52.897
LS-1W Animation Laser RGB DMX
152.897
Instruction Manual
（Before using，please read the user manual carefully.）
This is product integrates many advanced technologies like optics,
electronics, digital graphic processing, especially designed for dancing halls
and DISCO. According to music rhythms, built-in beam program can be
activated; if using smoke, light curtain wall and time tunnel can be formed to
create a colorful and fantastic laser world.
NOTICE
The best temperature range of using laser：20～35℃.
Do not reflect to the eye directly in case of hurting.
Do not use the laser over AC220V～240V and please make sure
reliable grounding.
Do not turn on and turn off frequently; this will affect the laser’s
normal life.
Based on the working character of solid state laser, please try not
to work for a long time. If the laser works continuously for three
hours, please turn off the laser 15 minutes. After the laser is cold,
start to turn on again.
Do not use hands to touch the lens in case it will affect the effects.
If there appears breakdown, please ask experts to repair; do not
remove the laser yourself.
Attention：Destroy the laser or tear up the warranty label artificially,
it’s all beyond warranty scope. Please read the warranty rules.
Animation Laser (without PC interface)
Front panel and rear panel schemes (According to different models, the
panel will be different.)
○
,1 light outlet ○,2 Fan
○
,3 power supply
○
,4 Sound control sensitivity knob
○
,5 DMX XLR
○
,6 power socket
○
,7 Address code switch ○,8 sound control MIC
1. Operating Instructions
DIPSWITCH CHART
FUNCTION
#1 #2 #3 #4 #5 #6 #7 #8 #9 #10
X X X X X X X X X x SOUND ACTIVE
1 X X X X X X X x x AUTO MODE
1
1 x x x x x x x x Animatiom
Sound control Auto working
Animation
1.1 Single user mode:
1.1.1 Use dip switch to set operating mode(See the table below）. Set
the operating mode according to clients’ requirement: SOUND
ACTIVE or AUTO MODE.
1.1.2 Connect the power supply, and the lamp start to project laser light.
1.1.3 When in SOUND ACTIVE mode，adjust sound control sensitivity,
and adjust the sound control sensitivity knob according to the
surrounding’s sound strength. In the front panel when the blue
indicator flashes to indicate the sound activation, the system is in
sound active program; when in Auto mode, the system is in
Auto-working program.
1.2 Scanner master & slave synchronous mode:
The switching method of Master & slave synchronous mode
Master: sound activation( switch 0 in address code) or auto mode( switch
1in address code) or animation mode( switch 1,2 in address code)
Master ( sound activation, auto, animation mode)
Loading...