Ariston A6VMH60 X AUS, A6VMH60 W AUS Operating Instructions

Operating Instructions

COOKER AND OVEN

English, 1

A6VMH60/ AUS

Contents

Warning, 2

Installation, 3

Positioning and levelling Electrical connection Technical data

Description of the appliance, 5

Overall view Control panel

Start-up and use, 6

Starting the oven Using the cooking timer

Cooking advice, 9

Oven cooking advice table

Using the glass ceramic hob, 10

Switching the cooking zones on and off Cooking zones

Precautions and tips, 11

General safety Disposal Respecting and conserving the environment

Care and maintenance, 12

Switching the appliance off Cleaning the appliance Replacing the oven light bulb Cleaning the glass ceramic hob Assistance

WARNING

During use the appliance becomes hot. Care should be taken to avoid touching

heating elements inside the oven.

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

! When you place the rack inside, make sure that the stop is directed upwards

and in the back of the cavity .

WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire.

NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.

WARNING: Danger of fire: do not store items on the cooking surfaces. WARNING: If the surface in glassceramic is cracked, switch off the appliance to avoid the possibility of electric shock.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass. The internal surfaces of the compartment (where present) may become hot.

Never use steam cleaners or pressure cleaners on the appliance. Remove any liquid from the lid before opening it.

Do not close the glass cover (if present) when the gas burners or electric hotplates are still hot.

Installation

HOOD

420

Min.

min.

650

mm. with hood

min. 700 mm. without hood

mm.

600

Min. mm.

420

Min. mm.

! Before operating your new appliance please read this instruction booklet carefully. It contains important information concerning the safe installation and operation of the appliance.

Please keep these operating instructions for future reference. Make sure that the instructions are kept with the appliance if it is sold, given away or moved.

Levelling

If it is necessary to level the appliance, screw the adjustable feet* into the places provided on each corner of the base of the cooker (

see figure

! The appliance must be installed by a qualified professional according to the instructions provided.

! Any necessary adjustment or maintenance must be performed after the appliance has been disconnected from the electricity supply.

Positioning and levelling

! It is possible to install the appliance alongside cupboards whose height does not exceed that of the hob surface. ! This cooker should be installed directly on! This cooker should be installed directly on

! This cooker should be installed directly on

! This cooker should be installed directly on! This cooker should be installed directly on the floor. Do not install this cooker on anthe floor. Do not install this cooker on an

the floor. Do not install this cooker on an

the floor. Do not install this cooker on anthe floor. Do not install this cooker on an artificial base of any kind.artificial base of any kind.

artificial base of any kind.

artificial base of any kind.artificial base of any kind. ! Make sure that the wall in contact with the back of the appliance is made from a non-flammable, heatresistant material (T 90°C). ! Important: Do not install this appliance! Important: Do not install this appliance

! Important: Do not install this appliance

! Important: Do not install this appliance! Important: Do not install this appliance adjacent to the door or other means ofadjacent to the door or other means of

adjacent to the door or other means of

adjacent to the door or other means ofadjacent to the door or other means of access to minimise the likelihood of personsaccess to minimise the likelihood of persons

access to minimise the likelihood of persons

access to minimise the likelihood of personsaccess to minimise the likelihood of persons using the door making contact with pans onusing the door making contact with pans on

using the door making contact with pans on

using the door making contact with pans onusing the door making contact with pans on the hob surface.the hob surface.

the hob surface.

the hob surface.the hob surface.

To install the appliance correctly:

• Place it in the kitchen, dining room or the bed-sit

(not in the bathroom).

• If the top of the hob is higher than the cupboards,

the appliance must be installed at least 200 mm away from them.

• If the cooker is installed underneath a wall cabinet, there must be a minimum distance of 420 mm between this cabinet and the top of the hob. This distance should be increased to 700 mm if the wall cabinets are flammable (

• Do not position blinds behind the cooker or less

than 200 mm away from its sides.

• Any hoods must be installed according to the

instructions listed in the relevant operating manual.

see figure

The legs* provided with the appliance fit into the slots on the underside of the base of the cooker.

Electrical connection

Ovens with a three-pole power supply cable are designed to operate with alternated current at the supply frequency and voltage indicated on the data plate (at the bottom of the oven dashboard). The earthing conductor of the cable is the yellow-green conductor.

Opening the terminal board:

••

• Using a screwdriver, prise

•• on the side tabs of the terminal board cover;

••

• Pull open the cover of the

•• terminal board.

To install the cable, proceed as follows:

••

• Remove the wire clamp

•• screw and the three contact screws L-N-

• Fasten the wires beneath the heads of the screws using the following color scheme :

Blue (N) Brown (L) YellowGreen

• Fasten the supply cable in place with the clamp and close the cover of the terminal board.

Connecting the supply cable to the mains

WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE

WARNINGS: THIS APPLIANCE MUST BE

WARNINGS: THIS APPLIANCE MUST BEWARNINGS: THIS APPLIANCE MUST BE EARTHED.EARTHED.

EARTHED.

EARTHED.EARTHED.

! The cooker must be connected to the mains by a switched (double pole) cooker outlet correctly fused with a capacity appropriate to that shown on the cooker Rating Plate. All electrical wiring from the consumer unit to the cooker, via the switched double

pole cooker outlet, must be of an acceptable type and current rating as above. ! the supply cable must be positioned so that it

never reaches at any point a temperature 50°C higher than the room temperature. The cable must be routed away from the rear vents.

HOT PARTS

! The manufacturer declines any liability should these safety measures not be observed.

We recommend cleaning the oven before using it for the first time, following the instructions provided in the "Care and maintenance" section.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

Safety Chain

! In order to prevent accidental tipping of the appliance, for example by a child climbing onto the oven door, the supplied safety chain MUST be installed!

The cooker is fitted with a safety chain to be fixed by means of a screw (not supplied with the cooker) to the wall behind the appliance, at the same height as the chain is attached to the appliance.

Choose the screw and the screw anchor according to the type of material of the wall behind the appliance. If the head of the screw has a diameter smaller than 9mm, a washer should be used. Concrete wall requires the screw of at least 8mm of diameter, and 60mm of length.

Ensure that the chain is fixed to the rear wall of the cooker and to the wall, as shown in figure, so that after installation it is tensioned and parallel to the

ground level.

Description of the appliance

Overall view

Glass ceramic hob

Control panel

GRILL rack

DRIPPING pan

Adjustable foot

GUIDE RAILS

for the sliding racks

position 5 position 4 position 3 position 2 position 1

Adjustable foot

Control panel

SELECTOR

knob

THERMOSTAT

indicator light

THERMOSTAT

knob

Electronic programmer

ACTIVE HOTPLATE

indicator light

ELECTRIC HOTPLATE

control knobs

+ 11 hidden pages