Audiovox AS9234 Owner's Manual
Model AS-9234
Owners Guide
Upgrade Vehicle Security
& Remote Start System
Table Of Contents:
Features Page 2
Options Page 2
Arming the System - Active Page 3
Arming the System - Passive (Automatic) Page 4
Protection While the System is Armed Page 4 - 5
Disarming the System Page 5
Intrusion Warning Signals Page 5 - 6
Operating the Emergency Panic Page 6
Using the Valet Switch Page 6 - 7
Manually Overriding Your System Page 7
Programming Your Custom Code Override Code Page 7 - 8
Using Custom Code Manual Override Page 8 - 11
Optional Ignition Lock / Unlock Feature Page 11
Eliminating the Arm / Disarm Chirps Page 11
To Remote Start Your Vehicle Page 12 - 13
Operating On Automatic Start Up Timer Mode Page 14 - 15
To Enter the Remote Start Safety By-Pass Mode Page 16 - 17
Owner's Notes Page 18
Programming Bank 1 Page 19
System Functions At A Glance Page 20
PATENTED: www.voxxintlcorp.com/company/patents
Rev b New Format 5/13
Page 1
128-8970a
1 of 20
FEATURES:
Programmable Active or Passive Arming
Selectable Manual Override Mode
Remote Panic in all modes
Protected Push Button Valet/Override Switch
Selectable Automatic Timed St art Mode
User Programmable Manual Override Code
7 Function LED - Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Optional 6 Tone Siren with Instant Siren Activation All Entry Points
Starter Disable When Armed
True Last Door Arming
Defective Zone By-Pass
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On/ Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
Car Horn Activation for additional alarm response
Additional Negative Trigger Input
Parking Light Flasher
Plug In Dual Stage Shock Sensor
OPTIONS :
Optional External Superheterodyne Receiver Antenna w/PushButton Switch & LED
Telematic Upgrade Ready
Plug In Flash Logic By-Pass Capable
Remote Trunk Release (must have electronic trunk release)
Multiple Vehicle Cap able
Remote Power Window Roll Up
Remote Garage Door Interface
Multiple Vehicle Cap able
Congratulations on your purchase of this automotive Remote Start / Alarm
Keyless Entry Upgrade System. This state-of-the-art system is designed to
arm and disarm when it receives a lock or unlock command from your existing
Factory Keyless Entry Transmitter. Taking a few moments to read this manual
will help to ensure that your vehicle is protected at all times.
NOTE: This system can be installed as a remote start upgrade operating
without any alarm functions. If this is the case with your vehicle's
installation, there will be no audible alert when the vehicle door,
hood, or trunk is opened while locked from the transmitter.
Also,the system has the ability to beep the vehicle's horn, sound
a siren, or both. Where a beep or chirp is mentioned, consider
either or both may sound.
Page 2
128-8970a
2 of 20
NOTE: All functions of the system will be controlled by the factory transmitter,
including the start sequence. If you find the operating range to be
less than desired, Audiovox offers an optional one button transmitter
kit which can be added to increase operating range for starting and
unlocking while running under control of the the remote start.
WARNING! Be certain that the vehicle is outdoors before using this or an
NOTE: Y our system has the option of using a siren, the vehicle horn, or both
for the sounding device. Where the siren is referenced below, the
horn or both may in fact chirp, or beep.
ARMING THE SYSTEM - ACTIVE
1. Turn the ignition key off, exit the vehicle and close all doors.
2. Press and release the Lock button on the keychain transmitter.
3. The siren and or horn will beep one time, the parking lamps will flash one
time, and the Dash Mounted, LED or the optional LED found on the glass
mounted windsheild receiver will begin to slowly flash, indicating that the
system is ARMED.
If the siren/horn
lid ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" three times, sometime after arming, the exclusive delayed
dome light learn circuit has been programmed and the system detected a
open entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to disarm the
system to make the correction. If the siren/horn did not sound when arming,
then the chirps have been turned off, and you should refer to the section
titled “ ELIMINATING THE ARM / DISARM CHIRPS “ in this manual.
remote vehicle starting device. A running engine produces
dangerous carbon monoxide fumes which can be harmful or
fatal if prolonged exposure occurs. DO NOT remote start the
vehicle if it is garaged.
sounds 3 chirps, then you have left a door, trunk, or hood
4. Any time the door lock switch in the vehicle is used to lock the doors
while the ignition key is turned off, the system will immediately arm.
To lock the doors after entering the vehicle, make sure the ignition key is
switched on first. Turning the ignition key on first will stop the system from
arming.
Page 3
128-8970a
3 of 20
ARMING THE SYSTEM - PASSIVE (AUT OMATIC)
(Must be activated during programming)
1. Turn the ignition key off, exit the vehicle, and close all doors.
2. The Dash Mounted, LED or the optional LED found on the glass mounted
receiver will begin to flash rapidly, indicating that the system is
automatically (passively) arming. As an added convenience, the 30
second automatic passive arming will not begin until all doors are closed,
allowing passengers to exit the vehicle at their convenience.
