESH FOOD
FROZEN FOOD SYMBOLS AND FREEZER CALENDER
DEFROSTING
CLEANING AND CARE
3
4
5
6
7
8
8
9
9
10
DO'S AND DON'TS
PROBLEM SOLVING/TROUBLE SHOOTING
GUARANTEE DETAILS
HOW TO OBTAIN SERVICE
2
11
12
12
13
ELECTRICAL REQUIREMENTS
Before you insert the plug into the wall socket make sure that the voltage and
the frequency shown in the rating label at the back wall of the appliance
corresponds to your electricity supply. Rating label is on the apper left side of
the back wall. We recommend that this appliance is connected to the mains
supply via a suitably switched and fused socket in a readily accessible position.
Should the mains lead of the appliance becom damaged or should it need
replacing at any time, it must bee replaced by a special purpose made mains
lead which can only be obtained from a BEKO Authorized Service Agent.
WARNING! THIS APPLIANCE MUST BE EARTHED
If the fitted moulded plug is not suitable for your socket, then plug should cut off
and an appropriate plug fitted. Destroy the old plug which is cut off as a plug
with bared cord could cause a shock hazard if inserted into a socket elsewhere
in the house.
The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTA approved BS 1362 fuse of the same rating must
be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover
the plug must not be used until a replacement fuse cover has been fitted. Colour
of the replacement fuse cover must be the same colour as that visible on the pin
face of the plug. Fuse covers can be obtained from a BEKO Authorised Service
Agent.
IMPORTANT! FITTING A
DIFFERENT PLUG
As the colours of the wires in the
mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals
in your plug proceed as follows:
(See diagram).
1. Connect the green-Yellow or
green (Earth) wire to the therminal
in the plug marked ‘E’ or with the
symbol or coloured green
and yellow or green.
2. Connect the blue (Neutral) wire
to the terminal in the plug marked
GREEN &
YELLOW
OR
GREEN
N
BLUE
OR
BLACK
BROWN
32 mm
22 mm
6 mm
CORD GRIP
6 mm
RED
OR
L
6 mm
12 mm
FUSE
FITTED WITH
CARTTRIDGE FUSE
FIT BS 1362 REPLECAMENT
BS 1362 13A FUSE ALWAYS
‘N’ zor coloured black.
3. Connect the brown (Live) wire
to the terminal in the plug marked
‘L’ or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor
or in the main fuse box.
If in doubt contact a qualified electrician.
3
TRANSPORTATION INSTRUCTIONS
1. The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2. If during the course of transport the appliance, has been transported horizontally,
it must not be operated for at least 4 hours, to allow the system tosettle.
3. Failure to comply with the above instructions could result in damage occurring
to the appliance. The manufacturer will not be held responsible if these instructions
are disregarded.
4. The appliance must be protected against rain, moisture and other atmospheric
influences.
IMPORTANT!: Care must be taken while cleaning/carrying the appliance to
avoid touching
the condenser metal wires at the back of the appliance, as you might injure your
fingers and hands or damage your product.
Important : This appliancce is not designed for stacking with any other
appliance.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
“IMPORTANT: Make sure that mains cable is not caught under the appliance
during and after carrying / mouving the appliance, to avoid the mains cable
becoming cut or damaged.”
When positioning your appyiance, take care not to damage your flooring, pipes,
wall covering etc. Do not move the appliance by pulling by the lid or handle.
Do not allow children to play with the appliance or tamper with the controls
BEKO (UK) Ltd. declines to accept any liability should the instructions not be
followed.
4