AEG-Electrolux F55090IW, F55090IA User Manual

FAVORIT 55090i
User manual Dishwasher
2
1
Dear Customer
Thank you for choosing one of our highquality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best per formance and control  indeed we are setting the highest standards of excel lence. In addition to this you find environmental and energy saving aspects as an inte gral part of our products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfect ly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. And please pass it to any future owner of the appliance. We wish you much joy with your new appliance.
The following symbols are used in this user manual: Important information concerning your personal safety and information on
3 General information and tips
how to avoid damaging the appliance.
2 Environmental information
Contents
Operating Instructions 4
Safety 4
Diagram of appliance 5
Control panel 6
Prior to using for the first time 8
Setting the water softener 8 Adding special salt 10 Filling up with rinse aid 11
In daily use 14
Loading cutlery and dishes 14 Adjusting the height of the upper basket 17 Adding detergent 18 Using 3in1 detergents 19 Selecting the dishwashing cycle (Cycle Table) 21 Starting a dishwashing cycle 23 Setting the Delay Timer 24 Switching off the dishwasher 24
Care and cleaning 25
3Contents
What to do if… 27
Remedying small malfunctions 27 If the dishwashing results are not satisfactory 29
Disposal 30
Technical data 30
Notes for Test Institutes 31
Installation and connection instructions 32
Safety information for the installation 32
Installing the dishwasher 33
Connecting the dishwasher 34
Guarantee/Customer Service 36
Service 43
Operating Instructions4
Operating Instructions
1 Safety
Prior to using for the first time
Follow the ”Instructions for installation and connection”.
Correct use
The dishwasher is only intended for washing domestic dishes.
Additions or modifications to the dishwasher are not permitted.
Use only special salt, detergent and rinse aid suitable for domestic dishwash
ers.
Do not put any solvents in the dishwasher. This could cause an explosion.
Child safety
Keep packaging away from children. There is a risk of suffocation.
Children often do not recognise the hazards associated with electrical appli
ances. Don’t allow children to use the dishwasher unsupervised.
Make sure that children and pets don’t climb into the dishwasher. Could en danger life!
Dishwasher detergents can cause chemical burns to the eyes, mouth and throat. Could endanger life! Comply with the safety instructions of the dish washer detergent manufacturer.
The water in the dishwasher is not for drinking. Risk of chemical burns.
General safety
Repairs to the dishwasher are only to be carried out by qualified service engi neers.
When the dishwasher is not being used, switch it off and shut off the water tap.
Never unplug the appliance by pulling on the cable. Always pull the plug.
Ensure that the door of the dishwasher is always closed when it is not being
loaded or unloaded. In this way you will avoid anybody tripping over the open door and hurting themselves.
Never sit or stand on the open door.
If the dishwasher is located in a room where there may be a frost, remove the
connection hose from the tap after each use of the dishwasher.
Diagram of appliance
Upper basket spray arm and floor spray arm
Water hardness dial
Dispenser for special salt
Dispenser for detergent
Dispenser for rinse aid
5Diagram of appliance
Rating plate
Filters
Control panel6
 s
Control panel
ON/OFF button
The ON/OFF button is used to turn the dishwasher on and off.
Programme buttons
Multidisplay
123
Function buttons
Set delay timer
End of cycle indicator
Control indi
cator
The Programme buttons are used to select the desired dishwashing cycle.
7Control panel
Function buttons: In addition to the preset dishwashing cycle, the following functions can also be set using these buttons:
Function button 1 Sets the water softener
Function button 2 Activates/deactivates rinse aid inflow when 3in1 on
Function button 3  not programmed 
Buttons 3in1 Activates/deactivates the 3in1 function
The rinse aid inflow is only affected, if the 3in1 function is selected. The multidisplay can indicate:
the start time that has been set.3 horizontal bars: the setting mode has been activated with function buttons1 horizontal bar: dishwashing cycle is runningMultidisplay is off: dishwashing cycle is completed
The control indicators have the following meanings:
1)
1)
Refill with special salt
Refill with rinse aid
3 IN 1 3 in 1 function activated
1) These control indicators are never illuminated while a dishwashing cycle is running.
