SB36W, SB36WE
Studio Boom Stands
1/1
A. (1) Remove the chrome plated decorative shell (SB36W only - not
included with SB36WE). (2) Do not adjust the check valve screw on
the base until the upright tube is securely in position (see Figure #1).
Place chrome shell into position on top of the base (SB36W only).
B. Thread the upright tube assembly (3) securely into the base to
avoid air leakage. Faulty operation of the air check-valve device on
the underside of the base will be noticed if the upright tube is not
installed tightly.
C. Next the air check-valve screw, located on the underside of base,
may be loosened or tightened for desired cushioning of the micro-
one wised phone stand tube assembly (see Figure #1).
D. Attach three swivel casters onto the base using the lock washers,
flat washers, and allen head bolts via the hex wrench provided
(see Figure #2).
7
E. Thread swivel adapter (4) on top of the installed upright
assembly. Next, install the swivel assembly (5) on top of the adapter.
Tighten swivel assembly screw (6).
7
F. Install counterweight (7) on unthreaded end of
then insert threaded end through swivel assembly and attach
coupler (9).
G. Thread remaining boom tube (10) into the coupler. Next thread
the hang-straight swivel (11) onto the end of the boom assembly.
⁄8" boom tube (8),
⁄8" tube
11
10
9
5
8
4
6
7
3
Figure #1
Underneath
Base
Air CheckValve
Screw
This can be adjusted for personal preference
tightening the screw- increases resistance
loosening the screw resulting in added
friction on decreases resistance resulting in
less friction on the clutch
2
1
Figure #2
Caster
Assembly
Flat Washer
Lock Washer
Allen Head Bolt
©2012 Atlas Sound L.P. All rights reserved. Atlas Sound is a trademark of Atlas Sound L.P. All other trademarks are the property of their respective owners. All specs are subject to change without notice. ATS004379 RevA 5/12
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
AtlasSound.com
Loading...