o Analog, Digital, Video, and Audio Industry Standards
for the Requirements of Today and the Future
d Test Signal Generators with Nonvolatile Storage
Analog and Digital Video Parameters
Research and
Studio Refere nce Generator
Manufacturing Test
Equipment Design Maintenance
Postproduction and Broadcast Facilities
Automated M anufacturing Test
TheTG2000i
platform. Designed for the most demanding test applications, the TG2000
provides reference-quality test signals, stressing functions in both the
analog and digital domains and the flexibility to address user-defined
testing requirements. Comprehensive test signal libraries are supplied
in all formats and are supplement ed by a Windows-based test signal
developmen
generators, and programmable system clocks ensure the TG2000 will meet
future needs as well as today’s requirements.
Development
s a multiformat, analog and digital, precision signal generation
t program. The modular architecture, RAM-based test signal
Data Sheet
TG2000 configured to supply signals in several formats simultaneously.
AVG1 Analog Video Generator
The AVG1 is a high-accuracy, multiformat analog test signal generator. The
AVG1 supports NTSC, PAL, PAL-D, PAL-M, PALY, B-Y, R-Y. Signal generation architecture is 12 bit, 27 MHz component
with digital modulation for composite signals. This ensures high-accuracy,
distortion-free signals within a 6 MHz video bandwidth and signals suitable
for many applications up to 8 MHz.
DVG1 Digital Video Generator
The DVG1 is a multiformat digital test signal generator. The DVG1 supports
NTSC composite and 525 and 625 component digital sampled at 13 .5 and
18 MHz. Parallel and serial outputs a re provided.
Full field and active picture CRC generation is supported on the serial
digital outputs and may be turned on and off from the front panel. Up to
16 channels of 20-bit audio sampled at 48 kHz and locked to the video
sampling c lock may be embedded on th e serial digital video output.
Frequency and level for
each channel may be set from the front panel.
N, SECAM, RGB, YC, and
generation for bandwidths up to 6 MHz. A fully programmable zone plate
generator is included. AWVG1 output is analog composite.
HDVG1 Digital HDTV Generator
The HDVG1 is a high-accuracy, multiformat, high-definition test signal
module that p rovides three 1.485 Gb/s serial digital video test signal outputs
in 1080i/60, 5
59.94 field rates. It is programmable with the included SDP2000 PC-based
signal development software.
9.94, 1080p/25, and 24 Hz rates and 720p formats in 60 and
HDST1 Stress Test Module
The HDST1 is a HD-SDI Stress Test module that supports stress test
capability for 1.485 and 1.485/1,001 Gb/s HD-SDI signals. The HDST1
takes in a single HD-SDI signal and outputs a stressed HD-SDI signal. HD
signals from test signal generators (including the HDVG1 module), as well
as from HD cameras, VTRs, or switchers, can be used as the input signal.
Signal stres
duty cycle, and random error insertion. The HDVG1 is recommended as a
signal source, since it is capable of providing a signal with low residual Jitter,
as well as the ability to incorporate its frequency offset stress feature.
sing options include Jitter (amplitude or frequency), amplitude,
SDP2000 Signal Development Program
The SDP2000 is a Windows-based software program that provides facilities
to edit signals in the factory-supplied test signal libraries and to create new
signals for special applications. Line- and frame-editing functions permit
fast, easy changes to full field test signals and composition of multisegment
matrix sign
may be named and stored in the factory test signal libraries or in new
user-created libraries.
als for automated testing applications. Modified and new signals
Internal and External Reference Operation
The TG2000 has a high-sta bility internal reference making it su itable as the
master house reference for most broadcast and production/postproduction
applications. A black-burst output, selectable for NTSC or PAL, is provided
with the TG2000 mainframe.
AWVG1 Analog Wideband Video Generator
The AWVG1 is a 30 MHz bandwidth test signal generator intended primarily
for generation of wideband frequency and transient response test signals.
