Behringer HB01 User Manual
HELLBABE HB01
Ultimate Wah-Wah Pedal with Optical Control
Thank you for show ing your condence in us by purchasing the BEHRINGER HELLBABE HB01. This professional Wah-Wah pedal is
specially designed to provide every thing you need for all-style classic and modern s ounds. Thanks to its high-performance features
like exible Q control, freely adjustable heel-down frequency range (perfe ct for use with bass guitars), tunable boost func tion
and much more you’re armed with a to ol for serious musicians yearning for the most up-to -date sounds to add new dimensions to
their creativity.
WHERE TO PUT YOUR WAH-WAH
Most guitar players put their Wah-Wah pedal before time base d eects like reverb, anger, chorus, vibrato etc. This assures that the
eect s are added to the Wah-Wah sound. Even all kinds of distor tion/overdrive eects should be placed before this unit to achieve
best tone results.
1. Controls
(4) (11) (7) (10) (2)
(1) (3) (5) (6) (8) (9)
(13) (12)
(1) This is the pedal of the HB01. The unit will be activated as soon as you put your foot on and move it. By t aking your foot from
the pedal the eect will be deactivated. Depending on the timer adjustment (see (10)) the HB01 remains ac tive for a few
seconds af ter that.
(2) The RANGE control lets you e xtend the heel-down frequency to match the f requency range of bass guitars for example
(440 Hz to 250 Hz).
(3) The BOOST switch activate s the boost function. The output level is then increased - but only if the Wah eec t is switched on.
(4) The BOOST control adjusts the level of outpu t boost (max. +15 dB). This control is only act ive if the BOOST switch is set to ON
(and if the Wah is switched on).
(5) The Q control allows to change the shape of the lter peak. High Q set tings (turned to right position) produce a large,
selective lter peak with a high output level. Low Q set tings (turned to left position) provide a lower output level with a
subtle, broad lter peak producing less voc al eect.
(6) Turning the FINE control allows to e xtend the toe-down frequenc y of the sweep range up to 2.2 kHz.
(7) Use this ¼" TS IN connector to plug in the ins trument cable.
(8) The ¼" TS OUT connector s ends the eected signal to your amp.
(9) The ¼" TS OUT/BYPASS connector can be used as second output or as bypass, hard wired to the input, to play out the
uneected signal.
(10) The TIMER ADJ control (access able through a hole in the housing) is needed to adjust the time the eec t remains active after
taking your foot from the pedal.
(11 ) Use the 9 V connec tion to plug in a 9 V power supply (not included).
(12 ) The STATU S-LED illuminates when the eect is activated.
(13 ) The BOOST-LED illuminates when the boost func tion is activated.
(14) The rocker screw allows to adjust the resistance of the rocker mechanism.
(14)
HELLBABE HB01
The BATTERY COMPARTMENT is located at the bottom of the unit. Open the lid to install or replace the 9 V b attery.
◊ The HB01 has no on/o switch. As soon as you inser t the jack into the IN connector, the HB01 begins running.
When not using the HB01, remove the jack from the IN connec tor. This extends the life of the bat tery.
The SERIAL NUMBER is located at the bottom of the unit.
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized attachments/accessories. Do not service product yourself.
Contact our qualied servicing personnel for servicing or repairs, especially when power supply cord or plug is damaged.
3. Warranty
Please regis ter your new BEHRINGER equipment right after your purchase by visiting ht tp://behringer.com and read the terms and
conditions of our warranty carefully.
4. Specications
Input
Connector ¼" TS
Impedance 1 MΩ
Output
Connector ¼" TS
Impedance 1 kΩ
Output/Bypass
Connector ¼" TS
Impedance 1 kΩ
Power Supply
9 V, 100 mA DC regulated
PSU-SB-CN BEHRINGER 220 VAC adaptor China
PSU-SB-EU BEHRINGER 230 VAC adaptor Europe
PSU-SB-JP BEHRINGER 100 VAC adaptor Japan
PSU-SB-SAA BEHRINGER 240 VAC adaptor Australia
PSU-SB-UK BEHRINGER 240 VAC adaptor UK
PSU-SB-UL BEHRINGER 120 VAC adaptor USA
Power connector 2 mm DC jack, negative center
Batter y 9 V type 6LR61
Power consumption 30 mA
Dimensions/Weight
Dimensions (H x W x D) 3.8 x 4.7 x 10" / 99 x 120 x 254 mm
Weight 2.6 lbs / 1.2 kg
BEHRINGER i s constantly str iving to maintain the h ighest profess ional standards. A s a result of these e ffort s, modificatio ns may
be made fro m time to time to exis ting product s without prior n otice. Specific ations and appearan ce may therefore dif fer from
those lis ted or shown.
TECHNICAL SPECIFICATIONS AND APPEARANCES ARE SUBJECT TO CHANGE WITHOUT NOTICE AND ACCURACY IS NOT GUARANTEED. BEHRINGER IS
PART OF THE MUSIC GROUP (MUSIC-GROUP.COM). ALL TRADEMARKS ARE THE PROPERTY OF THEIR RESPECTIVE OWNERS. MUSIC GROUP ACCEPTS NO
LIABILITY FOR ANY LOSS WHICH MAY BE SUFFERED BY ANY PERSON WHO RELIES EITHER WHOLLY OR IN PART UPON ANY DESCRIPTION, PHOTOGRAPH
OR STATEMENT CONTAINED HEREIN. COLORS AND SPECIFICATIONS MAY VARY FROM ACTUAL PRODUCT. MUSIC GROUP PRODUCTS ARE SOLD THROUGH
AUTHORIZED FULLFILLERS AND RESELLERS ONLY. FULLFILLERS AND RESELLERS ARE NOT AGENTS OF MUSIC GROUP AND HAVE ABSOLUTELY NO
AUTHORITY TO BIND MUSIC GROUP BY ANY EXPRESS OR IMPLIED UNDERTAKING OR REPRESENTATION. THIS MANUAL IS COPYRIGHTED. NO PART OF THIS
MANUAL MAY BE REPRODUCED OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, INCLUDING PHOTOCOPYING AND
RECORDING OF ANY KIND, FOR ANY PURPOSE, WITHOUT THE EXPRESS WRITTEN PERMISSION OF MUSIC GROUP IP LTD. ALL RIGHTS RESERVED.
© 2012 MUSIC Group IP Ltd. Trident Chambers, Wickhams Cay, P.O. Box 146, Road Town, Tortola, British Virgin Islands
Loading...