THIS PRODUCT IS DESIGNED FOR PROFESIONAL INSTALLATION ONLY
RS-660
PROFESSIONAL REMOTE CAR STARTER
&
3 CHANNEL SECURITY SYSTEM
OPERATIONS MANUAL
1
SYSTEM OPERATIONS:
WARNINGS:
As with any product that performs automatic functions, there are certain safety
precautions that you must
practice and be aware of.
1. Keep the transmitter out of children’s reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. The vehicle windows must be rolled up.
7. Should the unit malfunction, disconnect the fuse until the problem is
corrected.
8. The use and operations of this system is the sole responsibility of the
operator.
9. Some areas may have local ordinances that prohibit leaving a vehicle running
on public streets.
10.Do not start the vehicle by remote while the standard transmission vehicle is
parked at a steep place.
Transmitter
Button
System Function Remark
-
+
-
-
+
II
Lock Doors & Arm System
Panic function Press and Hold for 3 seconds
Car Locator Under armed mode
Arm and Delete The 2 Stage Shock
Sensor
Silent Arming / Disarming Ignition in "off" position.
Unlock Doors & Disarm System
Two Steps Door Unlock & Disarm
System
Trunk Release (Channel 2) Press and Hold for 2 seconds
Passive Arming By-pass While the system Disarmed.
Activate or Turn Off The Remote
Start
Channel # 3 Auxiliary Output Press both buttons together
Switching code For 2nd Car
Operation.
2
Press twice within 3 seconds
Press twice within 3 seconds.
For regular remote transmitter Only
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT-33: This transmitter uses two (2) 3-volt lithium ion batteries
(#CR2016) that are sandwiched together with the (+) side facing upward.
To replace the battery, you will need to use a small flat blade screwdriver.
Locate the small notch on the lower right side of the transmitter case next
to the key ring. Using the flat blade screwdriver, carefully pry the top
case from the bottom case. It should snap apart after breaking the seal.
Before removing the batteries note the direction of the positive (+)
terminal. Place the new batteries in exactly the same manner, being
careful not to bend or damage the contact terminal. Snap the cases
back together and then test the transmitter to insure it arms and disarms
the alarm.
(2) CR2016
3-Volt Batteries
ACTIVE LOCK & ARM:
1. Press button on the transmitter.
2. The siren will chirp once and parking lights will flash once indicating
that the system is now armed. The vehicle doors will lock upon arming
when interfaced with the keyless entry system.
SILENT ARMING / DISARMING: Pressing the + buttons
together on the transmitter will arm or disarm your system, No chirp
sound will be heard, arm / disarm confirmation will be through the
vehicles parking lights only.
DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then
you have left a door, trunk, or hood lid ajar.
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS:
Press the button once: The siren chirps once, The system is armed.
Press the button a second time within 5 seconds: The siren chirps
twice, the Shock Sensor is now bypassed. The sensor bypass feature is
programmed to activate for one arming cycle only. The security system
3
will return to normal operation during the next arming cycle.
B. PASSIVE ARMING
Active arming / disarming is controlling your security system via the
remote transmitter. This security system is equipped with an optional
Passive Arming feature, which allows the security system to arm 30
seconds after the last door is closed. Operation is as follows:
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast
for 30 seconds. If you re-open any door / hood / trunk, the security
system LED will stop flashing. It will begin flashing again once the
vehicle all entrances are closed.
After 30-second timer has elapsed, the security system will automatically
“ARM”. The siren will chirp [1] time and the parking lights will flash [1]
time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING
The vehicle doors will automatically lock after passive arming cycle has
been completed. Please refer to your installing dealer to activate this
feature.
PASSIVE ARMING BY-PASS: While the LED is fast flashing for passive
arming or Automatic re-arm, Press the buttons twice, the security will
respond with [1] chirp and LED will turn “ON”. The security system will
remain in this temporary state for as long as you wish.
To exit passive by-pass, press the or button and the system will
return to normal status.
ACTIVE UNLOCK & DISARMING:
1. Press button on the transmitter.
2. The siren will chirp twice and parking light will flash twice to indicating
that the security system is now disarmed. The vehicle doors will
unlock and dome lights will turn on for 30 seconds.
TAMPER DISARMING: If the alarm was triggered in your absence, upon
disarming the system, the siren will chirp 4 times, the parking lights will
flash 3 times.
PATHWAY ILLUMINATION
This feature turns the parking light “ON” for 30 seconds upon a unlock
signal and for 10 seconds upon the lock signal.
TWO STEPS DOOR UNLOCK: This feature will independently unlock
the driver door only when deactivating the system. Pushing the
button a second time within 3 seconds will unlock the entire vehicle.
Please refer to your installing dealer to install and activate this feature.
4