Atlas IED IP-FEST-HVP Installation Manual

IP-HVP

Install Sheet

IP-SEST-HVP Surface Mount Enclosure for IP-HVP

WARNING: IP-SEST-HVP enclosure must be mounted so seams are oriented vertically. See detail “A”. When installed outdoors, silicone-based weather

sealant (included) must be used to seal seams on sides, cable entry, and mounting holes on back of the enclosure.

ENCLOSURE

GASKET

A

BAFFLE

DETAIL A

SEAL ENCLOSURE EDGES
AND MOUNTING HOLES
WITH SILICONE PROVIDED

IP-FEST-HVP Flush Mount Enclosure for IP-HVP

WARNING: IP-FEST-HVP enclosure must be adjusted forward to edge of wall material so IP-HVP baffle may seal firmly to enclosure. See detail “A”.

Exterior surface perimiter edge must then be sealed with silicone sealant (included).

SEAL W/
RTV OR SILICONE

IP-FEST-HVP ENCLOSURE

BAFFLE

A

WALL

ENCLOSURE MUST BE

FLUSH WITH WALL SURFACE

DETAIL A

©2019 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved.

All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS003053 RevE 1/19 490344

1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.

TELEPHONE: [phone]
[e-mail]

AtlasIED.com