BAUKNECHT NM11 844 WS IL Daily Reference Guide

Quick Guide

THANK YOU FOR PURCHASING A BAUKNECHT PRODUCT.

To receive more comprehensive assistance, register the appliance on

www.bauknecht.eu/register

CONTROL PANEL

1. EXTRA RINSE / MUTE button

2. FINAL CARE / KEY LOCK button

3. ON/OFF button

4. STEAM HYGIENE button and indicator light

5. START/PAUSE button

6. RAPID button

7. SPIN button

8. START DELAY button

9. TEMPERATURE button

10. WASH CYCLE SELECTOR KNOB

WASH CYCLE TABLE

Before using the appliance carefully read the Health and Safety guide.

Before using the machine, it is imperative that the transport bolts are removed. For more detailed instructions on how to remove them, see the Installation Guide.

1 2

DISPLAY

Maximum load 8 kg Power input in o mode 0.5 W / in left-on mode 8 W

Wash cycle

Setting Range 1 2 3

Eco 40-60 (1) 40 °C 40°C 1400 8,0

Cotton (2)

Synthetics (3)

Mixed

Delicates

White

Anti Stain 40°

Rapid 30 min

Spin & Drain *

Rinse & Spin

Steam Refresh

20°C 20 °C

Wool

Anti Allergy

Bed & Bath

 Required dosage  Optional dosage

Eco Cotton (4)

Temperature

40°C - 60°C

40°C - 40°C

40°C - 90°C

40°C - 40°C

30°C - 30°C

– –

Maximum

spin

(r.p.m.)

1400 8

1200 4,5

1400 8

1000 4,5

1400 8

1000 4,5

800 4,5

1400 8

Maximum

load

(kg)

– – –

- 20 °C

40°C - 40°C

60°C 40°C - 60°C

60°C - 60°C

60 °C 60 °C 1400 8,0

40 °C 40 °C 1400 8,0

1400 8,0

800 2

1400 5

1400 8

Duration

(h : m)

Add Gar-

ments

(



Pre-

wash

)

–

Detergents and

Additives

Wash

softener

   

 

Recommended

detergent

Fabric

Powder Liquid

–

 (***)    



–

   

–

 

–

– – – – – –

– – –



– –

– – – – – –

–



 

–

 

–

   

–

   

–

   

–

   

–



The cycle duration indicated on the display or instruction manual is an estimate based on standard conditions. The actual duration may vary in relation to several factors, such as the temperature and pressure of the incoming water, ambient temperature, amount of detergent, load quantity and type, load balancing and any additional options selected. The values given for programmes other than the Eco 40-60 programme are indicative only.

1) - Test wash cycle in compl iance with EU Ecodesign r egulation 2019/2014. The mos t ecient programm e in terms of energy an d water consumption fo r washing normally s oiled cotton laun dry.

Note: spin speed v alues shown on the disp lay can slightly dier s from the values sta ted in the table.

For all testing institutes:

2) Long cotton cycle: set wash cycle with a temperature of 40°C.

PRODUCT DESCRIPTION

1. Top

2. Detergent dispenser drawer

3. Control panel

4. Handle

5. Porthole door

6. Drain pump (behind the plinth)

7. Plinth (removable)

8. Adjustable feet (2)

3) Long synthetics cycle: set wash cycle with a temperature of 40°C.

* By selecting the cycle and excluding the spin cycle, the washing machine will drain only. ** The duration of the wash cycles can be checked on the display. *** For Prewash press the “ ” button until the symbol lights up (only 90°).

4) Eco Cotton - Test wash cycles in compliance with regulations 1061/2010. Set “ ” wash cycle at a temperature of 40°C or 60°C to access this cycles.

DETERGENT DISPENSER DRAWER

compartment 1: Pre-wash detergent (powder)

compartment 2: Detergent for the wash

cycle (powder or liquid)

If liquid detergent is used, it is recommended that the removable plastic partition A (supplied) be used for proper dosage.

If powder detergent is used, place the partition into slot B.

compartment 3: Additives (fabric softeners, etc.)

The fabric softener should not overow the

grid. ! Use powder detergent for white cotton garments, for pre-washing, and for washing at temperatures over 60°C. ! Follow the instructions given on the detergent packaging.

WASH CYCLES

END

DDEEMMO

Follow the instructions on the symbols of the garment’s wash care label. The value indicated in the symbol is the maximum recommended temperature for washing the garment.

For washing normally soiled cotton garments declared to be washable at 40 °C or 60 °C, together in the same cycle. This is the standard cotton programme and the most ecient in terms of water and energy consumption.

Cotton

Normally to heavily soiled and robust cottons .

Synthetics

Suitable for washing moderately soiled garments made of synthetic bres (e.g. polyester, polyacrylic, viscose, etc.) or mixed synthetic-cotton bres.

Mixed

For washing lightly to normally soiled resilient garments in cotton, linen, synthetic bres and mixed bres.

Delicates

For washing very delicate garments. It is advisable to turn the garments inside out before washing them. For best results, use liquid detergent on delicate garments.

White

For washing normally to heavily soiled towels, underwear, table and bed linen, etc in resilient cotton and linen. Only when the temperature is selected at 90°C the cycle is provided with a prewash phase before main washing phase. In this case it is recommended to add detergent both, in the prewash and main wash section.