The AWVG1 ca n be used as a source of tri-level sync. Signal generation
is 12 bits w
2 www.tektronix.com
ith 72 MHz sampling that ensures very low distortion T-pulse
Remote Control
The TG2000 provides a versatile and comprehensive remote control
system. All front-panel functions and controls are available through the
RS-232 and optional GPIB ports. A subset of those function s is available
through g
round closure control.
Multiformat Generator — TG2000
Characteristics
TG2000 Mainframe
Black-burst Output –
Standards Conformance: EBU N14, SMPTE RP 154.
Frequency:
NTSC or PAL F
Long-term stability: ≤1 ppm per year drift.
AVG1 Analog Video Generator
Standards Conformance – EBU N10, ITU-R BT.624, SMPTE 170M.
Frequency Response – Within 0.5% to 6 MHz. Typically within 5% to 8 MHz.
Differential Gain Error – ≤0.1%.
Differential Phase Error – ≤0.1°.*
S/N Ratio – ≥67 dB unweighted to 6 MHz, measured on a quiet line.
SCH Phase Error – ≤2°.*
*1Denotes a typical performance characteristic.
DVG1 Digital Video Generator
Standards Conformance – EBU Tech. 3267: ITU-R BT.601, BT.656, BT.801;
SMPTE 125M, 244M, 259M, 267M, 272M, RP 165, RP 178.
Maximum Clock Frequency – 36 MHz.
Resolution – 8or10bit.
Serial Output –
Amplitude: 800 mV ±10% into 75 Ω.
Overshoot: ≤10%.
Rise/Fall times: 0.4 to 1.5 ns.
Jitter: ≤0.2 UI
Embedded Audio –
Number of
Audio tones:
Pre-emphasis: None.
channels: 16 channels in 4 groups; 8 AES/EBU audio pairs.
Frequency: silence to 16 kHz; 28 discrete settings.
Level: 0 t
.
SC
1
1
total for all Jitter frequencies above 10 Hz.
p-p
o -60 dBFS in 2 dB steps.
AWVG1 Analog Wideband Video Generator
Frequency Response – Within 1% to 20 MHz, 2% to 30 MHz.
DelayErrors–Group Delay: ≤3nsto20MHz,≤5nsto25MHz.*
Pulse Distortions –
Pulse Ringing:
2T: ≤0.5% peak
.
T: ≤1% peak.
PulsetoBarRatio–Unity within 0.5% for T and 2T.
S/N Ratio – ≥60 dB unweighted to 30 MHz, measured on a quiet line.
Connector – 75 Ω BNC Connector.
Cable Type – L-5CFB.
Return Loss – ≤15 dB to 1.485 GHz.
Length – 20 m, 100 m.
±10%.
p-p
t
5 Ω BNC Connector.
HD-SDI signal.
0to1040mV
±5% (measured at 4.64 MHz square wave).
p-p
1% step.
≤270ps(20%to80%).
≤15 dB to 1.485 GHz.
Sine wave.
Sine wave.
AGL1 Analog Genlock Module
Inputs – Two 75 Ω loopthrough; one 75 Ω terminating.
Loopthrough Inputs –
Input range: ±6 dB f rom nominal black burst.
Return loss: ≥40dBto5MHz.
Burst lock stability:
Amplitude changes: ≤1 ns change over a ±3 dB input level.
Jitter: ≤1nswith≥50 dB S/N ratio on a nominal amplitude reference input.
Typically ≤1°.
CW Input –
Input range: 1 to 2.25 V
Frequencies: NTSC and PAL F
.
p-p
sc
;1,5,and10MHz.
Return loss: ≥30 dB to 10 MHz.
Lock stability:
Amplitude changes: ≤1 ns over the valid input range.
Jitter: ≤1nswith≥50 dB S/N ratio for a 2 V reference input. Typically ≤0.5°.
Timing Adjustment (Black burst reference) –
Range: Anywhere within the color frame.
Resolution: ≤0.5°.
Color Framing – Correct for up to ±45° SCH error on the reference input.
Power Source
Mains Range –
Voltage: 87 to 132 or 174 to 250 VAC.
Frequency: 50 to 60 Hz.
Power Consumption – Typically 220 W for a fully loaded TG2000 mainframe.
