Bauknecht WA8789 User Manual

21
YOUR ELECTRONIC WASHING MACHINE GB
This washing machine is equipped with all-elec tronic control , wh ich ope ns up a host of possi bilit ies fo r you. Amongst others, these include: precise determination of load,
Dynamic-Sense Technolo gy
, imbalance detection and correction system, fast progra mme changing, accurat e programme sequence indicator, start delay, soaking, safety feature
“intelligent (anti-flood) Water Stop system”
.
The
load determining facility
evaluates the laundry load at the start of the wash cycle and optimises the washing procedure accordingly. The machine adapts automatically to the prevailing circumstances: if you are washing a minimum load, the programme carries out only two rinse cycles during the cotton and synthetics programmes, while keeping the rinse results very good. You save on water, energy and time as a result.
Thanks to its
Dynamic-Sense Technology
the appliance adapts optimally to the prevailing circumstances, achieving favourable consumption figures even in the case of small loads. Water supply temperature and pressure, quantity of water and degree of loading, are the parameters taken into account. The progamme duration is influenced by these factors. This is checked and updated at particular stages of the programme. Consequently, the programme duration can vary by up to 60 minutes.
The
imbalance detection and correction system
protects your washing machine if the imbalance is too great on initiating a spin cycle. This may occur with a badly distributed load or in the case of single large laundry item. The laundry is re-distributed and the spin speed is not increased until satisfactory laundry distribution has been achieved.
If you happen to have selected the wrong programme, you can quickly change programme at any time, without needing to add new detergent. Select the desired programme and start the appliance. The new program resumes the wash programme at the same stage at which the preceding one was interrupted.
The
accurate sequence indicator
shows what stage of the programme has been reached by LED indicators coming on: after starting the programme, the programme sequence indicator moves from left to right passing through “Wash”, “Rinse”, “Spin”. Once the current stage of the programme has been completed that LED indicator goes out.
The washing process is subdivided into three phases which corresponds to the three wash LEDs:
1.
Enzyme phase
: at low temperature, organic soiling such as e.g. blood, milk and egg are
dissolved.
2.
Heating-up phase
: the water is heated up to the selected washing temperature.
3.
Washing phase
: the laundry is washed and, if the temperature is raised, whitened.
Using the
“Start Delay”
option (if present) you can select the programme start time from 1 to 19 hours in advance. You can set th e programme start ti me so th at the laundry will be complet ed by a particular time, thus allowing you to t ak e advantage of favourable lower electric it y t ari ff s a t ni gh t.
In order to soak particularly heavily soiled colourfast laundry, select the “Coloured” programme and, once the water has been fed in, press the
“Start/Pause”
button. The programme is interrupted and
you can leave the laundry to
soak
as long as you want.
You can continue the programme by pressing the
“Start/Pause”
button once again.
Depending on the washing machine type, it may be equi pped with the anti-fl ood saf ety featu re “
intelligent Water Stop system
”: Even while switched off your washing machine is able to detect
water leakage and brings this to your attention with an audible alarm.
22
WASH
Resistant cotton
Synthetics
Delicates
The figures correspond to the maximum permitted washing temperatures.
Hand-washed items
Do not wash Chlorine bleaching possible
Chlorine bleaching not possible
Dry cleanable
Not dry cleanable
DRY
Dry at normal temperature
Dry at a lower temperat ure
Do not dry in tumble dryer
IRON
Hot iron
Use medium hot iron Do not use hot iron Do not iron
LAUNDRY CARE LABELS
23
QUICK REFERENCE GUIDE GB
BEFORE USING THE APPLIANCE FOR THE FIRST TIME:
FOLLOW THE “INSTALLATION INSTRUCTIONS
”.
REMOVE THE TRANSIT BOLTS BEFORE USING THE APPLIANCE.
First wash cycle without laundry:
1.
Turn on the tap.
2.
Close the appliance door.
3.
Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.
Select a short program (see programme chart).
5.
The
“Power On”
indication shows that the machine is switched on.
6.
The pilot lamp of the
“Start/Pause”
button flashes.
Press the
“Start/Pause”
button. This initial cycle serves to eliminate any water remaining after your appliance was tested at the factory.
NORMAL DAILY USE:
1.
Turn on the tap.
2.
Sort the wash according to fabric type and colour and load the appliance.
3.
Close the door.
4.
Put in detergent and any additives required into the dispenser.
5.
Select the programme, the temperature and any special options required.
6.
The pilot lamp of the
“Start/Pause”
button flashes.
Press the
“Start/Pause”
button.
IMPORTANT: During the first 15 minutes of the “Cotton”, “Coloured cotton” and “Synthetics”
programmes the door can be opened for adding laundry (“Door Free” indicator). This is not possible if “Rapid” is selected.
