Avery 6035 Operator Handbook
CONVERTING TO THE MONARCH®
6035™ PRINTER
The Monarch® DOS-based Pathfinder® Ultra® 6035 printer is very similar
to the 6030™ printer you are used to. There are a few differences, but
you should find it very easy to start using this new printer, based on your
experience with the 6030 printer. These instructions describe the
differences.
Getting Started
Before starting, review the 6035 printer’s Equipment Manual to learn
about any differences between it and the 6030 printer.
Refer to these topics in particular when reviewing the manual:
♦ “Charging the Backup Battery”
♦ “About the Display”
♦ “About the Keypad”
♦ “About Data Entry Modes”
♦ “Loading Supplies”
TC6035ADKOH Rev. AA 3/01 ©2001 Monarch Marking Systems, Inc. All rights reserved.
Using New Keys
Because the two printers have some different keys, you must use new
keys to perform the same functions.
Use this key on this printer…
To… 6030 6035
Load supplies l f, then 0 (outside
of an application).
The function keys A - F f, then 1 - 6
Clear data from the
display
c g
Scroll through menus
< and > = and *
Loading Supplies
The loading supplies procedure described in the 6035 Equipment Manual
is only part of the loading procedure. Following is the complete
procedure. You cannot run an application while doing it.
1. Press f, then 0. You will see:
Trigger to feed
ESC to Calibrate
2. Load the supplies as described in the 6035 Equipment Manual.
3. Press the trigger to feed some supplies.
2 Converting to the Monarch 6035 Printer
Loading...