Page 1
Important, Keep for
Future Reference
Assembly
Instructions
The Ultimate High Performance Double Jogging Stroller
Performance Double
Performance Double (Assem) 12/16/04 4:08 PM Page 1
Page 2
2 1
• To assemble, simply unfold frame and insert the front of handle assembly into Base Bracket
and lock together, securing with Snap Locks.
Frame
1
2
3
Snap
Locks
4
• Important, keep this booklet for future reference.
• Accessories which are not approved by the manufacturer or distributor
should not be used.
• WARNING: Prevent serious injury to your child by always using the
safety harness.
• WARNING: Any load attached to the handle affects the stability of the stroller.
• WARNING: It may be dangerous to leave child unattended.
• Always use your wrist strap – these strollers can really roll, and the
wrist strap gives you control if you should slip or fall down.
• The passenger should remain seated (no standing in the stroller).
• Watch out for cars – never assume that a driver can see you and your child.
• Never use Roller Blades while using a Baby Jogger Stroller.
• Intended for passengers up to five years of age weighing no more
than 150 pounds.
• This Jogger seats two passengers.
• WARNING: Recommended weight for seat pocket is 2 pounds and basket
is 10 pounds. Excessive weight may cause a hazardous unstable
condition to exist.
• It may be unsafe to use replacement parts other than those supplied or
approved by the manufacturer.
For the sake of your precious cargo, please read
these warnings before using your Baby Jogger.
Performance Double (Assem) 12/16/04 4:08 PM Page 2
Page 3
2 3
Frame
• Slide side braces located under seat into Jawslides by pulling up on Camlock and securing
into place.
REMOVE ALL PROTECTIVE CAPS FROM WHEELS AND
THE PLASTIC FORKTIP PROTECTOR PRIOR TO ASSEMBLY
Jawslide
Camlock
3 Velcro canopy straps to
back of sun canopy.
2 Snap canopy strap to frame
on each side.
1 Thread the center canopy connection through the seat to secure to the frame
using a phillips head screwdriver, attach canopy to frame on all three
connections.(Assistance may be helpful to hold in position while attaching screws)
Canopy
4 Secure center sun canopy
velcro strap around the
center bar of jogger frame.
Forktips
Plastic Protector
Performance Double (Assem) 12/16/04 4:08 PM Page 2
Page 4
4 5
• To install, gently slide the
wheel’s axle into the hole
in the axle end until you
hear it click into place.
• To remove, simply push in
the spring lock while
pulling out the wheel.
Rear Wheels
1 To install front wheel, lay
stroller back so handle is
resting on floor. Open the
calipers by flipping the
caliper lever toward the
rear wheels.
2 Insert the front wheel into
the fork tips by aligning
the axle flats with the
fork tip flats.
3 Tighten by turning the
wheel lever while holding
the opposite side.
4 Close the wheel lever
making sure that it is
facing toward the back
of the stroller.
5 Close caliper by flipping
the caliper lever toward
the fork tips.
Front Wheel
Caliper
Lever
Wheel
Lever
Spring
Lock
Spring
Lock
Performance Double (Assem) 12/16/04 4:08 PM Page 4
Page 5
6 7
Adjusting safety harness:
• Loosen the shoulder straps from their plastic guides.
• Slide the end of each strap through pair of seat loops closest to your child’s shoulder.
Safety Harness
• Slide the end of the shoulder strap back into plastic guide.
Please note: If you feel the straps are too tight, you may adjust their length by sliding the
plastic guides toward the top of the seat.
• Lock both sides of the strap mechanism into the center buckle. To adjust the center strap,
move its plastic guide up or down.
WARNING: Avoid serious injury from falling or sliding out.
Always use safety harness!
Performance Double (Assem) 12/16/04 4:08 PM Page 6
Page 6
8 9
• If you don’t have good braking
action, simply squeeze the brake
handle five or six times. If the
problem persists, loosen the
brake’s cylinder ring to adjust the
small ring, and then move the
small ring away from the handle
to tighten the cable. (Please do
not over tighten!) To lock the
rings, tighten the cylinder ring
against the handle while holding
the small ring in place.
