American DJ Reflections II User Instructions

Revised 7/01

Los Angeles Ca. 90058

www.americandj.com

4295 Charter Street

American DJ

User Instructions

attempt any repairs yourself, doing so will void your manufactures war-

ranty. In the unlikely event your unit may require service please contact

different type fuse from that which is recommended may cause fire or

electric shock and will void the manufactures warranty.

©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 2

of 2 amps is reached. If the fuse needs replacement, always replace

the fuse with same exact type that was remove, unless otherwise

instructed by an authorized American DJ

® service technician. Use of a

your nearest American DJ® dealer.

Safety Issues: This unit may blow a fuse if the maximum allotted load

not expose this unit to rain or moisture.

Caution! There are no user serviceable parts inside this unit. Do not

Warning! To prevent or reduce the risk of electrical shock or fi re, do

Voice: [phone]

Fax: [phone]

E-mail: [e-mail]

5:00 p.m. Pacifi c Standard Time.

demands of theatrical groups and those that desire an incredible effect

without strong fl ashing lights or fog.

Customer Support: American DJ® provides a toll free customer sup-

port line, to provide set up help and to answer any question should

you encounter problems during your set up or initial operation. You may

also visit us on the web at www.americandj.com for any comments or

suggestions. Service Hours are Monday through Friday 9:00 a.m. to

Introduction: The American DJ® Refl ections II

ulates rippling water and when used with a yellow or red gel this unit

can also simulate fi re. The Refl ections II™ was created to meet the

™

is an effect that sim-

can DJ

®. Every Refl ections II™ has been thoroughly tested and has

Reflections II™ Introduction

Unpacking: Thank you for purchasing the Refl ections II™ by Ameri-

been shipped in perfect operating condition. Carefully check the ship-

ping carton for damage that may have occurred during shipping. If the

carton appears to be damaged, carefully inspect your fi xture for any

damage and be sure all equipment necessary to operate the system

has arrived intact. In the event damage has been found or parts are

missing, please contact our toll free customer support number for fur-

ther instructions.

serviceable parts inside

• Never operate this unit when it’s cover is removed

• Never plug this unit in to a dimmer pack

• Do not attempt to operate this unit, if it becomes damaged

• This unit is intended for indoor use only, use of this product outdoors

voids all warranties

• During long periods of non-use, disconnect the unit’s main power

• Always mount this unit in safe and stable matter

• Power cords should be routed so they are not likely to be walked on,

pinched by items placed upon or against them.

• Cleaning -The fixture should be cleaned only as recommended by

the manufacturer. See page 5 for cleaning details.

• This unit should be situated away from heat sources such as radia-

tors, heat registers, stoves, or other appliances (including amplifiers)

that produce heat. Always be sure to mount this unit in an area

that will allow proper ventilation. Allow about 6” (15 cm) between this

device and a wall.

• The fixture should be serviced by qualified service personnel when:

A. The power-supply cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the appliance.

C. The appliance has been exposed to rain or water.

D. The appliance does not appear to operate normally or exhibits a

marked change in performance.

• Do not remove the cover under any conditions. There are no user

Reflections II™ Safety Precautions

• To reduce the risk of electrical shock or fi re, do not expose this unit

rain or moisture

• Do not spill water or other liquids into or on to your unit

• Be sure that the local power outlet match that of the required voltage

for your unit

• Do not attempt to operate this unit if the power cord has been frayed

or broken

• Do not attempt to remove or break off the ground prong from

the electrical cord. This prong is used to reduce the risk of electrical

shock and fi re in case of an internal short

• Disconnect from main power before making any type of connection

electrical outlet. After plugging this fixture in, the units “Reflections II™

shaped lenses will spin back and forth to an audio source. The unit

will react to the low frequencies of music via its internal microphone.

The audio sensitivity is preset there no need for any adjustments. If

after plugging the unit in there is no lamp output check the fuse and

lamp. If the fuse and lamp are good, please contact customer support

for further instructions. For best results, we suggest using with fog or

special effects smoke. This will enhance the effects by allowing you

to see the beams of light.

©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 4©American DJ Supply® - www.americandj.com - Refl ections II™ Instruction Manual Page 3

General Operation:

This fixture is designed to operate as a stand alone unit, it will react

to low frequencies of an audio source. The unit has been equipped

with a lamp and is ready to be hung or set on a flat surface, there is

no assembly necessary and no need of a controller of any type. The

unit is ready to be plugged in out of the box. Plug the unit’s power cord

in to a standard 110v~120v electrical outlet. There is no power switch,

the unit should automatically turn on after plugging the unit in to an

Power Supply: Before plugging your unit in, be sure the source

voltage in your area matches the required voltage for your American

DJ® Refl ections II™ before attempting operation.

• Low Power Consumption

Reflections II™ Set-Up/Operation

Reflections II™ Features

regarding the use and maintenance of this unit. Please keep this

manual with the unit, for future reference.

• Micro-Stepping Motors for Smooth Movement

• Full Focusing

• Fan Cooled

• Easy Lamp Replacement

• Long Life ZB-JCR H5 (15v/150w) Lamp - 500 Hours

• Light Weight Compact Design

To optimize the performance of this product, please read these operat-

ing instructions carefully to familiarize yourself with the basic operations

of this unit. These instructions contain important safety information

Reflections II™ General Instructions