Auto Page RS-650 User Manual
RS-650
PROFESSIONAL REMOTE CAR STARTER
&
2 CHANNEL ALARM SYSTEM
OPERATIONS MANUAL
THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY
SYSTEM OPERATIONS
A. 5-BUTTON TRANSMITTER OPERATION
Transmitter
Button
-
-
+
-
A. ACTIVE LOCK & ARM:
System Function Remark
Lock Doors & Arm System
Arm and Delete The Shock Sensor Pres s twic e within 5
Car locator System Armed
Panic function Press and Hold for 3
Unlock Doors & Disarm System
Two Steps Door Unlock & Dis arm
System
Silent Arming / Disarming
Channel 2 (Trunk) Timer Control Press and Hold for 2
Passive Arming By-Pass While the System Stay in
Activate Remote Start or Press and Hold for 1
Turn Off The Remote Start
Switching code For 2nd
Operation or Garage Door Opener
seconds.
seconds
Pres s twice within 3
seconds.
seconds
Passive Arming Or ReArming.
seconds
Car
1. Press button on the transmitter.
2. The horn will chirp once and parking light will flash once indicating that
the system is now armed. The vehicle doors will lock upon arming when
interfaced with the security system.
SILENT ARMING / DISARMING: Press the + button on the
transmitter will arm or disarm your security system, No chirp sound will
be heard, arm / disarm confirmation will be through the vehicles parking
lights only.
DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then
you have left a door, trunk, or hood lid ajar. (See Alarm Feature “I - 4
Programming)
SHOCK SENSOR / OPTIONAL SENSOR BY-PASS:
Press the button once: The siren chirps once, The system is armed.
Press the button a second time within 5 seconds: The siren chirps
twice, the Shock Sensor is now bypassed.
The sensor bypass feature is programmed to activate for one arming
cycle only. The security system will return to normal operation during
the next arming cycle.
B. PASSIVE ARMING
Active arming / disarming is controlling your security system via the
remote transmitter. This security system is equipped with an optional
Passive Arming feature, which allows the security system to arm 30
seconds after the last door is closed. Operation is as follows:
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast
for 30 seconds. If you re-open any door / hood / trunk, the security
system LED will stop flashing. It will begin flashing again once the
vehicle all entrances are closed.
After 30-second timer has elapsed, the security system will automatically
“ARM”. The siren will chirp [1] time and the parking lights will flash [1]
time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING
(See Alarm Feature “I
The vehicle doors will automatically lock after passive arming cycle
has been completed.
PASSIVE ARMING BY-PASS: While the LED is fast flashing for passive
arming or Automatic re-arm, Press the buttons twice, the security
will respond with [1] chirp and LED will turn “ON”. The security system
will remain in this temporary state for as long as you wish.
To exit passive by-pass, press the or button and the system will
return to normal status.
- 2” Programming):
C. ACTIVE UNLOCK & DISARM:
1. Press button on the transmitter.
2. The horn will chirp twice and parking light will flash twice to indicating
that the security system is now disarmed. The vehicle doors will unlock and dome light wills turns on for 30 seconds upon disarming when
interfaced with the security system.
TAMPER DISARMING: If the alarm was triggered in your absence, upon
disarming the system, the siren will chirp 4 times, the parking lights will
flash 3 times.
PATHWAY ILLUMINATION (See Alarm Feature “II - 4” Programming):
This feature turns the parking lights “ON” for 30 seconds upon a unlock
signal and for 10 seconds upon the lock signal.
TWO STEP DOOR UNLOCK (See Alarm Feature “III - 3”
Programming):This feature will independently unlock the driver’s door
only when disarming the security system. Pushing the button a second time within 3 seconds will unlock the entire vehicle.
AUTOMATIC RE-ARM (See Alarm Feature “I - 3” Programming):
If this feature is selected, the security system will automatically re-arm
itself 60 seconds after disarming with remote transmitter. Automatic rearm will cancel if any door is opened before the 60 seconds timer has
elapsed.
D. DISARMING WITHOUT A TRANSMITTER
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to ‘ON’ position.
2. Within 10 seconds push and release the valet switch
The alarm will enter the disarm mode. You can now start and operate
the vehicle normally.
E. VALET MODE: (System in Disarm or Valet mode)
The valet switch allows you to temporarily bypass all alarm functions,
eliminating the need to hand your transmitter to parking attendants or
garage mechanics. When the system is in valet mode, all alarm functions
and remote start functions are bypassed, however the remote panic feature and remote door locks will remain operational. To use the valet mode,
the system must first be disarmed either by using your remote transmitter, or by operating the Manual override sequence.
Enter Valet Mode:
1. From the disarmed condition, turn the ignition to “ON” position.
2. Push and hold valet switch for 2 seconds until the LED turns on. The
LED will remain on as long as the system is in ‘valet mode’.
Exit Valet Mode:
1. Return to normal operation, turn ignition ‘on’.
Push and hold valet switch for 2 seconds, The LED will turns off
indicating the system has exited the valet mode.
F. PANIC FUNCTION:
The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.
1. Press and hold the button for 3 second. The alarm will immediately
sound.
2. During panic mode, the normal function of this transmitter button will
be suspended. The and buttons can be used to lock and unlock the doors (if the option is installed), however once the button is
pressed, the vehicle’s starter disable device, (where installed) will be
enable allowing the vehicle to start.
3. To stop the alarm, press and hold the or button on the
transmitter again for 3 seconds. Also if any transmitter button other
than the or button is pressed and released, the panic mode
will be turned off immediately.
4. If no buttons are pressed, the alarm will automatically stop after
60 seconds.
Loading...