Prior to using for the first time8
Prior to using for the first time
3
If you wish to use 3 in 1 detergent: – First read the section “Using 3in1 detergents”. – Do not fill up with special salt or rinse aid.
If you do not use 3in1 detergent, before using for the first time
1. Set the water softener
2. Fill up with special salt for water softeners
3. Fill up with rinse aid
Setting the water softener
The water softener must be set manually and electronically:
3 To avoid scale deposits on the dishes and in the dishwasher, the dishes must be
washed with soft water, i.e. water with a low lime content. The water softener must be set according to the table to the water hardness in the area where you live. Your local water company will be able to give you information about the water hardness in your area.
The dishwasher must be switched off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn water hardness dial on the left wall of the dishwasher interior to 1 or 2 (see table).
Setting electronically:
1. Press the ON/OFF button.
3 If the only LED indicator illuminated is one
that belongs to a programme button, this means that this dishwashing cycle has been activated. The dishwashing cycle must be deselected: Press function buttons 2 and 3 simultaneously for approx. 2 seconds. The LED indicators of all the programme buttons that can be selected light up.
2. Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 1. The LED indicator for function button 1 will flash. The LED indicator for the end of the dishwashing cycle will flash simultaneously:
– The number of times that the LED indicator for the end of the dishwashing cy
cle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second pause in
between.
4. Pressing function button 1 increases the hardness setting by 1 degree. (Exception: hardness setting 1 follows hardness setting 10).
5. When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.
If the water softener is set electronically to “1”, this switches off the control in dicator for special salt.
9Prior to using for the first time
Water hardness Adjusting the hardness setting
1)
in °d
51  70 43  50 37  42 29  36 23  28
19  22 15  18
11  1 4 1,9  2,5 II 3 3
4  10 0,7  1,8 I/II 2 2
below 4 below 0.7 I
1) (°d) German degree, measure of the hardness of water
2) [mmol/l] millimol per litre, international unit for water hardness
3) On this setting the length of the dishwashing cycle may be slightly longer. *) factory setting
in mmol/l
9,0  12,5
7,6  8,9 6,5  7,5 5,1  6,4 4,0  5,0
3,3  3,9 2,6  3,2
2)
Range Manual Electronic
IV
III
2*
1
3)
10
9 8 7 6
5*
4
1
no salt
necessary
Number of
flashes
10
9 8 7 6
5 4
1
Prior to using for the first time10
Adding special salt
To decalcify the water softener, it must be filled up with special salt. Use only special salt suitable for domestic dishwashers.
If you do not use 3 in1 detergent, fill up with special salt:
Before using the dishwasher for the first time.When the control indicator for special salt is illuminated on the control panel.
1. Open the door and remove the lower basket.
2. Screw open the lid on the salt dispenser by turning it anticlockwise.
3. Only when using the dishwasher for the first time:
Fill the salt dispenser with water.
4. Place the funnel (supplied) over the dis penser opening. Fill the dispenser with special salt; the ca pacity of the dispenser is approx. 1.01.5 kg, depending on the size of the grains. Do not overfill the dispenser.
3 If water overflows when filling up with special salt, this is completely harmless.
5. Clean away any salt remnants from the dispenser opening.
6. Screw the lid back on in a clockwise direction.
7. Run a dishwashing cycle after filling the salt dispenser with special salt.
This will wash away salt water and salt crystals that have been spilt.
3 Depending on the size of the salt grains, it can take several hours for the salt to
dissolve in the water and for the control indicator for special salt to go out.
Filling up with rinse aid
With rinse aid the rinsing water drains away better and so you get smearfree, gleaming dishes and clear glasses.
If you do not use 3in1 detergent, fill up with rinse aid:
Before using the dishwasher for the first time.When the control indicator for rinse aid is illuminated on the control panel.
Use only special rinse aid for dishwashers and no other liquid detergents.
