Baby Jogger Q-SERIES DOUBLE User Manual

Important, Keep for
Future Reference

Assembly

Instructions

Amazing Quick Folding System (Patented)

Q-Series Double

2

• Important, keep this booklet for future reference.

• Accessories which are not approved by the manufacturer or distributor
should not be used.

• WARNING: Prevent serious injury to your child by always using the
safety harness.

• WARNING: Any load attached to the handle affects the stability of the stroller.

• WARNING: It may be dangerous to leave child unattended.

• Always use your wrist strap – these strollers can really roll, and the
wrist strap gives you control if you should slip or fall down.

• The passenger should remain seated (no standing in the stroller).

• Watch out for cars – never assume that a driver can see you and your child.

• Never use Roller Blades while using a Baby Jogger Stroller.

• Intended for passengers up to five years of age weighing no more
than 100 pounds.

• This Jogger seats two passengers.

• WARNING: Recommended weight for seat pocket is 2 pounds and basket
is 10 pounds. Excessive weight may cause a hazardous unstable
condition to exist.

• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer.

For the sake of your precious cargo, please read
these warnings before using your Baby Jogger.

With a simple lift of the straps, Baby Jogger’s new Q-Series strollers fold in half, which makes
transporting them easier than ever before. Combine that technology with our reputation for
quality and durability and you have the world’s best lineup of high performance strollers.

Frame

Baby Jogger Introduces The

World’s Easiest Folding System!

Simple

Lift & Fold

Yellow

Safety

Straps

Must Be

Released

Before

Folding

1

2

Frame

• To assemble, simply unfold frame as shown.

12

34

1 To install front wheel,

lay stroller back so handle
is resting on floor. Open
the caliper by flipping
the caliper lever toward
the rear wheels.

2 Insert the front wheel

into the fork tips by
aligning the axle flats
with the fork tip flats.

3 Tighten by turning the

wheel lever and holding
the opposite side.

4 Close the wheel lever

making sure that it is
facing toward the back
of the stroller.

5 Close caliper by flipping

the caliper lever toward
the fork tips.

Front Wheel

Caliper Lever

Wheel
Lever

3

4

• To install, gently slide the
wheel’s rear axle into the hole
in the axle end until you hear it
click into place.

• To remove, simply push in
the spring lock while pulling
out the wheel.

Rear Wheels

5

• If you don’t have good braking
action, simply squeeze the brake
handle five or six times. If the
problem persists, loosen the
brake’s cylinder ring to adjust the
small ring, and then move the
small ring away from the handle
to tighten the cable. (Please do
not over tighten!) To lock the
rings, tighten the cylinder ring
against the handle while holding
the small ring in place.

Hand Brake with
Parking Button

• To use the parking button feature, simply squeeze
the brake handle and push the park brake button.

Brakes

Small Ring

Cylinder
Ring

JOGGER IS PACKAGED

WITH THE HAND BRAKE

ASSEMBLY LOOSE.

TIGHTENING IS NECESSARY

FOR SAFE OPERATION!

• Rotate hand brake assembly upward to a comfortable
position then tighten bolt (clockwise) on the hand
brake assembly with supplied allen wrench as shown.

Adjusting the Brake

Rear Wheel
Parking
Brake

• Simply push brake
pedal down to
engage brake and
lift up to release.

Brake Pedal

Parking
Button

6

Adjusting
safety harness:

1 Loosen the shoulder straps from their

plastic guides.

2 Slide the end of each strap through pair of

seat loops closest to your child’s shoulder.

3 Slide the end of the shoulder strap back

into plastic guide.Please note: If you feel
the straps are too tight, you may adjust
their length by sliding the plastic guides
toward the top of the seat.

4 Lock both sides of the strap mechanism

into the center buckle. To adjust the center
strap, move its plastic guide up or down.

Safety Harness

WARNING: Avoid serious injury from falling or sliding out.
Always use safety harness!

7

1 Simply adjust seat

straps to desired
degree of recline.

