Audiovox AS-9055 User Manual

Model AS-9055

Owner’s Manual

3 Channel Remote

Car Starter

FEATURES :

w 2 Programmable RF Transmitters
w Three Channel Receiver (capable of accepting 4 transmitters)
w On-Board Start Relay
w On-Board Accessory Relay
w On-Board Ignition 1 Relay
w On-Board Ignition 2 Relay
w Ignition 2 Relay Selectable On or Off During Cranking
w On-Board Parking Light Relay
w Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
w Tach Signal Learning Circuit
w Two ( + ) and Two ( - ) Safety Shutdown Circuits
w Alarm By-Pass Output
w Accessory Outputs
w Selectable Steady or Flashing Parking Lights for Run Indication
w Selectable 5, 10, 15, 20 Minute Run Time

(Pulse Before & After Start, During Crank & After Shut Down)

128-6831

1 of 2

REMOTE STARTING THE VEHICLE

SAFETY CONTROL SWITCH

The red handle control switch allows you to temporarily disable the remote starting function
of the system and moving this switch to the Off position is recommended whenever the
vehicle is being serviced. When the system is disabled, the remote door locks and optional
accessories will remain operational.

Run Time 5 Min o 10 Min o 15 Min o 20 Min o
Door Lock Timer 1 Sec/1 Sec o 3.5 o 1 Sec/Dbl 1 Sec o
Lights Pulse o Steady o

This will not start the vehicle if any one of the following situations exists;

The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.

1. To start the vehicle, press and release the transmitter button two times
within 2 seconds. The vehicle will start and remain running for the pre­programmed 5,10,15,20 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending on the setting by your
installation center.

2. When you arrive at the vehicle, turn the ignition key to the ON position
(not the spring loaded start position), then step on the brake pedal to disen­gage the remote starter. The vehicle will continue to run, but now on it's own
power.
NOTE: The engine will stop running before the pre-programmed run cycle

has expired if you perform any one of the following functions;

-Press and the button on the keychain transmitter two times within 2 seconds.

-Depress the brake pedal.

-Open the vehicle's hood

-Move the safety control switch to the Off position.

FUNCTION SETTING CHART

To be completed by installer

© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6831

128-6831

2 of 2