OPERATING INSTRUCTIONS INSTRUCCIONES DE MANEJO MODE D’EMPLOI
CSD-FD92
CSD-FD82
COMPACT DISC STEREO RADIO CASSETTE RECORDER
RADIOCASETE ESTÉREO CON REPRODUCTOR DE DISCOS COMPACTOS
RADIO-CASSETTE LECTEUR DE CD STEREO
English : See page 2. |
En |
|
|
|
|
Español : Ver la página 12. |
E |
|
|
|
|
Français : Voir page 22. |
F |
|
|
8B-CHE-903-01
001225ACK-I-M
U
WARNING
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION |
RISK OF ELECTRIC SHOCK |
DO NOT OPEN |
“CAUTION:TO REDUCE THE RISK OF |
ELECTRIC SHOCK, |
DO NOT REMOVE COVER (OR BACK). |
NO USER-SERVICEABLE PARTS INSIDE. |
REFER SERVICING TO QUALIFIED |
SERVICE PERSONNEL.” |
Explanation of Graphical Symbols:
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
OWNER’S RECORD
For your convenience, record the model number (you will find it at the bottom of the unit) and serial number (you will find it in the battery compartment) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty.
Model No.
Serial No.
2 ENGLISH
Precautions
Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.
Installation
1Water and moisture - Do not use this unit near water, such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, swimming pool, or the like.
2Heat - Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat.
It also should not be placed in temperatures less than 5°C (41°F) or greater than 35°C (95°F).
3Mounting surface - Place the unit on a flat, even surface.
4Ventilation - The unit should be situated with adequate space around it so that proper heat ventilation is assured.
Allow 10 cm (4 in.) clearance from the rear and the top of the unit and 5 cm (2 in.) from each side.
-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.
-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.
5Objects and liquid entry - Take care that objects or liquids do not get inside the unit through the ventilation openings.
6Carts and stands - When placed or mounted on a stand or cart, the unit
should be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the unit or cart to overturn or fall.
7Condensation - Moisture may form on the CD pickup lens when:
-The unit is moved from a cold spot to a warm spot
-The heating system has just been turned on
-The unit is used in a very humid room
-The unit is cooled by an air conditioner
When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.
8Wall or ceiling mounting - The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.
Electric Power
1Power sources - Use on batteries or AC house current, as specified in the Operating Instructions and marked on the unit.
2Polarization - As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace
the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.
3AC power cord
-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.
-Never handle the AC power plug with wet hands, as this could result in fire or shock.
-Power cords should be firmly secured to avoid being bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.
-Avoid overloading AC outlets and extension cords beyond their capacity, as this could result in fire or shock.
4Extension cord - To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug.
5When not in use - Unplug the AC power cord from the AC outlet or remove all the batteries if the unit will not be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off.
Maintenance
Clean the unit only as recommended in the Operating Instructions.
Damage Requiring Service
Have the units serviced by a qualified service technician if:
-The AC power cord or plug has been damaged
-Foreign objects or liquid have got inside the unit
-The unit has been exposed to rain or water
-The unit does not seem to operate normally
-The unit exhibits a marked change in performance
-The unit has been dropped, or the cabinet has been damaged
DO NOT ATTEMPT TO SERVICE THE UNIT YOURSELF.
Specifications
Tuner section
Frequency range, antenna — FM: 87.5 - 108.0 MHz Rod antenna, AM: 530/531 - 1,710/1,602 kHz (10/9 kHz step) Ferrite bar antenna
Deck section
Track format — 4 tracks, 2 channels / Frequency range
— Normal tape: 50 - 12,500 Hz (EIAJ) / Recording system — AC bias / Erasing system — AC erase / Heads — Recording/playback head (1), Erasure head
(1)
CD player section
Disc — Compact disc / Scanning method — Noncontact optical scanner (semiconductor laser)
General
Speaker — 100 mm cone type (2), 36 mm cone type (2) / Output — Headphones jack (stereo mini-jack) / Power output — 2.5 W + 2.5 W (EIAJ, 7 ohms DC) / Power requirements — DC 12 V using eight size C (R14) batteries, AC 120 V, 60 Hz / Power consumption — 15 W / Dimensions (W × H × D) — 460 × 192 × 262 mm (18 1/8 × 7 5/8 × 10 3/8 in.) / Weight (excluding batteries)
— 4.0 kg (8 lbs. 13 oz.) / Accessories — Remote control (1), AC cord (1)
Specifications and external appearance are subject to change without notice.
En
COPYRIGHT
Please check the copyright laws relating to recordings from disc, radio or external tape for the country in which the machine is being used.
If an erroneous display or malfunction occurs
Turn off the unit and press POWER STANDBY/ON6 while pressing s.
If the unit cannot be reset in the way above, disconnect the AC cord and remove all the batteries to turn off the display.
Leave the unit for a while and turn the power back on.
ENGLISH 3
Power supply
OPE/BATT
The OPE/BATT indicator lights up while the power is on.
Using on AC house current
Connect the AC cord as illustrated below.
1 to the AC inlet of
the unit |
|
supplied AC cord |
2 to an AC outlet |
(AC 120 V, 60 Hz) |
•The rated voltage of the unit is 120 V AC.
•If abnormal high voltage is supplied, “Hi” flashes in the display and the unit does not accept any operation. Disconnect the AC cord.
CAUTION
Use only the supplied AC cord. Use with other cords may result in the risk of fire.
Demo display
When connecting the unit to an AC outlet for the first time, the demo display will begin automatically. The illuminations on the front panel also flash (CSD-FD92 only).
To turn off the demo, press * DISPLAY/COLOR/DEMO. You can turn it on or off by pressing DISPLAY/COLOR/ DEMO while the power is off.
* or DISPLAY on the remote control
•When using the unit on the batteries, the demo is not displayed.
•For ordinary use, turn off the demo to save power consumption.
Using on batteries
Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, as illustrated below. Then close the lid.
To switch from AC power supply to battery supply, disconnect the AC cord from the AC inlet.
R14 (C)
When the OPE/BATT indicator becomes dim, volume decreases, or sound is distorted during operation, replace the batteries.
When the batteries become weak during tape operation, “Lo” flashes in the display and the unit will be stopped or turned off. Replace the batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe the following:
•Insert the batteries with the 0and 9marks correctly aligned.
•Do not mix different types of batteries or old batteries with new ones.
•When the unit is not to be used for a long period, remove the batteries.
•Never recharge the batteries, apply heat to them or take them apart.
•Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
Changing the display color
You can select the color of the display light: orange, blue, purple (or turned off).
Press * DISPLAY/COLOR/DEMO repeatedly while the power is on.
* or DISPLAY on the remote control
•When using the unit on the batteries, the display light is off.
Illuminations on the front panel (CSD-FD92 only)
The illuminations light up or flash while the power is on. In playback mode, they will show the approximate sound level.
To turn off the illuminations, hold down * DISPLAY/ COLOR/DEMO while the power is on. To resume, hold it down again.
* or DISPLAY on the remote control
•When using the unit on the batteries, the illuminations are off.
4 ENGLISH