1. Open the door. The rinse aid compartment is located on the inside of the dishwasher door.
2. Press the release button on the rinse aid compartment.
3. Open the cover.
4. Pour rinse aid in slowly right up to the bro
ken “max” line; this corresponds to a volume of approx. 140 ml when full.
5. Press the lid shut until it clicks into place.
6. Wipe up any spilt rinse aid with a cloth.
Otherwise there will be too much foam when rinsing.
11Prior to using for the first time
Prior to using for the first time12
Setting the amount of rinse aid required
3 Only change the amount dispensed, if smears, milky spots (reduce the amount)
or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfactory”.) The dosage can be set from 16. The dosage is preset to “4” in the factory.
1. Open the dishwasher door.
2. Press the release button on the rinse aid
compartment.
3. Open the cover.
4. Set the dosage level.
5. Press the lid shut until it clicks into place.
6. If rinse aid has leaked out, wipe it away
with a cloth.
13Prior to using for the first time
Activating rinse aid inflow when 3in1 function is selected
3 If the 3in1 function is not selected, the rinse aid inflow is always activated.
If the 3in1 function is selected due to the use of 3in1 detergent, the rinse aid in flow is deactivated. If the dishes then do not dry sufficiently, you should reacti vate the rinse aid inflow (see also section “Using 3in1 detergents”).
1. Press the ON/OFF button.
3 If the only LED indicator illuminated is one that belongs to a programme button,
this means that this dishwashing cycle has been activated. The dishwashing cy cle must be deselected: Press function buttons 2 and 3 simultaneously for approx. 2 seconds. The LED indicators of all the programme buttons that can be selected light up.
2. Press function buttons 2 and 3 simultaneously and keep them pressed. The LED indicators for function buttons 1 to 3 will flash.
3. Press function button 2. The LED indicator for function button 2 will flash. The indicator for the end of the dishwashing cycle will display the current set ting:
Indicator for the end of the cycle is lit: Rinse aid inflow activated when 3in1 on
Indicator for the end of the cycle is not lit:
Rinse aid inflow deactivated when 3in1 on (factory setting)
4. Pressing function button 2 activates and deactivates the rinse aid dispensing function.
5. When the rinse aid inflow setting is correct, press the ON/OFF button. The setting for the rinse aid inflow is now saved.
In daily use14
In daily use
Loading cutlery and dishes
1 Sponges, cleaning cloths and any other objects that can absorb water must not
be washed in the dishwasher. Plastic and Tefloncoated dishes and pans tend to retain water droplets. These dishes and pans therefore do not dry as well as those made of china and stainless steel.
For washing in the dishwasher, the following cutlery/dishes/pots and pans
are not suitable: are of limited suitability:
Cutlery with wooden, horn, china or mother of pearl handles
Plastic items that are not heat re sistant
Older cutlery with cement that is sensitive to temperature
Dishes or cutlery with glued parts
Pewter or copper items
Lead crystal glass
Steel items that rust
Wooden boards/platters
Items made from synthetic materials
Before loading the dishes, you should:Remove the worst of the food residues.
Soak pans with burnton food residues.
When loading the dishes and cutlery, please note:Dishes and cutlery must not impede the rotation of the spray arms.
Load bowls, cups, glasses, pans, etc. with the opening downwards so that
water cannot collect in them
– Dishes and items of cutlery must not lie inside one another or cover one an
other
To avoid damage to glasses, they must not touch one anotherDon’t put small items (e.g. lids) in the baskets for the dishes, but in the cut
lery basket, so that they can’t fall through the holes.
Only wash stoneware in the dishwasher if it is spe cifically marked by the manufacturer as being dish washersafe.
Glazed patterns may fade if washed very frequently in the dishwasher.
Silver and aluminium parts have a tendency to dis colour during washing. Food remains, e.g. egg white, egg yolk and mustard often cause discoloration and staining on silver. Therefore always clean food resi dues from silver immediately, if it is not to be washed straight after use.
Glass can become dull after a large number of wash es.
Loading...
+ 30 hidden pages