No part of this documentation may be reproduced, transcribed, transmitted, or
translated in any language, in any form or by any means, except duplication of
documentation by the purchaser for backup purpose, without written consent of
ASRock Inc.
Products and corporate names appearing in this documentation may or may not
be registered trademarks or copyrights of their respective companies, and are used
only for identication or explanation and to the owners’ benet, without intent to
infringe.
Disclaimer:
Specications and information contained in this documentation are furnished for
informational use only and subject to change without notice, and should not be
constructed as a commitment by ASRock. ASRock assumes no responsibility for
any errors or omissions that may appear in this documentation.
With respect to the contents of this documentation, ASRock does not provide
warranty of any kind, either expressed or implied, including but not limited to
the implied warranties or conditions of merchantability or tness for a particular
purpose.
In no event shall ASRock, its directors, ocers, employees, or agents be liable for
any indirect, special, incidental, or consequential damages (including damages for
loss of prots, loss of business, loss of data, interruption of business and the like),
even if ASRock has been advised of the possibility of such damages arising from any
defect or error in the documentation or product.
is device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
CALIFORNIA, USA ONLY
e Lithium battery adopted on this motherboard contains Perchlorate, a toxic substance
controlled in Perchlorate Best Management Practices (BMP) regulations passed by the
California Legislature. When you discard the Lithium battery in California, USA, please
follow the related regulations in advance.
“Perchlorate Material-special handling may apply, see www.dtsc.ca.gov/hazardouswaste/
perchlorate”
ASRock Website: http://www.asrock.com
e terms HDMI™ and HDMI High-Denition Multimedia Interface, and the HDMI
logo are trademarks or registered trademarks of HDMI Licensing LLC in the United
States and other countries.
Contents
Chapter 1 Introduction 1
1.1 Package Contents 1
1.2 Specications 2
1.3 Motherboard Layout 6
1.4 I/O Panel 8
1.5 WiFi-802.11ac Module and ASRock WiFi 2.4/5 GHz Antenna 10
Chapter 2 Installation 15
2.1 Installing the CPU 16
2.2 Installing the CPU Fan and Heatsink 19
2.3 Installing Memory Modules (DIMM) 20
2.4 Expansion Slots (PCI Express Slots) 22
2.5 Jumpers Setup 23
2.6 Onboard Headers and Connectors 24
Chapter 3 Software and Utilities Operation 28
3.1 Installing Drivers 28
3.2 A-Tuning 29
3.3 ASRock Live Update & APP Shop 33
3.3.1 UI Overview 33
3.3.2 Apps 34
3.3.3 BIOS & Drivers 37
3.3.4 Setting 38
3.4 Enabling USB Ports for Windows® 7 Installation 39
Chapter 4 UEFI SETUP UTILITY 42
4.1 Introduction 42
4.1.1 UEFI Menu Bar 42
4.1.2 Navigation Keys 43
4.2 Main Screen 44
4.3 OC Tweaker Screen 45
4.4 Advanced Screen 53
4.4.1 CPU Conguration 54
4.4.2 Chipset Conguration 56
4.4.3 Storage Conguration 59
4.4.4 Super IO Conguration 60
4.4.5 ACPI Conguration 61
4.4.6 USB Conguration 62
4.4.7 Trusted Computing 63
4.5 Tools 64
4.6 Hardware Health Event Monitoring Screen 68
4.7 Security Screen 70
4.8 Boot Screen 71
4.9 Exit Screen 74
H170M-ITX/ac
Chapter 1 Introduction
ank you for purchasing ASRock H170M-ITX/ac motherboard, a reliable
motherboard produced under ASRock ’s consistently stringent qualit y control.
It delivers excellent performance with robust design conforming to ASRock’s
commitment to quality and endurance.
In this documentation, Chapter 1 and 2 contains the introduction of the
motherboard and step-by-step installation guides. Chapter 3 contains the operation
guide of the soware and utilities. Chapter 4 contains the conguration guide of
the BIOS setup.
Becau se the motherboard speci cations and the BIOS soware might be updated, the
content of this doc umentation will be subject to change without notice. In case any modications of this documentation occur, the updated version will be available on ASRock’s
website w ithout further notice . If you require technical suppor t related to this motherboard, please v isit our website for specic information about the model you are using. You
may nd the l atest VGA cards and CPU support list on ASRock’s website as well . ASRock
website http://www.asrock.com.