3. In 30 seconds, you will hear a single short chip from the siren and the
vehicle’s parking lamps will flash one time, indicating that the system has
ARMED. At this time, the dash mounted PRLED or the optional LED found
on the windsheild mounted receiver will begin to flash slowly, providing a
visual indication that the system is fully armed.
4. It is possible to program the system, that when the alarm is allowed to
automatically passive arm, there will be a 15 second delay after a door is
opened before the alarm will sound. However, if the system is programmed
for instant trigger there will be no delay. Check with your installer for the
setting of this feature.
IMPORTANT! When the system is programmed for passive arming, the
system will always arm, even when the keychain transmitter has not
been used to lock the doors.
When you leave the vehicle, and a door has been left opened, the
system will arm after 10 minutes. If you plan to vacuum the car, or if
service work is being performed, either leave the key in the ignition and
switched to the on position, or put the system into valet mode. If you do
not do this, the system will arm in 10 minutes, and you may inadvertently
trip the alarm.
PROTECTION WHILE THE SYSTEM IS ARMED
1. Opening any door, hood, or trunk will cause the alarm to immediately
sound. The alarm will continue to sound for 30 seconds, then stop and
automatically rearm the vehicle. If the potential thief left a door opened, the
alarm will sound for three more 30 second cycles, then re-arm and ignore
the opened door zone.
Page 4
128-8970a
4 of 20
2. Whenever the system is armed, the Dash Mount PRLED, or the optional
on windsheild mount receiver's LED indicator will slowly flash. This serves
as a visual deterrent to the potential thief. The LED is a very low current
bulb,and will not cause the vehicle’s battery to drain, even when the vehicle
is left unattended for extended periods.
3. Whenever the system is triggered, the vehicle’s parking lights will flash for
the 30 second alarm cycle, attracting added visual attention to the vehicle.
4. Whenever the system is armed, the vehicle’s starter will be disabled. The
vehicle will not start.
DISARMING THE SYSTEM: (Only If Alarm Features Are Selected On)
1. As you approach the vehicle, press and release the unlock button on the
keychain transmitter.
2. The siren and or horn will beep two times, the parking lamps will flash two
times, and the PRLED, or optional on glass receiver's LED will turn off,
indicating that the system is DISARMED.
NOTE: If your system has been programmed for "passive arming", then
it will begin to re-arm immediately after disarming. This is
indicated by a rapid flashing of the dash mounted PRLED, ot
the optional on glass receiver's LED. Opening one of the
vehicle’s doors will suspend the passive arming process until
all doors have been closed, or until the ignition key has been
turned on.
INTRUSION WARNING SIGNALS: (Only If Alarm Features Are Selected On)
The system will inform you if an intrusion attempt has occurred while you were
away from the vehicle. If an intrusion attempt has occurred, the siren and or
horn will beep four times when the system is disarmed. The vehicle’s parking
lights will also flash three times to indicate an intrusion has occurred.
Enter the vehicle and observe the dash mounted LED or the optional on glass
receiver's LED for further information.
1. If the LED is flashing one time, pause, one time, pause, etc., then an
intrusion attempt was made to a sensor connected to zone 1.
Page 5
128-8970a
5 of 20
2. If the LED is flashing two times, pause, two times, pause, etc., then
a nintrusion attempt was made to the hood or trunk, or to an optional
sensor connected to zone 2.
3. If the LED is flashing three times, pause, three times, pause, etc., then
a nintrusion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory, and will
only be erased when the ignition key is turned to the on position.
OPERATING THE EMERGENCY PANIC:
The buttons on your keychain transmitter will allow you to immediately activate
the alarm in emergency situations. To use the remote panic switch:
1. Press the unlock, then lock, then unlock buttons on your keychain
transmitter within 3 seconds. The alarm will immediately sound, and continue
to sound for 30 seconds.
2. To stop the alarm before the 30 second cycle has expired, simply press
andrelease the unlock button on your keychain transmitter.
NOTE: If the factory system has a panic mode, it is suggested that the factory
panic feature be used instead of the upgrade system to prevent any
potential problem of turning off the panic mode.
USING THE VALET SWITCH :
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter to parking attendants or garage
mechanics. When the system is in valet mode, all alarm functions are bypassed, however the remote panic feature and remote door locks will remain
operational. To use the valet mode, the system must first be disarmed
either by using your keychain transmitter, or by overriding the system as
explained in the Manual Override Section of this manual.
TO ENTER THE V ALET MODE:
1. Disarm the unit by use of the factory transmitter or by use of the manual
override sequence.
2. Turn the ignition switch to the on position.
Page 6
128-8970a
6 of 20
Loading...