Astro 888S User Manual
MINI STRAIGHT
888S
LINE SANDER
www.astrotools.com
•Astro Pneumatic Tool Co. warrants our products to the original user against
defective material or workmanship for a period of 1 year (except where noted on our
price schedule) from the date of 1st use. Astro reserves the right to determine
whether the product failed because of defective material, workmanship or other
causes and to charge back for missing parts. Astro Pneumatic Tool Co., at its
discretion, will repair products covered under this warranty free of charge. The
distributor should direct the original user to return the product (with the exceptions
listed below) with the distributor’s name, address, adequate proof of date of
purchase or a copy of warranty card, and a short note explaining the problem.
Failures caused by accident, alteration, or misuse are not covered by this
warranty.
•Astro Pneumatic Tool Co. or its authorized service representatives must perform all
warranty repairs. Any repair to the product by unauthorized service representatives
voids this warranty. The rights under this warranty are limited to the original user and
may not be transferred to subsequent owners.
•This warranty is in lieu of all other warranties, expressed or implied, including
warranties of merchantability and fitness for a particular purpose. Some states do
not allow the exclusion of limitations of incidental or consequential damages so the
above limitations may not apply to you. All claims must be sent to:
Astro Pneumatic Tool Company
372 Old US Highway 52 South
Mt. Airy, NC 27030
1 YEAR LIMITED WARRANTY
PLEASE DO NOT RETURN ANY PRODUCT WITHOUT CALLING
1-800-221-9705 FOR INSTRUCTIONS
• Used on plastic fillers at any stage of hardening
• Feathers with ease and smoothness
• Single Piston
• Single handle design for smaller and
harder to reach spaces
• Fast and efficient performance
• 3,000 strokes per minute
• 4 CFM
• Vibration less than 2.5 m/s2
SPECIFICATIONS:
• Sanding Paper Size: 2-3/4" x 11"
(7 x 28 cm)(PSA or Velcro)
• Tool Weight: 4.25 lbs (1.9kgs)
• Sound pressure: 89 dBA
• Sound Power: 98 dBA
Unpacking
When unpacking, check the parts diagram and part number listing
on page 4 to make sure all parts are included. If any parts are
missing or damage, please call your distributor.
MINI STRAIGHT LINE SANDER
MADE IN TAIWAN
888S
1.) LUBRICATION:
Before connection of the hose, apply 4 to 5 drips of a good
quality air tool oil at the air inlet. After 3 to 4 hours of operation, oiling may be necessary again.
2.) TIGHTNESS OF PARTS:
Regularly check whether all connection parts are
fastened securely. Follow this precedure daily
before beginning work.
3.) STORAGE:
Avoid storing the tool in a location subject to high humidity. If
the tool is left unused, the residual moisture inside the tool
can cause rust. Before storing and after operation, oil the tool
at the air inlet with a good quality air tool oil and run it for a
short period.
4.) DISPOSAL:
Follow national legislation of waste disposal.
MINI STRAIGHT LINE SANDER
5.) ORDERING SERVICE PART
For further operational and handling information or for
replacement of parts and components, contact the sales
agent from where you purchased the tool, or the service
division of our company. *When ordering parts and components, give each part number, name, and quantities.
MINI STRAIGHT LINE SANDER
Page 2 Page 3
Loading...