AutoPage RS-610, RS-650, RS-610 Plus, RS-650 Plus Instruction
Models: RS-610 / RS-650 / RS-610 Plus / RS-650 Plus
In the event, you should need to add or replace a Remote Control Transmitter, it is important that
you follow the instructions below.
Note: If more than 4 transmitters programmed, the system only kept the last 4
transmitters.
PROGRAMMING THE REMOTE TRANSMITTER
Enter:
1. Turn the Ignition 'switch ‘OFF/ON’ 3 TIMES and stay in ON position. Within 15
seconds.
2. Push the Valet switch 3 times. A long chirp to confirm enters. You are now in the
Transmitter programming mode.
Program:
1. Press button on one of the transmitter until the siren responds with a confirming chirp
the first transmitter is now programmed.
2. Press button on the second transmitter until the siren responds with a confirming
chirp, the second transmitter is now programmed.
3. Apply the same procedure to program 3rd and 4th
Exit: Turn Ignition to 'OFF' position, or leave it for 15 seconds. A 3 long chirps & 3
parking light flashes to confirm exit.
TRANSMITTER PROGRAMMING
.
Loading...