Anti Stain 40°

The programme is suitable to heavily-soiled garments with resistant colours. It ensures a washing class that is higher than the standard class (A class). When running the programme, do not mix garments of dierent colours. We recommend the use of powder detergent. Pre-treatment with special additives is recommended if there are obstinate stains.

Rapid 30 min

For washing lightly soiled garments quickly. This cycle lasts only 30 minutes, saving time and energy.

Spin & Drain

Spins the load then empties the water. For resilient garments. If you exclude the spin cycle, the machine will drain only

Rinse & Spin

Rinses and then spins. For resilient garments.

Steam Refresh

The garments will be damp once the cycle is completed, so we recommend hanging them to dry (2 kg, roughly 3 items). This programme refreshes garments by removing bad odours and relaxing the bres. Insert dry items only (that are not dirty) and select programme “ Steam Refresh”. Garments will be a little damp at the end of the cycle and can be worn after a few minutes. The “ Steam Refresh” programme makes ironing easier.

For washing lightly soiled cotton garments, at a temperature of 20 °C.

Wool - Woolmark Apparel Care - Green:

The Wool wash cycle of this machine has been approved by The Woolmark Company for the washing of wool garments labelled as “hand wash” provided that the products are washed according to the instructions on the garment label and those issued by the manufacturer of this washing machine (M1127). The Woolmark logo is a Certication mark in many countries.

Anti Allergy

Suitable for removing major allergens such as pollen, mites and cat or dog hair.

Bed & Bath

For washing home linen in a single cycle. It optimises the use of fabric softener and allows for saving time and electricity. We recommend the use of powder detergent.

Eco Cotton

For washing normally soiled cotton garments. At 40°C and 60°C.

DISPLAY

The display is useful when programming the washing machine and provides plenty of information.

The duration of the available wash cycles and the remaining time of a running cycle appear in section A (the display will show the maximum duration of the cycle chosen, which may decrease after several minutes,

since the eective duration of the programme varies depending on the wash load and the settings chosen); if the DELAYED START option has been set, the countdown to the start of the selected wash cycle will appear. Pressing the corresponding button allows you to view the maximum spin speed and temperature values attained by the machine during the set wash cycle, or the values selected most recently, if these are compatible with the set wash cycle. The “wash cycle phases” corresponding to the selected wash cycle and the “wash cycle phase” of the running wash cycle appear in section B:

Main wash Rinse

Spin + Pump out

References C indicate the wash options available (See “Options” section). The “Start Delay” symbol , when lit, indicates that the set “delayed start”

value has appeared on the display. The symbol indicates the possibility of inserting an additional garments load with the washing program started (See “Adding Garments” section). The symbol indicates the possibility to silence the key tones While the mute is active, almost all sounds will be turned o. Only the sound signals and the alarms remain active, as well as the sound of the end of cycle. For activate/deactivate the mute press and hold button.

DISPLAY INDICATORS

Failure: Call Service Refer to Troubleshooting section

Failure: Water lter clogged Water cannot be drained; water lter might be blocked

Failure: No water No or not sucient inlet water.

In the event of any failure, refer to the “Troubleshooting” section.

Key Lock To lock the control panel, press and hold the “Key lock” button for approximately 3 seconds. The symbol will light up on the display to indicate that the control panel has been locked (with the exception of the “ON/OFF“ button). This prevents unintentional changes to programmes, especially with children near the machine. To unlock the control panel, press and hold the “Key lock” button for approximately 3 seconds .

Locked door indicator

When lit, the symbol indicates that the door is locked. To prevent any damage, wait until the symbol turns o before opening the door.

To open the door while a cycle is in progress, press the START/PAUSE button ; if the symbol is o, the door can be opened.

FIRSTTIME USE

Once the appliance has been installed, and before you use it for the rst time, run a wash cycle with detergent and no laundry, using the wash cycle (60 °).

DAILY USE

Prepare the laundry by following the suggestions appearing under the “TIPS AND SUGGESTIONS” section.

- Press the ON/OFF button .

- Open the door. Load the laundry while making sure not to exceed the maximum load quantity indicated in the wash cycle table.

- Pull out the detergent dispenser drawer and pour the detergent into the relevant compartments, as described in the “DETERGENT DISPENSER DRAWER” section.

- Close the door.

- The machine automatically displays the default temperature and spin speed values for the selected cycle, or the most recently used settings if they are compatible with the selected cycle.

- Select the desired wash cycle.

- Select the desired options.

- Press the START/PAUSE button to start the wash cycle; the door will lock ( symbol on).

PAUSING A CYCLE

To pause the wash cycle, press the START/PAUSE button again. To start the wash cycle from the point at which it was interrupted, press the START/PAUSE button again.

OPENING THE DOOR, IF NECESSARY

Once a cycle starts, the symbol turns on to signal that the door cannot be opened. While a wash cycle is running, the door remains locked. To open the door while a cycle is under way, for example, to add or remove garments, press the START/PAUSE button to pause the cycle. If the symbol is not lit, the door may be opened. Press the START/PAUSE button again to continue the cycle.

ADDING GARMENTS

An icon on the display will signal when additional garments can be introduced into the washing machine, without decreasing the washing performance. To add garments, rst stop the washing machine by pressing the START/PAUSE button then open the door and insert them. Press the START/PAUSE button again to restart the wash cycle from the point at which it was interrupted.

+ 2 hidden pages