AT- H S 6
User Manual / Headshell
Name of each part
Side view
Top view
Screw holes
Rubber washer
Lead tip
�����������������������
Connector
Lead wire
How to install
1.
Mount a cartridge onto the headshell using
the cartridge installation slotted screw and
plastic washer provided, and tighten lightly so
that cartridge position can be adjusted.
• Take care that the screws are short enough so as
not to touch and damage the record.
• When using a cartridge without threaded inserts,
use screws and nuts to install the cartridge.
• Read the user manual of the cartridge.
������������������������������
Cartridge installation
slotted screw
Plastic washer
If you are unsure about the overhang
adjustment, align the stylus tip with the stylus
on the cartridge that originally came with the
turntable (see figure below).
Cartridge that came
with turntable
Connected cartridge
Make this
distance as
exact as
possible.
AT-HS6
Thank you for purchasing this Audio-Technica
product. Before using the product, read through this
user manual to ensure that you will use the product
correctly. Please keep this manual for future
reference.
Safety precautions
• Keep the product out of the reach of small
children to avoid accidental ingestion of screws,
nuts and washers, or damage to product.
• Do not use the product for any purpose other
than to mount a phono cartridge.
• Do not put the product in a location where it
is exposed to direct sunlight, near heating
devices, or in places with high temperatures,
high humidity, or high concentrations of dust.
• Do not attempt to disassemble or modify the
product.
��������������������
• Do not subject the product to strong impact.
Specifications
Material
Weight
Accessories
Specifications are subject to change without notice due to
improvements.
: Aluminum
: Approx. 9 g (0.32 oz) (including lead wire)
: Cartridge installation slotted screw (10.0 mm
2.521.4
19.6
������������������������������
× 2 and 8.0 mm × 2), Nut x 2,
Plastic washer × 2
13.0
48.9
10.5
(Unit : mm)
Threaded insert
2.
Slide the lead tips over the cartridge
connections.
• Do not apply heat.
• Use tweezers, small pilers, and non-magnetic
screwdriver(s) to mount the headshell/cartridge.
• If a lead tip is loose, flatten it out slightly to attach it.
●Layout of headshell leads
Front view
White
(left channel / +)
Blue
(left channel / –)
3.
Loosen screws with a non-magnetic screwdriver
and adjust for overhang. Tighten the screws
firmly when position is fixed.
Overhang adjustment
Red
(right channel / +)
Green
(right channel / –)
Loosen screws
and adjust the
position
4. Attach the headshell to the tonearm.
5. Refer to the turntable's user manual and
adjust the tonearm balance, tracking force
and anti-skate.
Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan
www.audio-technica.com
©2018 Audio-Technica Corporation
Global Support Contact: www.at-globalsupport.com
162501280-01-01 2018.08.01
Loading...