1.1 Package Contents
ASRock H170M-ITX/ac Motherboard (Mini-ITX Form Factor)
•
ASRock H170M-ITX/ac Quick Installation Guide
•
ASRock H170M-ITX/ac Support CD
•
2 x Serial ATA (SATA) Data Cables (Optional)
•
1 x I/O Panel Shield
•
1 x WiFi-802.11ac Module
•
2 x SMA WiFi Antenna Cables
•
2 x ASRock WiFi 2.4/5 GHz Antennas
•
1 x WiFi Module Bracket
•
2 x Screws for WiFi Module
•
English
1.2 Specications
Platform
CPU
Chipset
Memory
Expansion
Slot
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
* is Mini-PCI Express Slot supports WiFi and mSATA
Please realize that there i s a certain risk involved with o verclocking, including adjusting
the setting in the BIOS , applying Untied Overclocking Technology, or using third-party
overclocking tools. Overclocking may aect your system’s stability, or even cau se damage to
the components and devices of your system. It should be done at your own r isk and expense.
We are not responsible for possible damage caused b y overclocking.
English
PCIE1
DDR 4_A1 (6 4 bit, 28 8-pin m odule )
DDR 4_B1 (6 4 bit, 28 8-pin m odule )
CPU_FAN1
CHA_FAN1
5
RoHS
H170M-ITX/ac
2
6
7
9
10
8
USB 2.0
T: USB1
B: USB2
PS2
Keyb oard
/Mou se
15 14 13 12 11
MINI_PCIE1
128Mb
BIOS
AUDIO
CODEC
4
17
1
HD_AUDIO1
1
USB_3_ 4
1
SPEAKER 1
Top:
RJ-45
USB 3.0
T: USB1
B: USB2
Top:
RJ-45
USB 3.0
T: USB3
B: USB4
USB 3.0
T: USB5
B: USB6
LAN
LAN
Intel
H170
ATXP WR 1
SATA3_3
SATA3_2
SATA3_1
SATA3_0
USB3_7 _8
1
31
PANEL1
HDLED RESET
PLED PWRBTN
1
TPMS1
1
1
CLRMOS1
1
CI1
16
HDM I1
DVI 1
Top:
LINE I N
Cent er:
FRON T
Bott om:
MIC IN
Front U SB 3.0
PCI Express 3.0
1.3 Motherboard Layout
English
67
No. Description
1Chassis Fan Connector (CHA_FAN1)
2CPU Fan Connector (CPU_FAN1)
32 x 288-pin DDR4 DIMM Slots (DDR4_A1, DDR4_B1)
4USB 2.0 Header (USB_ 3_4)
5ATX Power Connector (ATXPWR1)
6USB 3.0 Header (USB3_7_8)
7TPM Header (TPMS1)
8System Panel Header (PANEL1)
9Clear CMOS Jumper (CLRMOS1)
10 Chassis Intrusion Header (CI1)
11 Chassis Speaker Header (SPEAKER1)
12 SATA3 Connector (SATA3_0)
13 SATA3 Connector (SATA3_1)
14 SATA3 Connector (SATA3_2)
15 SATA3 Connector (SATA3_3)
16 Front Panel Audio Header (HD_AUDIO1)
17 ATX 12V Power Connector (ATX12V1)
H170M-ITX/ac
English
1.4 I/O Panel
1
23
12891011
No. DescriptionNo. Description
1USB 2.0 Ports (USB12) 7USB 3.0 Ports (USB3_56)
2LAN RJ-45 Port (Realtek RTL8111H)* 8USB 3.0 Ports (USB3_34)
3LAN RJ-45 Port (Intel® I219V)* 9USB 3.0 Ports (USB3_12)
4Line In (Light Blue)**10HDMI Port
5Front Speaker (Lime)**11DVI-D Port
6Microphone (Pink)**12PS/2 Mouse/Keyboard Port
* ere are two LEDs on each LAN port. Plea se refer to the table below for the LAN port LED indications.
** To congure 7.1 CH HD Audio, it i s required to use an HD front panel audio module and e nable the multichannel audio feature through the audio driver.
Please set Speaker Cong uration to “ 7.1 Speaker” in the Realtek HD Audio Manager.