Hand Brake with
Parking Button
• To use the parking button feature, simply squeeze
the brake handle and push the park brake button.
Brakes
Small Ring
Cylinder
Ring
JOGGER IS PACKAGED
WITH THE HAND BRAKE
ASSEMBLY LOOSE.
TIGHTENING IS NECESSARY
FOR SAFE OPERATION!
• Rotate hand brake assembly upward to a comfortable
position then tighten bolt (clockwise) on the hand
brake assembly with supplied allen wrench as shown.
Adjusting the Brake
Rear Wheel
Parking
Brakes
• Simply push brake
pedal down to
engage brake and
lift up to release.
Brake Pedal
Parking
Button
1 Snap seat to frame.
2 Attach bottom part of seat
to footplate with the velcro.
3 Wrap bottom straps around
frame, thread strap through
D-ring and secure.
4 Snap center anchor strap. 5 Attach seat anchor straps
to rear frame uprights.
Seat
NOTE: Some Joggers are shipped
with the Canopy, Seat and Basket
pre-assembled. Assembly
instructions are given if any
pre-assemble items are removed
for cleaning or replacement.
Performance Double (Assem) 12/16/04 4:08 PM Page 8
Page 7
1110
1 Snap front basket straps to seat’s
bottom straps.
Basket
2 Snap the rear snap strap around upright.
1 Simply adjust seat straps
to desired degree of
recline.
2 Pull on strap when you
want to return the seat
to its upright position.
3 Rear flap serves as sun
canopy when seat is in
reclined position.
Reclining Seat
4 Jogger is packaged with seat support board and can be easily removed
or inserted into the seat back if additional support is desired.
Be sure to remove the board from the back of the seat before washing.
Note: The rear of basket has the mesh material and the front doesn’t.
Performance Double (Assem) 12/16/04 4:08 PM Page 10
Page 8
12 13
Washing
• You can machine wash your stroller’s seat in cold water with a mild detergent.
To minimize shrinkage, simply reattach the seat to the frame to dry.
(Please do not put the seat in the dryer!)
• Be sure to remove the board from the back of the seat
before washing.
• You may clean the stroller frame using a soft, dry cloth, and an
occasional spray of household wax will maintain its healthy glow.
Wheel Care
• Moisture – especially from the beach – can rust the wheel bearing case.
Spraying regularly with a silicone lubricant will keep your wheels looking healthy.
• Also, if you jog massive amounts of miles, your stroller will benefit from
a yearly visit to the bike shop for wheel alignment. Refer to the number
on the tire wall for the optimum pressure for your tires.
Storing
• Sunshine can fade seat fabric and dry out tires, so storing your
stroller indoors will prolong its good looks. However, if you do
store it outside, using a tarp will protect against weather wear.
Stroller Care
Steering
• Steering your stroller is simple: it’s balanced to
turn with just a light touch on the handlebar.
For tighter turns, push down on the handlebar
and raise the front wheel to steer.
Wrist Strap
• Make sure wrist strap is around your wrist whenever
your baby is in the stroller. The Baby Jogger is lightweight
and ready to roll – with or without you – and the wrist strap
helps you gain control over your stroller.
In the Dark
• Since we are concerned about the safety of you and your
baby, we recommend that you not use your stroller at
night. However, if you choose to, please attach
reflective strips to the wheel spokes and the seat.
Bicycle lights can also be mounted on the handlebar.
In Motion
Performance Double (Assem) 12/16/04 4:08 PM Page 12
Page 9
We wish you many happy journeys with your new
Baby Jogger! Your stroller is a great product, and
we are proud to manufacture it. If you have any
questions or comments, please give us a call at.
1.800.241.1848
Baby Jogger is a Division of Dynamic Brands
2042 Westmoreland Street • Richmond, VA 23230
T: 800.241.1848 • F: 804.262.6277
www.babyjogger.com
Thank You!
BJC P/SD 08.10.04 (R1–12/04)
Performance Double (Assem) 12/16/04 4:08 PM Page 14
Loading...