2 Pull on strap when you

want to return the seat
to its upright position.

3 Rear flap serves as sun

canopy when seat is in
reclined position.

Reclining Seat

4 Jogger is packaged with seat support board and can be easily removed

or inserted into the seat back if additional support is desired.

Be sure to remove the board from the back of the seat before washing.

8

Seat

1 Snap seat to frame. 2 Attach bottom part of seat

to footplate with the Velcro.

3 Wrap bottom straps around

frame, thread strap through
D-ring and secure.

5 Attach seat anchor straps

to rear frame uprights.

6 Snap safety strap to frame.

4 Snap center seat anchor

straps to each other.

9

NOTE: Some Joggers are shipped with the

Canopy, Seat and Basket pre-assembled. Assembly
instructions are given if any pre-assemble items
are removed for cleaning or replacement.

ALWAYS BE SURE
THE YELLOW SAFETY
STRAP IS SECURELY
SNAPPED ONTO THE
FRAME BEFORE
USING JOGGER!

7 Thread folding strap through openings in seat.

8 Attach folding

strap to folding
trigger and
secure the
triangle shaped
fastener.

10

1 Snap front basket straps to frame tube.

Basket

2 Wrap rear basket straps around upright

and snap back to itself.

Note: The rear of basket has the mesh material and the front doesn’t.

4 Now secure center of sun

canopy around center bar
on Jogger frame.

3 At the top corners of the sun canopy there should be two

Velcro straps, snap the canopy strap to the frame and
Velcro it back to itself.

2 Thread the center support of the

sun canopy through the seat’s
center hole and secure to the frame
using a phillips head screwdriver.
Secure side brackets to mounting
holes on side of frame.

1 Unsnap and lower the top section

of seats to reveal the mounting
holes for the sun canopy brackets.

Canopy

You will need a friend to help
attach the sun canopy and a
phillips head screwdriver.

11

Center Hole

Mounting

Holes

12

Steering

• Steering your stroller is simple: it’s balanced to
turn with just a light touch on the handlebar.
For tighter turns, push down on the handlebar and
raise the front wheel to steer.

Wrist Strap

• Make sure wrist strap is around your wrist whenever
your baby is in the stroller. The Baby Jogger is lightweight
and ready to roll – with or without you – and the wrist strap
helps you gain control over your stroller.

In the Dark

• Since we are concerned about the safety of you and your
baby, we recommend that you not use your stroller at
night. However, if you choose to, please attach
reflective strips to the wheel spokes and the seat.
Bicycle lights can also be mounted on the handlebar.

In Motion

13

Washing

• You can machine wash your stroller’s seat in cold water with a mild detergent.
To minimize shrinkage, simply reattach the seat to the frame to dry.
(Please do not put the seat in the dryer!)

• Be sure to remove the board from the back of the seat
before washing.

• You may clean the stroller frame using a soft, dry cloth, and an
occasional spray of household wax will maintain its healthy glow.

Wheel Care

• Moisture – especially from the beach – can rust the wheel bearing case.

Spraying regularly with a silicone lubricant will keep your wheels looking healthy.

• Also, if you jog massive amounts of miles, your stroller will benefit from
a yearly visit to the bike shop for wheel alignment. Refer to the number

on the tire wall for the optimum pressure for your tires.

Storing

• Sunshine can fade seat fabric and dry out tires, so storing your
stroller indoors will prolong its good looks. However, if you do
store it outside, using a tarp will protect against weather wear.

Stroller Care

We wish you many happy journeys with your new

Baby Jogger! Your stroller is a great product, and

we are proud to manufacture it. If you have any

questions or comments, please give us a call at.

BJC QD 11.19.04 (R1–12/04)

1.800.241.1848

Baby Jogger is a Division of Dynamic Brands

2042 Westmoreland Street • Richmond, VA 23230

T: 800.241.1848 • F: 804.262.6277

www.babyjogger.com

Thank You!