AutoPage RF-315, RF-520, RS-655, RS-620, RS-725 Instruction

Models:
RF-315 / RF-520 / RS-615 / RS-620 / RS-655 / RS-720 / RS-725 / RS-855 / RS-860

In the event, you should need to add or replace a Remote Control Transmitter, it is important that
you follow the instructions below.

TRANSMITTER PROGRAMMING

Note: This mode will only retain the last 4 remote transmitters programmed. If the

transmitter memory is exceeded, the security system will start deleting transmitters from
memory in chronological order.

1. Turn the Ignition 'switch ‘OFF/ON’ 3 TIMES and stay in ON position.
“Within 15 seconds”.

2. Push the Valet switch 2 times and holding in on 2nd push until a long chirp is heard

then release the valet switch. You are now in the Transmitter programming mode.

3. Press and hold any button of the transmitter until the siren responds with a confirming

chirp, indicating the signal has been stored into memory.

4. If you have additional transmitters (up to 4) that need to be programmed, repeat step

3 for each transmitter.

Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. 3 long chirps & 3 parking

light flashes will confirm exit.