Aladdin IHA-99SAE Parts List

MODEL IHA-99S / IHA-99SAE

®

HEAT ON DEMAND

2

HEAT ACTIVATOR

& BASE

INSTALLATION, OPERATION & SERVICE MANUAL

Manual P/N 93442
Rev. C 11/27/2006

HEAT ON DEMAND® U. S. Patent# 5,603,858 and 5,786,643 other U.S.
and Foreign Patents Pending

Please read this manual completely before attempting to operate, install or service
this equipment! Failure to follow these instructions and precautions could cause
death, injury or equipment damage!

After receiving, inspect all components immediately.
Notify carrier of damage! See page 6.

TECHNICAL BULLETIN

Condition: Overheated Bases

The Aladdin Heat on Demand Products are designed with a temperature measurement sensor
located under the base guide. This sensor should be cleaned weekly due to possible debris
accumulation during operation. If the sensor is not kept clean, the base may be damaged after the
initial heating cycle by either accidental or intensional re-entering a previously heated base.

Clean sensor weekly by wetting a Q-tip with water and lightly swab the sensor.

Solution: Clean Sensor

To Clean:

1) Wet a Q-tip with water (soaps or glass cleaner will damage the sensor)

2) Swab the middle of the temperature measurement sensor

To verify the sensor is clean:

1) Place a clean dry base into the guide to be heated.

2) After the heating cycle has ended, Remove the base

3) Count 3 seconds.

4) Place the same base back into the guide and the green ready lamp should glow within
4 seconds or less. If not, the temperature detection system is not functioning properly
contact the Aladdin Technical service department

.

Copyright © 1999 Aladdin Temp-Rite

Changes may be made to the information in this document without notification.

®

HEAT ON DEMAND

2

CONTENTS

ACTIVATOR

I. INTRODUCTION

II. SAFETY

III. SPECIFICATIONS

IV. REGULATORY COMPLIANCE AND
INDEPENDENT TESTING

V. RECEIVING INSPECTIONS

VI. INSTALLATION

VII. OPERATION

VIII. OPERATOR MAINTENANCE
SANITATION & CLEANING

IX. ELECTRICIAN'S MAINTENANCE
TROUBLESHOOTING GUIDE

4

4

5

5

6

7

9

11
11

12
13

X. PARTS ILLUSTRATIONS

XI. PARTS LIST

XII. ELECTRICAL SCHEMATIC

XIII. HEAT ON DEMAND BASE CARE & HANDLING

XIV. SERVICE

XV. EQUIPMENT WARRANTY

14

15

16

18

20

20

3

®

HEAT ON DEMAND

2

ACTIVATOR

I.

INTRODUCTION

The Aladdin Heat on Demand
with the Aladdin Heat on Demand

The Activator has been specifically created for use ONLY with Aladdin's Heat on Demand
exposed coil, open flame or heated surface. The only heat applied to the top surface of the base is that which
is absorbed from internal component base parts.

This Activator contains no operator serviceable parts. Please consult a qualified electrician or the Aladdin Service
Department should the equipment require service. Aladdin's toll free service line is 1-800-888-5426.

®

Activator is designed to provide a quick, clean and efficient heat source for use

2

®

base.

®

bases. There is no

! WARNING

This equipment is to be installed only by a qualified electrician. There are no
operator serviceable parts inside this Activator. Operators should never remove
the back panel or fuse access panel of this Activator.

II. SAFETY

If you know how to correctly install, operate, clean and service the Heat on Demand
with the system will be increased and safety will be enhanced. In accordance with generally accepted product
safety labeling guidelines, the following three signal words are used throughout this manual to alert you to
potential hazards and to tell you how to avoid them.

WARNING:

result in death or serious personal injury.

4

The word "Warning" identifies a potentially hazardous situation which, if not avoided, COULD

®

System, your satisfaction

2

CAUTION :

MAY result in minor or moderate injury. The word "Caution" may also be used to alert against unsafe practices

and property damage only accidents.

The word "Caution" identifies a potentially hazardous situation which, if not avoided,

III.

NOTE! T

important but not hazard related.

SPECIFICATIONS

A. MODEL NUMBER………………………………………IHA-99S
B. LENGTH…………………………………23¾ inches (60.3 cm.)
C. WIDTH…………………………………...16¾ inches (42.5 cm.)
D. HEIGHT…………………………………..13¼ inches (33.7 cm.)
E. VOLTAGE……………………………………………200-240VAC
F. FREQUENCY………………………………………….…50/60 HZ
G. PHASE……………………………………………………………..1
H. AMPS…………………………………………………………….14
I. NEMA PLUG………………………………………………..L6-20P
J. SHIPPING WEIGHT………………………..53 POUNDS (32.2kg)
K. NUMBER OF WIRES………………………………………………3
L. PLUG TYPE……HUBBELL

he word "Note" is used to identify installation, operation, or maintenance information which is

®

preferred or equivalent TWIST LOCK

IV.

Underwriters Laboratories--File Number E67324

National Sanitation Foundation--Standard Number 4

This equipment has been verified to comply with the following:

Code of Federal Regulations, Title 29, Section 1910.97. Occupational Safety and Health Administration

REGULATORY COMPLIANCE & INDEPENDENT TESTING

This equipment has been listed by the following organizations:

Code of Federal Regulations, Title 47, Section 18, Federal Communications Commission

5

®

HEAT ON DEMAND

2

! WARNING

This equipment generates, uses and can emit radio frequency energy and, if
not installed and used in accordance with these instructions, may cause harmful
interference to radio communications devices. Changes or modifications to this
equipment not expressly approved by the party responsible for compliance could
void the user's authority to operate this equipment.

There is no guarantee, however, that interference will not occur in a particular
installation. If this equipment is found to cause harmful interference to radio
communications, the user is encouraged to correct the interference by one or
more of the following means:

A. Reorient or relocate the receiving antenna.
B. Increase the separation between the equipment
and the receiver.
C. Connect the equipment into an outlet or on a circuit
different from that which the receiver is installed.
D. Consult your sales representative, Aladdin Service
Department or an experienced radio/TV technician.

ACTIVATOR

NOTE! Each user is responsible for adherence to existing local codes regarding

the posting of warning notices.

V.

is not damaged.

Carefully check for any visible signs of damage to the carton. If evidence of damage exists, the carton should
be opened immediately and a joint inventory and examination of the contents should be made by you and
the delivery driver.

6

RECEIVING & INSPECTING THE EQUIPMENT

Even though this equipment is carefully packaged, care should be taken during unloading so the equipment