Antunes HWT-20 User Manual

HWT

Hand Wash Timer

HWT-20

Mfg. No. 9900640

Dimensions: 6" x 1 1/4" x 4"

(152 mm x 32 mm x 102 mm)

Prevent the spread of germs and infectious
disease when handling food product by pro­moting safe cleaning practices. e Hand
Wash Timer displays a repeating 20-second
countdown to provide a visual reminder of
the recommended time for washing hands.
It requires no user intervention to operate or
active and helps employees conform to health
and safety requirements.

Features

■ Runs on two AA batteries with an estimated
operating life of three years.

■ Mounts to any magnetic surface.

■ Encourages safe cleaning habits to prevent
the spread of infectious diseases.

■ No user intervention required to operate or
activate the timer.

■ Helps employees conform to the HACCP
Safety requirement.

■ Assures customers that your employees have
a procedure for healthy standards.

■ Demonstrates to local health inspectors your
commitment to safe cleaning practices in the
restaurant.

The Correct Way to Wash Hands

1. Wet hands and apply liquid soap.

2. Rub hands vigorously together and scrub all
surfaces.

3. Continue until the Hand Wash Timer
completes a full cycle. e soap combined
with vigorous scrubbing helps dislodge and
remove germs.

4. Rinse thoroughly and dry hands with a clean
towel.

a brand by A.J. Antunes & Co. www.ajantunes.com

HWT

Instructions for Use

Hand Wash Timer

Follow these instructions for mounting the timer, changing the batteries,
and using the timer to properly wash hands.

MOUNTING THE HAND WASH TIMER

The Hand Wash Timer will mount directly to any flat steel surface with the
magnetic backing.

NOTE: Thoroughly clean the surface where the Timer is to be mounted
before proceeding. Observe the proper cleaning procedures as required.
Mount the Hand Wash Timer in the location that best suits your operation.

1. If desired, use the Universal Mounting Bracket by carefully peeling
the backing from the adhesive and secure the Universal Bracket to
the chosen mounting surface.

NOTE: The adhesive is strong. Make certain to center it properly before
attaching.

2. Attach the Hand Wash Timer to the Universal Bracket or directly
to a magnetic surface.

CHANGING BATTERIES

The Hand Wash Timer comes with two AA batteries installed. These bat­teries have an estimated operating life of 3 years. In the event the batteries
need to be changed, follow these steps:

1. Remove the four screws from the rear of the unit and remove the
back panel.

2. Remove and properly discard the two old AA batteries.

3. Install two new AA batteries. The unit should begin to operate
automatically.

4. Re-attach the back panel and secure with the four screws.

PROPER HAND WASHING TECHNIQUE

1. Wet hands and apply liquid soap.

2. Rub hands vigorously together and scrub all surfaces.

3. Continue until the Hand Wash Timer completes a full cycle. The
soap combined with vigorous scrubbing helps
dislodge and remove germs.

4. Rinse thoroughly and dry hands with a clean towel.

PROBLEMS WITH THE TIMER?

If you experience any problem with your Hand Wash Timer, contact the
manufacturer immediately at 877-392-7854 (Toll Free in the U.S. and
Canada) or at 630-784-1000 (outside the U.S and Canada).

CLEANING THE TIMER

To clean the timer, wipe it lightly using a clean, dry towel. Do NOT sub­merse the timer in water. Do NOT wash it in a dishwasher. This will void
the warranty.

USA Headquarters:

China Facility:

P/N 1020263 Rev. H 12/12

Ph: [phone] Fx: [phone] Tf: [phone]

Ph: 86-512-6841-3637 Fx: 400-0-7878-22 Tf: 86-512-6841-3907