Environmental
Temperature –
Operating: 0 °C to +40 °C.
Nonoperating: -40 °C to +65 °C.
Certifications
EMC – Certified to the EMC Directive 89/336/EEC.
Safety –
Approved to: CSA1010.1, ANSI S82.01.
Complies with: EN61010-1, IEC1010-1.
Physical Char acteristics
Dimensions
Height1335.23
Width48319.0
Depth58423.0
Weightkglb.
Net17.338.0
Shipping
mm
in.
23.752.0
4 www.tektronix.com
Multiformat Generator — TG2000
Ordering Information
When Ordering, Please Observe These Simple Guidelines:
At least one signal generation module must accompany each TG2000
mainframe
Only one AGL1 Genlock Module per TG2000 mainframe
Only one GP1 GPIB Interface Module per each TG2000 mainframe
Signal generator modules (AVG1, DVG1) may be combined in any mix
desired up to the TG2000 mainframe limit of 8. The mainframe may
contain a maximum of 4 of any combination of HDVG1 and AWVG1
modules
Only one HDST1 module per TG2000 mainframe. Additional limitations
may apply, depe
configured with an HDST1. Contact Tektronix Technical Support for
details
The performance of the TG2000 is degraded to the E4 environment for
radiated emissions only when operating with a combination of HDVG
and HDST1 in HD-SDI stress testing applications
Add O pt . 88 to each item ordered. This will ensure your TG2000
package will come assembled and calibrated as a single unit
Modules ordered to add to an existing TG2000 package do not require
Opt. 88
nding upon other modules loaded in a mainframe
TG2000
Generator Mainframe with BG1 Black Burst Generator.
AVG1
Analog Video Generator.
DVG1
Digital Video Generator.
Opt. S1 – SDI Test.
AWV G1
Analog Wideband Video Generator.
Tri-level Sync Generator.
AGL1
Analog Genlock Module.
GP1
GPIB interface.
HDVG1
High Definition Video Generator.
HDST1
HD-SDI S
1
Support Options
Opt. C3
Opt. R3 – Repair Service 3 Years.
tress Test Module.
–
Calibration Service 3 Years.
Product(s) ar
e manufactured in ISO registered facilities.
www.tektronix.com 5
Data Sheet
6 www.tektronix.com
Multiformat Generator — TG2000
www.tektronix.com 7
Data Sheet
Contact Tektronix:
ASEAN / Australa
Balkans, Israel, South Africa and other ISE Countries +41 52 675 3777
Central East Eu
Mexico, Central/South America & Caribbean 52 (55) 54247900
rope, Ukraine, and the Baltics +41 52 675 3777
Central Europe & Greece +41 52 675 3777
Luxembourg +44 (0) 1344 392400
Middle E ast,
For other areas contact Tektronix, Inc at: 1 (503) 627-7111
Asia, and North Africa +41 52 675 3777
The N etherlands 090 02 021797
People’s Rep
United Kingdom & Ireland +44 (0) 1344 392400
ublic of China 86 (10) 6235 1230
Republic of
sia (65) 6356 3900
Austria +41 52 675 3777
Belgium 07 81 601
Brazil +55 (11) 40669400
Canada 1 (800) 661-5625
Denmark +4580881401
Finland +41526
France +33(0)169868181
Germany +49 (221) 94 77 40 0
Hong Kong (852
India (91) 80-42922600
Italy +39 (02) 25086 1
Japan 81 (3) 67
Poland +41 52 675 3777
Portugal 80 08 12370
Korea 82 (2) 6917-5000
Russia & CIS +7 (495) 7484900
South Africa +27 11 206 8360
Spain (+3 4)
Sweden 020 08 80371
Switzerland +41 52 675 3777
Tai wa n 886 (
USA 1 (800) 426-2200
75 3777
) 2585-6688
14-3010
Norway 800 16098
901 988 054
2) 2722-9622
Updated 30 October 2008
66
www.tektronix.com
For Further Information. Tektronix maintains a comprehensive, constantly expanding
collection of application notes, technical briefs and other resources to help engineers working
on the cutting edge of technology. Please visit www.tektronix.com