AutoPage RS-600 Operation Manual

THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY

RS-600

PROFESSIONAL REMOTE CAR STARTER

KEYLESS ENTRY SYSTEM

OPERATIONS MANUAL

Please register your product at

www.autopageusa.com

SYSTEM OPERATIONS:

WARNINGS:

As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of.

1. Keep the transmitter out of children’s reach.

2. Do not leave anyone in the vehicle while running on remote control.

3. Alert servicing personnel that the vehicle can be started automatically.

4. Do not start the vehicle by remote while it’s in an enclosed area or garage.

5. Always apply the parking brake and lock the vehicle as you exit the vehicle.

6. The vehicle windows must be rolled up.

7. Should the unit malfunction, disconnect the fuse until the problem is corrected.

8. The use and operations of this system is the sole responsibility of the operator.

9. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.

10. THIS DEVISE CANNOT BE USED IN ANY STANDARD TRANSMISSION VEHICLE. FOR AUTOMATIC TRANSMISSIONS ONLY!

Standard XT-33, 5 Button remote

XT-33

Transmitter

Button

Standard XT-11 Mini One Button remote

XT-11

Transmitter

Button

System Function Remark

Lock Doors Unlock Doors Trunk Release (Channel 3) Press and Hold for 2 seconds Activate The Remote Start Push twice to start

Stop remote start operation Push to stop engine Switching code For 2nd Car

Operation.

System Function Remark Activate or Turn Off The Remote

Start

For regular remote transmitter Only

Push twice to start and stop

CHANGING THE BATTERY IN YOUR TRANSMITTERS

XT-33: The XT-33 transmitter uses two (2) 3-volt lithium ion batteries

(#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ring. Using the flat blade screwdriver, carefully pry the top case from the bottom case. It should snap apart after breaking the seal. Before removing the batteries note the direction of the positive (+) terminal. Place the new batteries in exactly the same manner, being careful not to bend or damage the contact terminal. Snap the cases back together and then test the transmitter to insure it arms and disarms the alarm. The procedure for the XT-11 Mini remote will be the same.

(2) CR2016

3-Volt Batteries

XT-11 Mini Remote is for start only.

1 - 3 Volt CR 2032

Your RS600 remote car starter comes with a secondary remote transmitter with only one button. This remote will be used in applications, where the factory keyless entry system is the main source for arming/locking and disarming/unlocking the vehicle. For example, vehicles with the factory smart key/ “push button” start or one-piece remote with key, it is recommended that the main sole purpose for this transmitter to be used for remote starting the vehicle.

All operational directions are for the XT-33 remote control. The XT-11 is designed to be used with a factory keyless entry remote and will only start and stop the engine of the installed vehicle.

+ 6 hidden pages