For FAQs and more information, please visit:
www.SeeNebula.com
support@SeeNebula.com
+1(800) 988 7973 (US) Mon-Fri 9:00-17:00 (PT)
© Anker Technology Co., Limited. All rights reserved. NEBULA and the NEBULA logo are trademarks of Anker Technology Co., Limited, registered in the United States and other countries.
Mode: D2321 |
51005000706 V01 |
Mars Lite
Owner’s Manual
Table of Content
01 Safety Instructions
04 What’s Included
04 Overview
09 Get Started
11 Settings
12 Enjoy
15 Specifications
16 Troubleshooting
17 Notice
18 Trademarks
18 Warranty
Safety Instructions
Read and understand all instructions before you use this device. Do not make any changes or settings that are not described in this manual. If physical injury, loss of data or damage is caused by failure to follow instructions, the warranty does not apply.
Setup
•To reduce the risk of fire and/or electric shock, do not expose the device to rain or moisture, and objects filled with liquids, such as vases, should not be placed on the device.
•Do not place this device on soft surfaces such as tablecloths or carpets. Otherwise the device could catch fire.
•Do not place this device in areas susceptible to excessive dust and dirt or near any appliance generating a strong magnetic field.
•To prevent overheating, do not block or clog the ventilation openings.
•Never place this device in a confined space. Always leave enough space around the device for ventilation.
•Protect the device against direct sunlight, heat, large temperature fluctuations and moisture.
•When the device is running for a long period of time, the surface becomes hot. Shut it down immediately and unplug the power cord. Only after the device has cooled down, you can continue to operate.
•Always handle the device with care. Avoid touching the lens.
•Never place heavy or sharp objects on the device or the power cord.
•To avoid electric shock, do not disassemble.
•Use attachments or accessories specified by the manufacturer only.
•Avoid extreme vibrations. It may damage the internal components.
•Do not allow children to handle the device without supervision.
•Under the following conditions, a layer of moisture can appear inside the device which can lead to malfunctions: a) if the device is moved from a cold to a warm area; b) after a cold room is heated; c) when the device is placed in a damp room. To avoid any moisture, seal the device in a plastic bag before moving it to another room, and wait for one to two hours before you take it out of the bag.
English
01
English
Power Supply
•Use only the provided power adapter.
•Power off the device before removing the power supply from the socket.
•Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from this device.
•Unplug this device during lightning storms or when unused for a long period of time.
•Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
•Before you make or change any connections, ensure that all devices are disconnected from the power outlet.
•Never touch the mains cable of the mains connection with wet hands.
Hearing Safety
•To avoid hearing damage, do not listen for extended periods at high volume. Set the volume at a safe level.
Battery
•Do not replace the built-in battery yourself. Contact an authorized service center to replace it.
•The remote control contains coin type batteries, which can be swallowed. Keep the batteries out of reach of children.
•Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
•When the remote control is not used for a long period of time, remove the batteries.
•Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
•Batteries contain chemical substances, they should be disposed of properly.
•Charge the device regularly. Do not store the device with a completely discharged battery.
Cleaning
•Power off the device and remove it from the power supply before cleaning the surface.
•Use a soft, lint-free cloth. Never use liquid, gaseous or easily flammable cleansers (sprays, abrasives, polishes, alcohol).
•Do not use any liquid cleaning agents for cleaning the lens, to avoid damaging the coating film on the lens.
•Wipe over the surfaces gently. Be careful that you do not scratch the surfaces.
•Use lens cleaning paper to clean the lens of the projector.
Repairs
•Do not make any repairs to the device yourself. Only have your device repaired by an authorized service center.
•Improper maintenance can result in injuries or damage to the device.
Class II equipment symbol
This symbol indicates that the unit has a double insulation system.
Laser Safety
CLASS 1
LASER PRODUCT
IEC 60825-1:2014. Complies with IEC 62471:2006 Risk Group 2.
Caution:
•Possibly hazardous optical radiation emitted from this device.
•Do not stare at operating beam. The bright light may hurt your eyes.
English
02 |
03 |
What’s Included |
2. Rear View |
English
1 |
2 |
3 |
4 |
|
8 |
5 |
Main unit |
Remote control with batteries |
6 |
|
||
|
|
7 |
English
|
|
NEBULA |
|
|
P1 Lite |
|
|
Owner’s Manual |
Power Adapter |
Power cord |
Manual |
Overview
1. Front View
1
2
3
4
04
1Lens
2Handle
3Lens cover
•Slide down to power on and automatically adjust focus
•Slide up to power off
4Loudspeaker
1DC IN
•Connect to power supply
2HDMI
•Connect to a playback device with HDMI output
3USB
•Connect to a USB storage device
•Charge a USB device as a power bank
4AUDIO OUT
•Connect to headphone or external speaker
5Infrared Receiver
6Air ventilation (outlet)
7Air ventilation (inlet)
8RESET
05
Loading...