Asrock H470M-ITX/ac RAID Installation Guide

Configuring a RAID array Using UEFI Setup Utility

The BIOS screenshots in this guide are for reference only and may differ from the exact settings

for your motherboard. The actual setup options you will see shall depend on the motherboard

you purchase. Please refer to the product specification page of the model you are using for

information on RAID support. Because the motherboard specifications and the BIOS software

might be updated, the content of this documentation will be subject to change without notice.

Caution:

Please use identical PCIE SSDs that are of the same type and capacity. RAID including a PCIe

SSD in a Hyper M.2 slot is only available with an Intel® SSD in that slot.

STEP 1:

Enter the UEFI Setup Utility by pressing <F2> or <Del> right after you power on the computer.

STEP 2:

Go to Boot\CSM and set CSM to [Disabled].

STEP 3:

Go to Advanced Storage Configuration and set SATA Mode Selection to [RAID Mode], then

press <F10> to save the configuration changes and exit setup.

1

STEP 4. (If you are not using a PCIe SSD in the RAID, please skip this step)

Set the M.2 slots with PCIE SSDs to [RST Controlled].

STEP 5.

Enter Intel(R) Rapid Storage Technology in the Advanced page.

2

STEP 6:

Select the option Create RAID Volume and press <Enter>.

STEP 7:

Key-in a volume name and press <Enter>, or simply press <Enter> to accept the default name.

3