Function of the Audio Ports in 7.1-channel Conguration:
PortFunction
Light Blue (Rear panel)Rear Speaker Out
Lime (Rear panel)Front Speaker Out
Pink (Rear panel)Central /Subwoofer Speaker Out
Lime (Front panel)Side Speaker Out
English
1.5 WiFi-802.11ac Module and ASRock WiFi 2.4/5 GHz Antenna
WiFi-802.11ac + BT Module
is motherboard comes with an exclusive WiFi 802.11 a/b/g/n/ac + BT v4.0
module that oers support for WiFi 802.11 a/b/g/n/ac connectivity standards and
Bluetooth v4.0. WiFi + BT module is an easy-to-use wireless local area network
(WLAN) adapter to support WiFi + BT. Bluetooth v4.0 standard features Smart
Ready technology that adds a whole new class of functionality into the mobile
devices. BT 4.0 also includes Low Energy Technology and ensures extraordinary
low power consumption for PCs.
* e transmission speed may var y according to the environment.
WiFi + BT Module
(included in the package)
ASRock WiFi 2.4/5 GHz Antennas
(included in the package)
English
1011
WiFi Module and WiFi Antennas Installation Guide
Step 1
Prepare the WiFi Module, WiFi Module Bracket,
and the two screws (M2*3) that come with the
package. Prepare a Phillips #0 screwdriver.
Step 2
Attach the WiFi Module Bracket to the WiFi
card, aligning the screw hole on the WiFi card
with the screw hole on the bracket. Use the screw
to attach the bracket and the WiFi card, but do
not tighten the screw.
H170M-ITX/ac
Step 3
Insert the WiFi Module Card into the vertical
mini PCI Express slot (MPCIE1).
Step 4
Tighten the screw that holds the card in place.
English
Step 5
Tighten the screw that attaches the WiFi
Module Bracket to the WiFi card (installed
in Step 2).
Step 6
Prepare the SMA Wi-Fi Antenna Cables
and WiFi 2.4/5 GHz Antennas that come
with the package.
Step 7
Attach the SMA Wi-Fi Antenna Cables to
the WiFi Module.
English
1213
Step 8
Insert the RP-SMA Wi-Fi Antenna Con-
nectors to the antenna ports on the I/O
shield
Step 9
Fasten the screw nuts to secure the
antenna connectors.
H170M-ITX/ac
Ste p 10
Connect the two WiFi 2.4/5 GHz
Antennas to the antenna connectors. Turn
the antenna clockwise until it is securely
connected.
English
Ste p 11
Set the WiFi 2.4/5 GHz Antenna at 90-de-
gree angle.
*You may need to adjust the direction of
the antenna for a stronger signal.
English
1415
H170M-ITX/ac
Chapter 2 Installation
is is a Mini-ITX form factor motherboard. Before you install the motherboard,
study the conguration of your chassis to ensure that the motherboard ts into it.
Pre-installation Precautions
Take note of the following precautions before you install motherboard components
or change any motherboard settings.
Make sure to unplug the power cord before installing or removing the motherboard
•
components. Failure to do so may cause physical injuries and damages to motherboard
components.
In order to avoid damage from static electricity to the motherboard’s components,
•
NEVER place your motherboard directly on a carpet. Also remember to use a grounded
wrist strap or touch a safety grounded object before you handle the components.
Hold components by the edges and do not touch the ICs.
•
Whenever you uninstall any components, place them on a grounded anti-static pad or
•
in the bag that comes with the components.
When placing screws to secure the motherboard to the chassis, please do not over-
•
tighten the screws! Doing so may damage the motherboard.
English
2.1 Installing the CPU
1. Before you insert the 1151-Pin CPU into the socket , please check if the PnP cap is on the
socket, if the CPU sur face is unclean, or if the re are any bent pins in the socket . Do not
force to in sert the CPU into the socket if above situation is found. Otherwise, the CPU
will be seriously damaged.
2. Unplug all power c ables be fore installing the CPU.
1
2
A
B
English
1617
H170M-ITX/ac
3
4
5
English
Please save and replace the cover if the processor is removed. e cove r must be placed if
you wish to return the motherboard for ae r service.
English
1819
2.2 Installing the CPU Fan and Heatsink
12
H170M-ITX/ac
FAN
CPU_
English
Loading...
+ 56 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.