TUBE AMP MODELER TM300
Ultimate Tube Am p Modeling Eec ts Pedal
Thank you for show ing your condence in us by purchasing the BEHRINGER TUBE AMP MODELER TM300.
This high-quality e ects pedal provides 3 classic guitar amps, 3 gain mo des and 3 mic placements for a
total of 27 congur ations that let you easily achieve the most sought-after tube amp sounds from clean,
crunch to super-fat distor tion. Thanks to its high-performance features you can achieve the t ypical hard
rock or heav y metal distortion sounds.
1. Controls
(2)
(8)
(3)
(1)
(5)
(4)
(7)
(6)
(10)
(11)
(9)
(1) The LEVEL control adjust s the output level.
(2) The LOW control allows you to boos t/cut the low-frequenc y range.
(3) The HIGH control allows you to boost/cut the high-frequency range.
(4) The DRIVE control adjusts the amount of overdrive eec t.
(5) The MIC switch simulates the microphone placement (orientation and distance) in relation to
the cabinet. Select CLSIC (Classic: dis tant mic placement without ambience) to achieve high
mid-range content and a greater denition of notes like with c lassic early tube amps. In CNTR
(Center: close miking at the center of a cone) you get greater high mid-range content and increased
low-end for mega crunchy results. OFF X (O Axis: close miking at the e dge of a cone) is very similar
to CNTR, but pro duces a smoother, softer sound with less up per mid-range content; per fect in
combination with MODE position HOT.
(6) Use the MODE switch to dial up one of 3 gain settings (HOT, HI G, CLN) that you want to combine
with the amp setting.
(7) Use the AMP swi tch to select one of 3 great c lassic tube amps. You will recogni ze these classic amp
tones as soon a s you hear them. For crys tal-clear, transparent s ounds with dynamic bass s elect TWEED.
For aggressi ve mids and incredible sus tain select BRIT(ISH). Rounder and mor e evened-out (yet sti ll
sophisti cated) sounds can be diale d up if you select CALIF(ORNIAN); it ’s perf ect for leads.
(8) The ON /BATT LED illuminates w hen the eect is activated. It als o serves as a batter y level indicator.
TUBE AMP MODE LER TM300
(9) Use the footswitch to ac tivate/deactivate the eect.
(10) Use this ¼" TS IN connector to p lug in the instrument cable.
(11 ) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V bat tery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be caref ul not to
scratch the unit.
◊ The TM300 has no on /o switch. As soon as you insert the plug into the in connector,
the TM300 is on. When not in use, remove the plug from the in connec tor. This ex tends
the life of the battery.
The SERIAL NUMBER is located at the underside.
2. Safety Instructions
Do not use near water, or install near heat s ources. Use only authorize d attachments/accessories.
Do not service produc t yourself. Contact our qualied servicing personnel for servicing or rep airs,
especially w hen power supply cord or plug is damaged.
3. Warranty
Please regis ter your new BEHRINGER equipment right after your purchas e by visiting
http://behringer.com and read the terms and conditions of our warranty care fully.
4. Specications
In
Connec tor ¼" TS
Impedanc e 500 kΩ
Out
Connec tor ¼" TS
Impedanc e 1 kΩ
Power Supply
9 V𝌂, 100 mA regulate d
BEHRINGER PSU-SB
USA/Canad a 120 V~, 60 Hz
Europe/ U.K./ 230 V~, 50 Hz
Power conne ctor 2 mm DC jack,
negative center
Batter y 9 V type 6LR 61
Power consumption 30 mA
Physical/Weight
Dimensio ns approx. 2 ⁄ x 2 ¾ x 4 ⁄"
(H x W x D) approx. 5 4 x 70 x 123 mm
Weight approx. 0.73 lbs / 0.33 kg
BEHRING ER is constant ly strivin g to maintain the
highes t professio nal standard s. As a result of t hese eff orts,
modifi cations may be m ade from tim e to time to exis ting
produc ts withou t prior notice . Specific ations and app earance
may there fore diff er from thos e listed or show n.
Australia
China 220 V~, 50 Hz
Korea 220 V~, 60 Hz
Japan 100 V~, 50/60 Hz
TECHNICAL SPECIFICATIONS AND APPEARANCES ARE SUBJECT TO CHANGE WITHOUT NOTICE AND ACCURACY IS NOT GUARANTEED. BEHRINGER IS PART OF THE
MUSIC GROUP (MUSIC-GROUP.COM). ALL TRADEMARKS ARE THE PROPERTY OF THEIR RESPECTIVE OWNERS. MUSICGROUP ACCEPTS NO LIABILITY FOR ANY LOSS
WHICH MAY BE SUFFERED BY ANY PERSON WHO RELIES EITHER WHOLLY OR IN PART UPON ANY DESCRIPTION, PHOTOGRAPH OR STATEMENT CONTAINED HEREIN.
COLORS AND SPECIFICATIONS MAY VARY FROM ACTUAL PRODUCT. MUSIC GROUP PRODUCTS ARE SOLD THROUGH AUTHORIZED FULLFILLERS AND RESELLERS
ONLY. FULLFILLERSAND RESELLERS ARE NOT AGENTS OF MUSICGROUP AND HAVE ABSOLUTELY NO AUTHORITY TO BIND MUSICGROUP BY ANY EXPRESS OR
IMPLIED UNDERTAKING OR REPRESENTATION. THIS MANUAL IS COPYRIGHTED. NO PART OF THIS MANUAL MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM
OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND RECORDING OF ANY KIND, FOR ANY PURPOSE, WITHOUT THE EXPRESS
WRITTEN PERMISSION OF MUSICGROUPIPLTD. ALL RIGHTS RESERVED. © 2012 MUSICGroupIPLtd. Trident Chambers, Wickhams Cay, P.O. Box 146, Road Town,
Tortola, British Virgin Islands