ADTRAN Total Access 544R Quick Start Guide

For more detailed documentation, visit us online at www.adtran.com

Quick Start Guide

Reviewing the Front Panel

TOTAL ACCESS 544R P/N 4200704L8, L9, L10, L11

LAN LEDs

Connecting to the Total Access 544R

Connecting a VT100 terminal (or VT100 terminal emulator) to the C interface (on the back panel of the unit) allows access to the terminal menus and management features of the Total Access 544R.

Perform Steps Below in the Order Listed:

1. Configure a VT100 terminal (or terminal emulation software) with the following settings:

RAFT

WAN LEDs

LAN WAN

Power LED

Front Panel LEDs

The front panel provides five status LEDs to monitor operation and activity. The following table provides LED activity explanations.

LED COLOR DESCRIPTION

Off There is no data trafic on the LAN

LAN TX/RX

Green (blinking) There is data trafic on the LAN

Data Rate: 9600 baud Stop Bits: 1

Data Bits: 8 Flow Control: None

Parity Bits: None

If the terminal has a parallel setting, disable it and use serial.

2. Connect one end of the 6” data cable (supplied) into the Total Access 544R C

port. (This connection is RJ-45.) Make the connection to

RAFT

the VT100 terminal as appropriate for your connection. ADTRAN supplies an RJ-45 to DB-9 adapter for connections to standard DB-9 Communications (COM) ports.

3. Initiate a terminal session and the L

screen displays. Press Enter

OGIN

LAN LINK

WAN STAT

WAN ERR Off Not applicable

PWR

Off The physical link is down; there is no Ethernet connection

Green (solid) There is link integrity on the LAN (physical link is up)

Red (solid) SHDSL is down

Green (solid) SHDSL is up

Green (solid) Power is supplied to the unit

Off Power is not supplied to the unit

to enter the menu. There is not a manufacturer’s password by default. (Passwords in the Total Access 544R are case sensitive.)

For more detailed documentation, visit us online at www.adtran.com

Reviewi

Quick Start Guide

TOTAL ACCESS 544R P/N 4200704L8, L9, L10, L11

ng the Rear Panel Design

Network Pinout

PIN NAME DESCRIPTION

—

RXDATA-RING Receive data from the network

RXDATA-TIP Receive data from the network

UNUSED —

TXDATA-RING Transmite data from the network

TXDATA-TIP Transmite data from the network

UNUSED —

Network

Interface

Craft

Interface

10/100BaseT

Ethernet

10/100BaseT Ethernet Pinout

PIN NAME DESCRIPTION

1 TX1 Transmit Positive 2 TX2 Transmit Negative 3 RX1 Receive Positive 4,5, 7, 8 — Unused 6 RX2 Receive Negative

AC Power Connection

Craft Pinout

PIN NAME DESCRIPTION

1 GND Ground - connected to unit chassis 2 RTS Request to send - flow control 3 RXDATA Data received by the Total Access 544R 4 DTR Data terminal ready 5 TXDATA Data transmitted by the Total Access 544R 6 CD Carrier detect 7 UNUSED — 8 CTS Clear to send - flow control

Equipment Dimensions

The Total Access 544R measures 11.25” W, 7.5” D, and 2” H and comes equipped for table top or wall mount use.

Power Requirements

The Total Access 544R has a maximum power consumption of 100-250VAC 50/60Hz and a maximum current draw of 300 mA.

For direct contact call:

1-800-726-8663 1-256-963-8716