AVer H300, H100 Installation Manual

formerly
AVerMedia In formation

AVer H300/H100 Installation Guide

Thank you for choosing AVer video conferencing solutions. This hardware installation guide serves as a reference for making the connections
needed to get your new system up and running as quickly as possible.

1. Before making the connections

Make sure all devices are powered o. Follow the illustrated connection diagrams below and also refer to the user
manual of the device you are connecting to the video conferencing system.

2. Connecting a VGA Display Device (Recommended Connection Method)

Connect the VGA input port of the display device to either VGA OUT 1 (main system) or VGA OUT 2 (Table Hub). Both
VGA OUT 1 and VGA OUT 2 can be used at the same time. Shared data and captured images will be displayed thru VGA
OUT 2 when implementing dual display mode.

3. Connecting a TV Display Device (Alternate Method)

1

Locate the S-VIDEO, VIDEO, or SCART RGB input of the TV/LCD monitor and connect it to AVer H300/H100 using the
appropriate cable.

• Make sure the NTSC/PAL switch is set to the proper TV format.

• For better video quality, we recommend using the S-VIDEO connection if available.

4. Connecting the Camera and Main System

Locate the CAMERA port on the camera and connect it to the CAMERA port of the main system.

• The included 26 Pin-D Sub cable (DB26 female/female) is 5 ft long

5. Connecting the Table Hub and Main System

Connect the HUB I/O port of the table hub to the HUB I/O port of the main system using the included D-Sub cable.

• The included 26 Pin-D Sub cable (DB26 male/male) is 15 ft long

2