Bauknecht GSI 5043 W-IN, GSI 5043 W-AL, GSI 5043 W-BR Quick Reference Guide

GSI 5043

Quick Reference Guide

Further indications are given in the pages to follow and in the user instructions.

Start button

Indicator lamp lit while the dishwasher is operating. Flashes when a fault occurs. Switches off at the end of the programme.

Programme Symbol

and Temperature

Pre-wash

Rapid 40° C

Bio Normal 50° C

Intensive 70° C

1) Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15° C - as well as water hardness and power supply voltage, etc.

2) Programme recommended when using detergents of type B (enzyme-based detergents). Reference programme for energy label.

3) Programme recommended when using detergents of type A (non enzyme-based detergents).

Crockery to be washed later.

Lightly soiled crockery with no dried-on food.

Normally or heavily soiled crockery with dried-on food.

Heavily soiled pans and saucepans.

Programme selection and

recommended load type

Salt level indicator

Add regeneration salt; only add regeneration salt immediately before starting a wash programme.

Rinse aid level indicator

Add rinse aid.

Programme selector

On/Off button

Place the detergent in the:

small

compartment

--5.00.029

- X 13.0 0.85 30

X X 16.0 1.24 133

X X 21.0 1.90 110

large

compartment

Water

(Litres)

Consumption

Normal load

Energy

(kWh)

Time

(Min.)

5019 100 90369

(We reserve the right to make technical modifications)

How to use the dishwasher

1. After loading the dishwasher, close the door properly and open the water supply tap.

2. Press the On/Off button to switch the dishwasher on.

indicator lamps will switch on.

3. Turn the selector knob to select the desired programme.

corresponding indicator lamp lights

If required, select options (if

up.

supplied).

4. Press the Start button to start the selected programme.

indicator lamp will light up.

the programmed data cannot be altered by turning the programme selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the last programme selected. This information remains in the memory even during interruption of the power supply.

To change the programme selected, press the Start button for about 5 seconds,

lamp switches off.

programme and press the Start button.

if the dishwasher is switched off

Note:

during a wash programme, when switched on again it will resume the wash cycle from where it was interrupted.

Only open the dishwasher door if strictly necessary during a wash cycle and exercise maximum caution. Danger of scalding f rom steam.

5. To indicate the end of the programme, the Start indicator lamp switches off and the lights up

One of the programme

The

The Start

Once set,

until the Start indicator

End indicator lamp (if fitted)

(for about 30 min.)

Select a new

6. Once the Start indicator lamp has switched off press the On/Off button to switch the dishwasher off.

indicator lamps switch off.

7. Open the door (warning: beware of hot steam). Unload the lower rack before the upper one. Close the water tap.

All the

Upper and lower rack

Upper rack

Crockery holders:

• Down: cups and long-stemmed glasses.

•

Up: plates.

Glass holder:

Lower rack

Cutlery basket:

• The cutlery basket can be removed to increase (C) available space.

• Some models are provided with a grid (D) that can be fitted onto the cutlery basket.

Please read the user instructions carefully.

+ 2 hidden pages