Autopage RS-601 Operation Manual

1

RS-601

PROFESSIONAL REMOTE CAR STARTER

With REMOTE ENTRY OPERATION

OPERATIONS MANUAL

Please register your product at

www.autopageusa.com

THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY

2

SYSTEM OPERATIONS:

WARNINGS:

As with any product that performs automatic functions, there are certain safety
precautions that you must practice and be aware of.

1. Keep the transmitter out of children’s reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it’s in an enclosed area or garage.

5. Always apply the parking brake and lock the vehicle as you exit the vehicle.

6. The vehicle windows must be rolled up.

7. Should the unit malfunction, disconnect the fuse until the problem is
corrected.

8. The use and operations of this system is the sole responsibility of the
operator.

9. Some areas may have local ordinances that prohibit leaving a vehicle
running on public streets.

10. THIS DEVISE CANNOT BE USED IN ANY STANDARD TRANSMISSION
VEHICLE. FOR AUTOMATIC TRANSMISSIONS ONLY!

Standard XT-12 Mini One Button remote

XT-12

Transmitter

Button

System Function Remark

x2

Activate or Turn Off The Remote
Start

Push twice to start and stop

Unlock Doors Remote Entry

+

Trunk Release

Push and hold together for 3
seconds

3

CHANGING THE BATTERY IN YOUR TRANSMITTERS XT-12:

The XT -12 transmitter uses two (2) 3-volt lithium ion batteries (#CR2016)
that are sandwiched together with the (+) side facing upward. To replace
the battery, you will need to use a small flat blade screwdriver. Locate the
small notch on the lower right side of the transmitter case next to the key
ring. Using the flat blade screwdriver, carefully pry the top case from the
bottom case. It should snap apart after breaking the seal. Before
removing the batteries note the direction of the positive (+) terminal.
Place the new batteries in exactly the same manner, being careful not to
bend or damage the contact terminal. Snap the cases back together and
then test the transmitter to insure it operates the system.

Your RS601 remote car starter comes with a 2 XT-12 remote transmitters
with only two buttons. These remotes will be used in applications, where
the factory keyless entry system is the main source for arming/locking and
disarming/unlocking the vehicle. For example, vehicles with the factory
smart key/ “push button” start or one-piece remote with key, it is
recommended that the main sole purpose for this transmitter to be used for
remote starting the vehicle and remote entry when started by the RS -601.