24
GB CONTENTS
YOUR ELECTRONIC WASHING MACHINE
PAGE
21
LAUNDRY CARE LABELS
PAGE
22
APPLIANCE AND ACCESSORIES
PAGE
25
CHILD SAFETY
PAGE
25
PROTECTING THE ENVIRONMENT
PAGE
26
SAFETY INSTRUCTIONS
PAGE
26
TRANSPORT / HANDLING
PAGE
26
PREPARING THE WASH
PAGE
27
DETERGENT AND ADDITIVES
PAGE
28
DYEING AND BLEACHING
PAGE
29
PROGRAMME SELECTION / PROGRAMME START
PAGE
29
START DELAY
PAGE
29
DOOR LOCK / PROGRAMME END
PAGE
30
CHANGING / INTERRUPTING / CLEARING PROGRAMME
PAGE
30
REMOVING THE FILTER / DRAINING RESIDUAL WATER
PAGE
30
CARE AND MAINTENANCE
PAGE
32
TROUBLESHOOTING GUIDE
PAGE
33
AFTER-SALES SERVICE
PAGE
35
INSTALLATION INSTRUCTIONS
PAGE
35
25
1. Worktop
2. Control panel
3. Detergent dispenser
4. After-Sales Service sticker (on the back side of the door)
5. Door
6. Door handle
- To open the door press the button on the inside of the handle and pull
- Close the door by pushing it firmly (the lock will click into place)
7. Child safety (inside door)
8. Filter (behind cover)
9. Plinth
10.Residual water drain (behind the plinth)
To protect the appliance from improper use, turn the plastic screw on the interior of the do or usi ng a co in o r th e th ick rounded plastic projection on the coloured insert from the detergent dispenser.
1. Slot vertical: safety position, i.e. the door will not lock.
2. Slot horizontal: normal position, i.e. the door can be
locked again.
APPLIANCE AND ACCESSORIES
CHILD SAFETY
26
PACKING
The packing material is 100% recyclable (marked with the recycling symbol ). Adhere to local regulations when disposing of packaging material.
The packaging material (plastic bags, polystyrene parts, etc.) is potentially dangerous and must be kept out of reach of children.
PRODUCT
The appliance is made from recyclable materials and must be scrapped in accordance with local waste di spo sal regulations.
Before scrapping, cut off the po wer cable so the appliance cannot be connected to the mains.
ENVIRONMENTAL TIPS
Do not exceed the detergen t do sag es indicated in the Manufacture r’s in st ru ct ion s.
The Eco Flap - a special system in the outlet will prevent detergent loss from t he d r um t o avoid detergent loss into the environment.
Remove detergent from compartment i f yo u intend scrapping your appliance.
MAXIMIZE THE LOAD SIZE
Achieve the best use of energy, water, detergent and time by using th e recommended maximum load size.
DO YOU NEED TO PREWASH?
Use “Prewash” for heavily soiled laundry only! Save detergent, time, water and between 5 to 15% energy consumption by not sel ect in g “Prewash” for slight to normally soiled laundry.
IS A HOT WASH REQUIRED?
Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wa sh pro gram.
Save up to 50% energy by using a 60° C instead of a 90° C wash programme or a 40° C instead of a 60° C wash programme.
BEFORE USING A DRYING PROGRAMME
Save energy and time by selecting a high spin speed to reduce the water content in laundry before using a drying programme (for machines with adjustable spin s pee d).
Use the appliance only for domestic washing and for its intended applicati on .
Ensure the installation of electrical and water connections have been made in accordance with the Manufacturer’s instructio ns an d in observance of local safety regulations (refer to “Installation Instructions”).
Before cleaning or maintaining the appliance , switch it off and unplug it.
When the appliance is not in use unplug it and turn off the tap.
Do not attempt to force the door o pe n.
Do not allow children to play with the appliance or enter the drum. Do not rest any weight on the door.
Packing materials can be dangerous for children: keep all packing materials (plastic bags, polystyrene, etc.) well out of their reach.
The appliance conforms to European safety regulations, to Directive n. 93 /6 8/ EEC an d standard 93/68/EC.
1.
Unplug the appliance.
2.
Turn off the tap.
3.
Remove the water supply and drain hose.
4.
Eliminate all water from the hoses and from the appliance (see “Removing the Filter / Draining Residual Water”).
5.
Fit the transit bolts (obligatory) (see “Installation Instructions”).
PROTECTING THE ENVIRONMENT
SAFETY INSTRUCTIONS
TRANSPORT / HANDLING
Loading...
+ 12 hidden pages