American Standard T42043X, Diverter Trim User Manual
Installation
Instructions
PORTSMOUTH™
DIVERTER TRIM KIT
Thank you for selecting American-Standard...the
benchmark of fine quality for over 100 years.
T42043X
Series
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
ROUGHING-IN DIMENSIONS
ALL CONNECTIONS 1/2" NPT
66mm MAX.
(2-5/8")
71mm
(2-3/4")
41mm MIN.
(1-5/8")
57mm HOLE SIZE
(2-1/4")
FINISHED
WALL
51mm
(2")
FINISHED
WALL
HANDLE
LEVER
42mm
(1-11/16")
Certified to comply with ANSI A112.18.1
M965032 REV.1.3
CROSS
HANDLE
70mm
(2-5/8")
Recommended Tools
Flat Blade Screwdriver
CARE INSTRUCTIONS:
To keep your new faucet looking new, please follow
these simple care instructions:
DO: Simply rinse the faucet clean with clear water.
Dry the faucet with a soft cotton cloth.
DO NOT:
Do not use any abrasive cleaners, cloths, or
paper towels.
Do not use any cleaning agents containing
acids, polish abrasives, or harsh cleaners or
soaps.
Regular and routine cleaning will reduce the need for
heavy cleaning and polishing. If heavy cleaning is
required, the following procedures are recommended:
Phillips Screwdriver
Remove as much surface dirt and film using clear
water and soft cotton cloth
Use any of the following to remove tough surface
film and build-up:
Mild liquid detergents
Clear ammonia free liquid glass cleaners
Non-acidic, non-abrasive gentle liquid or fully
dissolved powder cleansers mixed according to
manufacturers directions.
Non-abrasive liquid polishers
Once clean, rinse faucet again with clear water to
thoroughly remove cleaner or polish and blot dry with
a soft cotton cloth.
(as described above).
Failure to follow these care instructions may
damage the Faucet's finish.
TRIM INSTALLATION
1
Place ESCUTCHEON (1) onto ESCUTCHEON HOLDER (2).
Align ESCUTCHEON (1). Thread ESCUTCHEON HOLDER (2) onto DIRVERTER VALVE (3).
Tighten until ESCUTCHEON (1) is snug against fiished wall.
3
2
1
HANDLE INSTALLATION
2
Install KNOB MOUNT (1) onto VALVE STEM (2).
Thread HANDLE SCREW (3) into VALVE STEM (2) and tighten.
Align HANDLE (4) and push onto KNOB MOUNT (1).
Tighten SET SCREW (5) in handle with
HEX WRENCH (6) SUPPLIED.
OPERATING THE VALVE
3
1
3
4
2
5
6
Turn water supply on and test installed fitting.
Rotate handle to all diverter positions to check operation of valve.
Check for leaks.
OFF
M965032 REV.1.3
Loading...